屈服点

Carried out generalized Mises yield criterion , yield curve on the n flat face was circle curve, and different elected parameters correspond to external angular point circumcircle、 internal angular point circumcircle and incircle of Mohr-Coulomb unequiangular hexagon. According to unequiangular hexagon, circle yield curve which had the same area as hexagon can be found, and corresponding yield criterionwas equilateral circle yield curve.

3广义米赛斯准则在π平面上的屈服曲线为圆曲线，选择的参数不同对应有莫尔—库仑不等角六边形的外角点外接圆，内角点外接圆和内切圆，对于不等角六边形，还可以找到一个面积和六边形相等的圆屈服曲线，对应的屈服准则为等面圆屈服曲线。

In order to analyze rheological property and establish constitutive model of Q_2 loess, a series of uniaxial creep experiments on different water content are done .The creep test curves and stress-strain isochronism curves are drawed with the result of experiments and conclusions are reached from the curves. The creep performance of Q_2 loess is different under the different stress level. In the different time the stress-strain isochronism curve has obvious inflection point namely yield stress and the yield stress reduces along with the increase of water content, which can be described by exponential function.

为了分析黄土的流变特性和建立相应的本构模型，本文首先根据对不同含水量的Q_2黄土进行的一系列单轴应力条件的室内蠕变试验结果，分析总结了Q_2黄土蠕变特征和应力—应变等时曲线特征，得出Q_2黄土在不同的应力水平下蠕变变形表现形式不同；在不同的时刻应力—应变等时曲线存在有较明显的拐点，拐点所对应的应力即为屈服应力，屈服应力随着含水量的增大而呈指数形式降低；Q_2黄土可近似看成一种线性粘弹塑性体。

In order to ensure that the structure is stable, the working stresses are kept well below the yield point or the proof stress.

为了保证结构稳定，工作应力应很好地保持在屈服点或弹性极限以下。

In order to ensure that the structure is stable, the working stress es are kept well below the yield point or the proof stress .

为了保证结构稳定，工作应力应很好地保持在屈服点或弹性极限以下。

Yield point is determined by extrapolation from the flow curve.

屈服点可以通过流变曲线外推法而得到。

An experimental and theoretical study of the earthquake mitigation effect of hysteretic damper s using ultra low yield point steel was presented in this paper.

本文通过试验研究和理论分析探讨极低屈服点软钢阻尼器的减震效果。

The conventional photoelastic modes and procedures suffice to indicate whether or not the yield point of the material of the prototype will be exceeded.

常用的光弹性模型和方法能够指明原型材料的屈服点是否将被超过。

434 We shall take the sample to test its physical properties (mechanical properties, t ensile strength, yield point, percentage elongation, reduction of area, impact value, Brinell hardness).

我们将取样试验其物理性能（机械性能、抗张强度、屈服点、延伸率、断面收缩率、冲击值、布氏硬度）。

The results indicate that in the synchronizing condition the MRF is unyielded, every point of MRF in the flow field has the same angular velocity. Under the slipping condition, with the increase of magnetic field or the decrease of slip speed, MRF may transfer from whole yield to partial yield. When the MRF wholly yields, the angular velocity of MRF increases nonlinearly with its radius, the non-linear distribution becomes more obvious as the magnetic intensity in the working gap increases. When the MRF partially yields, the yield region expands with the decrease of magnetic intensity or the increase of slip speed and the unyield region always reaches the driven rotor. The transfer torque of MRTD increases with the increase of the external magnetic field, but the transfer torque maintains a constant value approximately with the variation of slip speed at the same magnetic intensity.

研究结果表明，在同步工况下，传动装置流场中磁流变液未屈服，各点角速度相同；在滑差工况下，随外加磁场的增大和滑差转速的减小，磁流变液逐渐从完全屈服向部分屈服转变；磁流变液完全屈服时，磁流变液角速度随半径呈非线性增加，工作间隙中磁场越强，流场的非线性分布越明显；磁流变液部分屈服时屈服区域随外加磁场的增大而减小，随滑差转速的增大而增大，未屈服区与主动转子相连；稳态下磁流变传动装置传递的转矩随外加磁场的增加而近似呈线性增大，但在相同外加磁场下，传递转矩基本不随滑差转速改变而改变，表现出良好的恒转矩特性。

Results The single half frame (HF1) was the worst, the delta frame was better, and the half ring frame was the best in over-all performances with regard to rigidity.

对改良AO外固定器进行了5种构型的刚度、屈服点测试，检测指标为抗轴向压力、扭转力、前后弯曲力和侧方弯曲力。

By the time of its fall, most of the prisoners were writers who had written against the corruptions of the government.

到它被攻陷的时候，里面多数的犯人是写了反对政府贪污文章的作家。

The most obvious variation to ovum morphological character was that the color was changed from light green to sepiaceous in embryonic development, and all the ovums were almost hatched after 96h.

在胚胎发育过程中卵的形态特征最明显的变化是颜色从淡绿到深褐色，卵在发育96h后卵基本全部孵化。