层间

The gold orebodies were controlled by main slip fault zone - structural breccia rock zone.

主要工业矿体受层间滑动构造角砾岩带控制。

The results indicate that SBR emulsified asphalt has better felting capability and temperature stability.

结果表明：SBR乳化沥青具有较好的层间粘结能力和温度稳定性。

The results go as follows: by adopting the 3D FEM model, the more complete and accurate results can be obtained and the analytical result is lower than particle model.

分析结果表明：采用三维杆系有限元模型能够更全面、准确地反映隔震结构的地震反应性能，计算结果低于层间质点模型计算结果。

The application of three DIAR couplers in color negative film is studied,and the data of sensitivity ,fog,particularly,reduced graininess,improved interlayer effect have been obtained.

对 3个DIAR成色剂在彩色负片中的应用进行了研究，得到了它们对感光度、灰雾影响的数据，特别是得到了它们在降低颗粒度和改善层间效应方面的数据。

This is comparable to the in plane order of graphite intercalation compounds.

这相当于在石墨层间化合物的飞机订单。

Quartz - vein type and greisen - type associated with tungsten, and porphyry - type are major types of Sn deposits, In recent few years, a new type of tin deposit- clastic altered rock type has been discovered, which made new development in tin - probing.

赣南地区是闻名于世界的钨锡矿产区，区内锡矿主要有与钨矿共生的石英脉型、云英岩型，斑岩型，隐爆层间裂隙带型等类型，近年来，又发现了锡矿新类型——破碎蚀变岩型，使本区找锡又有了新的进展。

That urine and hexamethylenetetramine taking the place of sodium carbonate as the precipitants could also produce 1D Co3O4 showed lights on understanding the mechanism of formation of 1D structures.

以六次甲基四胺、尿素等代替Na2CO3溶液作为沉淀剂，均得到了一维纳米结构的Co3O4，表明CO2-3在水镁石CoO2层间的嵌入是得到一维结构水热产物的关键。

Base on the weldability tests , the repair welding procedures of weari-resistant cast steel (abrasion-plates) have been made up , The results show that satisfying repair welding quality can be attained with such welding conditions as the low hydrogenous alkalescent welding rod , preheating and slow cooling , strictly maint.

通过对其焊接性能的试验研究，制定了该类铸钢件的补焊工艺：低氢型碱性焊条，预热与缓冷相结合的工艺措施，严格控制层间温度(250～300℃)及焊接工艺规范，可获得满意的修复质量。

Relations between the inelastic story drift of frame and deformation of members are studied.

二、对框架的弹塑性层间位移与构件变形的关系进行了研究。

The results provide a solution to the problems of how to control the impact velocity and how to make the impact velocity for each layer approximately equal and close to the inferior limit in the explosive welding of multilayer metal plates.

该文研究结果为控制层间撞去速度，使其达到基本一致，且接近焊接下限提供了解决方法。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。