屈服

They try not to give in to their chaotic nature, and generally are successful in this practice.

但他们并没有屈服于自身混乱的天性，而将其控制在可容忍的范围内。

By mechanical test of the steel strip and simulation of strip deformation in tension leveling using finite element method,characteristic features of the strip were obtained,such as;high yield stress,high yield ratio and low plastic elongation as the basic reason of difficulty in tension leveling and shape control.

通过对全硬钢的力学性能的测定和拉矫变形行为的有限元仿真，发现屈服应力大、屈强比高以及断裂时塑性延伸小等特性是造成镀锌后全硬带钢拉矫困难和板形难以控制的根本原因。

The historian obviously analyses the power of Alexander into component forces. Talleyrand, Chateaubriand, and so on, and the sum of these component forces, that is, the effect on one another of Chateaubriand, Talleyrand, Madame de Stal, and others is obviously not equal to the resultant effect, that is, the phenomenon of millions of Frenchmen submitting to the Bourbons.

因此，要说明这些分力是以何种方式变成千百万人屈服的原因，也就是说，等于一个A的那些分力是怎样得出等于一千个A的合力的，这位史学家又不得不回到他否定的那个力量——权力，并且承认权力是那些力量的合力，也就是说，他不得不承认一种无法解释的影响合力的力量。

Mr Clifton says he won't bow to what he sees as interference from Argentina.

他认为阿根廷是在干涉阻碍他们的开发，但不会向它屈服。

I would clutch the throat of my fate and never yield up to it.

我要扼住命运的喉咙，决不向它屈服。

Thermal exposured at 175 ℃ for 100 h and 500 h, the yield strength decreases by 5.5% and 14%, and the elongation decreases by 4% and 9.3%, respectively. The fact that S′(Al2CuMg) precipitates get coarsen and the precipitate-free-zones get wider are responsible for the decline of the tensile properties of 2124-T851 aluminum alloy under thermal exposure condition.

于175 ℃热暴露500 h屈服强度和伸长率就分别降低14%和9%；于热暴露条件下，2124-T851合金拉伸性能衰退的主要原因是合金固溶体基体内主要强化相S′(Al2CuMg)相粗化以及晶界无沉淀析出带的宽化。

The results show that proper RRA heat treatment can improve SCC properties with retention of the high strength of T6 level. After preaging at 100℃for 24 h, retrogression at 200℃for 7 min, and reaging at 100℃for 24 h, the ultimate tensile strength, yield strength and elongation of the alloy are 795 MPa, 767 MPa and 9.1%, respectively. Meanwhile the failure time of the alloy applied to tensile strength of 210MPa in 3.0%NaCl+0.5%H2O2corrosion condition is longer than 720 h. The corresponding TEM observation shows that after retrogression for 7 min and re-aging treatment, the microstructure of grain boundary is similar to that treated in the T73 condition with coarsen and isolated distribution, and the microstructure inside grain is similar to that treated in the T6 condition with small and homogeneous distribution.

研究结果表明：在峰值时效T6状态下合金强度高，但抗应力腐蚀性能差；采用合适的RRA热处理工艺既能使合金保持T6状态下的高强度的同时，又能显著改善合金的抗应力腐蚀性能；经回归7 min RRA处理后合金的晶界类似T73态析出相聚集粗化，而晶内类似T6态析出相细小弥散分布，在拉伸应力为210 MPa和3.0%NaCl+0.5%H2O2腐蚀液中，其断裂时间大于720 h，相应的抗拉强度、屈服强度和延伸率分别为795 MPa， 767 MPa和9.1%，显示优越的综合性能。

The results show that proper RRA heat treatment can improve SCC properties with retention of the high strength of T6 level. After pre-aging at 100 ℃ for 24 h, retrogression at 200 ℃ for 7 min, and reaging at 100 ℃ for 24 h, the ultimate tensile strength, yield strength and elongation of the alloy are 795 MPa, 767 MPa and 9.1%, respectively. Meanwhile the failure time of the alloy applied to tensile strength of 210 MPa in 3.0%NaCl+0.5%H2O2 corrosion condition is longer than 720 h. The corresponding TEM observation shows that after retrogression for 7 min and re-aging treatment, the microstructure of grain boundary is similar to that treated in the T73 condition with coarsen and isolated distribution, and the microstructure inside grain is similar to that treated in the T6 condition with small and homogeneous distribution.

研究结果表明：在峰值时效T6状态下合金强度高，但抗应力腐蚀性能差；采用合适的RRA热处理工艺既能使合金保持T6状态下的高强度的同时，又能显著改善合金的抗应力腐蚀性能；经回归7 min RRA处理后合金的晶界类似T73态析出相聚集粗化，而晶内类似T6态析出相细小弥散分布，在拉伸应力为210 MPa和3.0%NaCl+0.5%H2O2腐蚀液中，其断裂时间大于720 h，相应的抗拉强度、屈服强度和延伸率分别为795 MPa， 767 MPa和9.1%，显示优越的综合性能。

The results show that proper RRA heat treatment can improve SCC properties with retention of the high strength of T6 level. After pre-aging at 100℃ for 24 h, retrogression at 200℃ for 7 min, and reaging at 100℃ for 24 h, the ultimate tensile strength, yield strength and elongation of the alloy are 795 MPa, 767 MPa and 9.1%, respectively. Meanwhile the failure time of the alloy applied to tensile strength of 210 MPa in 3.0%NaCl+0.5% H2O2 corrosion condition is longer than 720 h. The corresponding TEM observation shows that after retrogression for 7 min and re-aging treatment, the micro- structure of grain boundary is similar to that treated in the T73 condition with coarsen and isolated distribution, and the microstructure inside grain is similar to that treated in the T6 condition with small and homogeneous distribution.

研究结果表明：在峰值时效T6状态下合金强度高，但抗应力腐蚀性能差；采用合适的RRA热处理工艺既能使合金保持T6状态下的高强度的同时，又能显著改善合金的抗应力腐蚀性能；经回归7min RRA处理后合金的晶界类似T73态析出相聚集粗化，而晶内类似T6态析出相细小弥散分布，在拉伸应力为210 MPa和3.0%NaCl+0.5%H2O2腐蚀液中，其断裂时间大于720h，相应的抗拉强度、屈服强度和延伸率分别为795 MPa，767 MPa和9.1%，显示优越的综合性能。

Thermal exposured at 175℃ for 100 h and 500 h, the yield strength decreases by 5.5% and 14%, and the elongation decreases by 4% and 9.3%, respectively. The fact that S'(AI2CuMg) precipitates get coarsen and the precipitate-free-zones get wider are responsible for the decline of the tensile properties of 2124-T851 aluminum alloy under thermal exposure condition.

于175℃热暴露500h屈服强度和伸长率就分别降低14%和9%；于热暴露条件下，2124-T851合金拉伸性能衰退的主要原因是合金固溶体基体内主要强化相S'(Al2CuMg)相粗化以及晶界无沉淀析出带的宽化。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。