工业设计

In this paper, the design of configuration software for the speed chain of production line in papermaking industrial is proposed, some key points about the configuration software in papermaking industrial is introduced, the selection and design of the hardware of the control system is also det

本论文针对造纸工业生产线速度链控制的特殊工艺，提出了造纸工业组态软件的设计方案，并介绍了造纸工业组态软件的一些关键环节，对控制系统的硬件进行了选择和设计。

The results show that the main design parameters of the coal cutter are rational and reach the requirements of the design, and its technical performance occupies the leading place among the same kind of domestic products.

为确定MG300/690W采煤机能否取代MG2×300W采煤机，进行了有关工业生产试验和整机结构性能分析，结果表明该采煤机的主要参数设计合理性达到设计要求，技术性能居于国内同类产品的先进地位。

It has been active in mainland China since 1979, completing more than 100 projects covering a wide range of industries, including infrastructure, energy, industrial, and commercial design, engineering and construction.

它在1979年就进入中国市场，已完成了100多个不同种类的工业项目，包括基础设施，能源，商业设计，工程设计和施工。

The optimized design results of critic structure parameters of ejector drainage equipment are gained with theory research and numerical simulation in this paper, the method of designing is established and the high efficient structure is raised. The design method of ejector is proved reliable by in-situ tests and the ejector runs with high efficiency.

针对国内外喷射技术的研究现状，采用理论研究、数值模拟及工业试验，建立了高效喷射装置结构设计方法；现场试验表明：喷射装置设计方法可靠，装置运行高效，低压气井压力（最低1.1MPa）低于集输压力（5.2MPa）仍能够正常。

At present, hot-blast stove designers have been used to refer to remaining heat exchanger when they designed heat exchanger of hot-blast stove, and have taken examples in accordance with experience of remaining heat exchanger.

目前热风炉换热器的设计多借鉴工业炉用预热助燃空气的高温换热器，选型多按余热利用换热装置在设计及应用中形成的经验选型。

In this study a 50 kilotons industrial-scale ALR has been designed based on the safety criteria of high-pressure tank regulations in the handbook of the American Society of Mechanical Engineers.

本研究依据美国国家标准American Society of Mechanical Engineers规范设计，符合压力容器安全规范的50吨工业量产级气举式生物反应器的机械设计。

It has been focused by mechanists all the tune. With the development of computer technology, the demand of precise product get more tough, and then, many fuzzy matters occur.

随着国民经济的发展和工业技术的提高，对高精尖产品的要求呼声也越来越高，从而使定量研究从狭义设计到广义设计必然要遇到大量的模糊概念。

He has been involved in RFID tag design and development for niche industrial applications, application software concepts, functional and UI design and specifications for ruggedized handhelds and databases.

除此，Ian也参与RFID的标签设计及特殊工业的应用研发，软件概念的应用，以及适用于耐损型的RFID手提式读卡器的功能、用户界面和其数据库的规格设计。

The standard McLaren SLR (with 626 hp and 780 Nm of torque) has been restyled, resculpted here by the use of ultra-light carbon fiber materials which FAB-Design claims is as advanced as anything in use in Formula One or the aerospace industry today.

标准迈凯轮单镜反光（与626马力和780 Nm的扭矩）已经重新设计， resculpted这里使用超轻碳纤维材料的原子轰击设计索赔是先进的东西在使用的F1或航空工业今天。

The design methods and key design points of the fire automatic alarm system for construction of metallurgic industry were expounded from selection of system mode,matching of fire detector and alarm control,division of alarm zone and detection zone,function of fire fighting equipment and linkage control requirement,and system wiring.

从系统形式的选择，火灾探测器和报警控制器的选配，报警区域和探测区域的划分，消防控制设备的功能和联动控制要求，以及系统布线等方面系统阐述了冶金工业建筑中火灾自动报警系统的设计方法和设计要点。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。