屈服的

Use of analytical solution for predicting the ground settlement induced by tunneling in free soil and Plasticity Yield Criterion get the calculation process of analytical solution for predicting the plastic zone induced by tunneling in free soil.

利用预测自由地层中隧道开挖引起土体沉降的解析解，引入理想塑性屈服准则，得到了自由地层中隧道开挖产生塑性区范围的解析解的计算过程。

We're not asking you to genuflect to us — in fact, most of us would love nothing more than to deal with you as an equal and welcome you into our culture, if you put in the effort required to make that possible.

我们并没有要求你向我们屈服--事实上，我们中的大多数人最喜欢公平交易不过了，只要你付出小小努力来满足最起码的要求，我们就会欢迎你加入到我们的文化中来。

In Chapter 1, introduce the basis and meaning of the thesis selected title, summarize the method of research the stability of gravity dam at home and abroad, and list the main content of this paper.

第二章简要介绍了有限元法的基本原理，混凝土材料的屈服准测及本构关系，为后面的研究提供了理论基础。

I am teaching you not to hanker for comfort and convenience, because if you hanker for comfort and convenience, the society will give them to you, but at a cost.

我教你去成为你自己，我教你去成为毫无畏惧的；我教你不要屈服于社会的影响；我教你不要成为循规蹈矩的。

The results show t hat yttrium exists as the form of compound (Al2Y) in AZ31 magnesium alloy, and dystectic Al2Y as the heteromorphic nucleation emerges firstly in the cou rse of alloy precipitation, which refines the alloy's microstructure and obviou sly improves the mechanical properties at room and high temperature. The average grain size of AZ31 magnesium alloy containing Y is reduced by 35.82%. Tensile s trength, yield strength and elongation percentage reach 212 MPa, 147 MPa, and 7. 5% at room temperature respectively, and 117 MPa, 98 MPa, and 10.2% at 200 ℃ re spectively.

结果表明，Y在AZ31 镁合金中主要以块状Al2Y化合物形式存在；高熔点的Al2Y在合金凝固过程中首先析出，成为凝固的异质形核剂，从而细化了合金组织，改善了室温和高温力学性能；由于Y的强化，含Y AZ31镁合金平均晶粒尺寸降低幅度约为35.82 %；室温抗拉强度、屈服强度和延伸率分别为 212 MPa， 147 MPa和7.5%，200 ℃时分别为117 MPa， 98 MPa和10.2%。

The relation between the performance of hot rolled plate and the nitrogen content in the steel are discussed.

讨论了热轧板性能与钢中氮的关系；指出了钢中氮质量分数的减少可降低热轧板屈服强度，且满足供冷轧基料的要求。

Irritatingly enough, it was usually when I was alone, not that I wanted to share it with anyone. I wouldn't want them to think I was buckling under the pressure.

让人气愤地是，我见着这些鬼魂的时候通常都是单独一个人的时候，我倒也不想告诉任何人这些事，我不想让他们觉得我是屈服于他们的压力了。

Four-node degenerated shell element and rigid shell element are used in our FEM model.Updated Lagrange formulation and rate form constitutive equation are adopted to solve the problem of large strain and large rotation in sheet forming process.Sheet metal material property is described by plastic anisotropy yielding model and isotropic hardening model.Master surface-slave surface contact model is used to define the contact between tools and blank.Contact constraints are enforced with a kinematic algorithm and friction stress is computed by Coulomb friction law.Dynamic relaxation method is used to treat springback after forming stroke.

四结点蜕化壳单元和刚体壳单元分别用来建立板和模具的有限元模型；更新Lagrange法和速率型本构关系被用来处理板料变形中的大应变和大转动；材料模型采用塑性各向异性屈服与等向强化模型；通过主从面模型定义板料和模具的接触，接触算法采用运动约束法，摩擦力用库仓定律计算；并利用动力松弛法对回弹过程进行了计算。

A strength model of end-plate was presented by modifying the strength model of the T-stub which was set up by Kulak in 1987 and by presenting two hypotheses about the stress distribution on the beam section located at the connection of beam and end-plate.

对传统T形件连接强度模型作了修正，建立了端板连接节点的端板强度模型。提出了节点处梁端截面应力分布的两个假设，给出了端板屈服弯矩的近似计算方法。

Pultruded fiberglass has 86% of the yield strength of aluminum and, pound-for-pound's, stronger than aluminum in the lengthwise direction.

拉挤玻璃纤维有86 ％的屈服强度铝和，英镑，为英镑的，比铝强，在纵向的方向。

What would he tell Judith and the children?

他将怎样告诉朱迪丝和孩子们呢？

I this is at that time, the opinion with peacockish true girl is full of in a heart.

这就是当时的我，一个心中布满虚荣的女孩子真实的想法。