屈曲

The solution was expressed in the form of elliptic integrals, and compared with experimental data.

对于结构内脱层在弯曲作用下发生屈曲的问题，基本上是用有限元法进行分析。

We measured the knee joint gap of flexi...

在后交叉韧带被切断前后用张力测量器分别测量膝关节屈曲90度和伸直位时的内外侧膝关节间隙的数值，精确度为1mm，不加额外的其他力量。

We measuredthe knee joint gap of flexion in 90 degree and full extension by using tensor devicebefore and after resecting posterior cruciate ligament. The minimum incrementwith this device was 1 mm.

在后交叉韧带被切断前后用内径卡尺分别测量膝关节屈曲90度和伸直位时的内外侧膝关节间隙的数值，精确度为1mm。

Objective To study the anatomical and mobile characteristics of collateral ligaments of the elbow.

目的探讨肘关节副韧带的形态结构特点和在不同屈曲角度时的形态变化规律。

Thus there is uncertainty today about whether the lumbricals enable higher speed or whether they cause curl paralysis.

至今为止，人们仍未能确定手背肌能提高速度还是引致屈曲瘫痪。

It is generally believed that these muscles are used mainly to control the curvature of the fingers, so that FFP uses only the muscles in the arms to move the fingers and the lumbricals simply hold the fingers in position, thus simplifying the movement and allowing for greater control and speed for FFP.

但从常识来说，肌肉主要用于控制手指屈曲的幅度，所以直指型只用一手心肌来弹奏，而另手背肌只用于伸张手指。这简化了动作并容许直指型对速度有更好的控制。

The influences of length-to-thickness ratio, material anisotropy and torsions effect on natural frequencies and buckling loads were also investigated.

分析中同时考虑了一阶和高阶横向剪切变形、转动惯量、细长比、各向异性、扭转变形等多种因素对组合梁固有频率和屈曲载荷的影响。

Methods: The hook test was performed by a single surgeon in a cohort of 45 patients undergoing surgical exploration of the distal biceps tendon. While the patient actively supinates with the elbow flexed 90°, an intact hook test permits the examiner to hook his or her index finger under the intact biceps tendon from the lateral side. With an abnormal hook test, indicating distal avulsion, there is no cord-like structure under which the examiner may hook a finger.

一名外科医生对一组45例远端二头肌腱外科手术探查的患者进行了牵引钩试验，当患者肘关节屈曲90度上肢主动旋后时完整的牵引钩试验检查者在完整的二头肌腱侧面可以钩住他或她的食指，而异常的牵引钩试验表明远端撕裂，那里没有索状的结构使检查者可以钩住他的手指。

On the basis of the results and methods of the researches done at home and abroad the analytical model of finite element has been built according to the formation and behavior of I-section plate girders with stiffeners.

实际工程中的板件由于存在初始几何缺陷或在荷载作用下发生屈曲变形后，便具有了壳体的特征，因此文中采用板壳的曲壳有限元分析方法。

A postbuckling analysis is presented for a shear deformable laminated cylindrical panel of finite length subjected to lateral pressure.

基于Reddy高阶剪切变形理论的Karmam-Donnell型非线性壳体方程，给出复合材料层合剪切圆柱曲板在侧压作用下的后屈曲分析。

Do you know, i need you to come back

你知道吗，我需要你回来

Yang yinshu、Wang xiangsheng、Li decang,The first discovery of haemaphysalis conicinna.

1〕 杨银书，王祥生，李德昌。安徽省首次发现嗜群血蜱。