屈氏体

The result indicated that the microstructure of the steel consisted of tempering troostite and tempering sorbite.

结果表明，钢的组织主要由回火屈氏体与回火索氏体组成。

The technology not only guarantees that there are good microstructures of the tempered troostite and sorbite in the wire rod steel, but also makes environmental pollu.

该工艺在保证盘条钢具有良好的回火屈氏体和索氏体组织外，还减少了对环境的污染和对人体的危害。

With the increased of tempering temperature, the content of tempering troostite decreased, meanwhile tempering sorbite and particles precipitation increased.

且随回火温度的升高，回火屈氏体含量降低，回火索氏体含量增加，第二相粒子析出增加。

The quench zone consisted of martensite ,retained sorbite, temper troosite and so on.

激光作用区主要是低碳板条马氏体与未转变的索氏体甚至屈氏体、回火索氏体组织和屈氏体。

The fragment fell from the roll is the hardening layer, and the micrograph of its surface, its middle area and its bottom are martensite, sorbite, and troostite respectively.

剥离块为辊身的硬化层，硬化层外表为马氏体，中部为索氏体，硬化层的底部组织为屈氏体。

The results show that the fractography is woody structure, there is a great deal ferric oxide in the hair seam, its matrix is composed by the ferrite, the pearlite and a little of sorbite and troostite, the grain size is 9～10 levels primarily, there are obvious zone structure and inclusions, which are silicate, sulfide and a little of oxide.

结果表明：弯裂带钢的断口呈木纹状，发纹处存在大量氧化铁，其基体主要由铁素体和珠光体组成，有少量索氏体及屈氏体，晶粒度以9～10级为主，有较为明显的带状组织，夹杂物为硅酸盐、硫化物及少量氧化物。

The results showed that the main reason of rupture is troostite structure existing in rod.

通过金相、性能和热处理试验，对盘条拉丝断裂原因进行了分析，认为盘条存在屈氏体组织是断裂的根本原因。

The steel selected for this investigation is spring steel 50CrVA for automobile in this paper,the appropriate duplex microstructure of lower bainite and martensite was obtained through isothermal quenching and low temperature tempeing heating treatment,then the effect of duplex microstructure and tempered troostite on strength-toughness of spring steel 50CrVA is compared.

以汽车用弹簧钢50CrVA为研究对象，通过等温淬火+低温回火热处理工艺获得适当比例的回火马氏体和下贝氏体的复合组织，并在此基础上比较复相组织和回火屈氏体对弹簧钢50CrVA 强韧性的影响。试验结果表明：在弹簧要求的HRC硬度在50~54范围内，在910℃保温30 min+360℃等温20 min淬火+300℃保温60 m in回火工艺得到复相组织的强韧性最好

The experiments showed that, the surface microstructure is plate martensite, and the subsurface microstructure is cryptocrystalline martensite. the transition zone contains mixed martensite, troostite and part of the nonmelting ferrite.

实验表明：改性层微观组织由表层至基体依次为：表面熔凝区为片状马氏体；均匀相变硬化区为隐晶马氏体；过渡区为混合马氏体、屈氏体和部分未熔的铁素体。

The experiments show that the remelting hardening layer consists of melting zone, quenching zone and heat affected zone. From surface to internal, the respective microstructures are extremely small hidden-crystal martensite and a few residual austenites, hidden-crystal martensite and carbides and residual austerite, martensite and backfire troostite and ferrite.

实验表明：熔凝硬化层由熔化区、相变硬化区和热影响区组成；由表及里组织分别为极细隐晶马氏体＋少量残余奥氏体、隐晶马氏体＋碳化物＋残余奥氏体、马氏体+回火屈氏体+铁素体。

For a big chunk of credit-card losses; the number of filings (and thus charge-off rates) would be rising again, whether

年美国个人破产法的一个改动使得破产登记急速下降，而后引起了信用卡大规模的亏损。

Eph. 4:23 And that you be renewed in the spirit of your mind

弗四23 而在你们心思的灵里得以更新