层间

However, the result shows that temperature is the most important factor of shearing strength in layers; bestrew detritus diameter is the next one; and then is pave ply; waterproof material is the trifling one.

通过把胶粉改性沥青与SBS改性沥青在相同条件下进行点预估，得出胶粉改性沥青作为防水粘结层的层间抗剪切能力相对较大，适用于桥面。

To improve the performance of image-denoising methods, a locally adaptive denoising algorithm was presented. The new algorithm assumed the statistical dependence among wavelet coefficients. First, a bivariate probability distribution model was introduced to model the statistics of wavelet coefficients, and corresponding nonlinear threshold function was derived from the model using the Bayesian estimation theory.

由于图像小波系数存在很大的层间相关性，引入双变量概率分布模型，基于贝叶斯估计理论，得到了相应的非线性阈值函数；基于层内局域方差估计，利用该收缩函数得到一种局域自适应的图像去噪算法。

At one time, we emphasized the solar radiation transfer mechanics. To advance the estimation precision, in this paper, we classed land cover into four layer, canopy of Robinia pseudoacacia L ,top of Melilotus albus Desr,bottome of Melilotus albus Desr and layer of soil, separately estimated their fluxes of moisture, heat and CO2 ,actualized the separated simulation for each composement in soil-vegetation-atmosphere contimuum.

同时，本次研究强调了太阳辐射在冠层间的辐射传输机制，为了提高估算精度，本文把地表覆盖分为刺槐冠层，草木樨上层、草木樨下层及土壤层四个层面来分别估算其水热及CO2通量，做到了土壤-植被-大气连续体能量及物质通量的分离模拟。

In order to decrease the exchange coupling energy,the biaxial feature ofthe cubic in-plane anisotropy gives rise to a gap of(π/4-3π/4)for the canting angle inthe region relevant to the non-collinear configuration.

层间的交换耦合与磁性层内的各向异性之间的竞争导致了多种可能的自旋组态。

It is shown that beams of reinforced average strain distributing accord with flat section assume; The method of strengthening intension of concrete structure with reinforced materials is a feasible way. The strength of beam can be increased with the number of reinforcement materials be added; The strength of beam is affected by percentage of flexural reinforcement and the compound proportion and fashion of reinforcement materials and the number of reinforcement materials; The capability of bend and stretch and price of inner hybrid fiber is better than sole fiber and exterior hybrid fiber.

通过分析可知：加固后的梁，其平均应变的分布符合平截面假定；使用加固材料来提高混凝土受弯构件承载力的补强加固方法是有效的；构件受弯承载力随加固材料用量的增加而提高；纵筋配筋率、加固材料混杂比例及混杂方式、加固材料用量均对受弯承载力有一定的影响；层内混杂纤维的抗弯性能、延伸性能以及经济性均优于单一纤维和层间混杂纤维。

Through addition of heteropolyacid inhibitors, double boiler crystallization to greatly reduce the layer distribution between the filtering layers (mass fraction is controlled in the range of 1%~2%), pressure rises calmly with the increase of filtering time.

通过在结晶釜中加入杂多酸类阻聚剂、采用双釜变温结晶的方法，使过滤层的层间分布显著减小（质量分数控制在1%~2%范围），压力随过滤时间的增加而缓慢平稳升高。

The experiment results prove that this method effectively re— duces the measurement error caused by the uneven distribution of the flow velocity,and increases the accuracy of Doppler uhrason— iC flowmeter.

层流流动时(雷诺数Re#lt；2 300)，管内流体分层流动，各流层之间互不混杂而平行于管道轴线流动，流层间没有流体质点的相互交换。

The micro mold after forming of electroform needs the increasing thickness process which inset in the block and supports the micro mold during the injection modeling. Otherwise, the buffer layers could prevent the problems of stresss and surface deterioration.

然而微模具在电铸成形后需经增厚处理，因为增厚处理使非常薄的微模具与模具基座较易配合，也将提供微模具於射出成形过程中之支撑，一般增厚制程会在微模具与增厚层间加入一缓冲层避免应力与表层变质造成之问题。

The results showed that the effect of tree-based stratification was morereasonable than equidistance grouping.The difference of lung cancer incidenceis largest between strata and smallest within every stratum with this method.

研究显示，按该模型对主要危险因素进行分层的结果优于常规使用的等距离方法，主要表现在层间率差拉大，层内再分层的率差变小。

The influences of Darcy number and inertia parameter on the velocity profile of the structural flow are analyzed,and it is shown that the velocity profile becomes evener with Darcy number decreasing and the inertia parameter increasing.

随着所施加的外力逐渐增大，管壁附近的各流层依次开始流动，而管路中心的流体仍然以相同的速度，像圆柱体一样向前运动，这部分流体称为流核，流核内部的流层间没有相对运动，具有流核的流体流动称为结构流

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。