层的

The main lithology is lithic arkose and the average porosity of reservoir is 8.21%, the average permeability is 0.256×10-3μm2, and the reservoir belongs to low porosity ultra-low permeability, slender throat-micro throat reservoir.

储层的岩石类型为岩屑长石砂岩，储层平均孔隙度为8.21%、平均渗透率为0.256×10-3μm2，属于低孔特低渗、细喉～微喉型储层。

In addition, some modifications on several computational methods are also presented. Using LMTO method the electronic structure of several systems are studied, and some results are obtained. They are: The ideal Nb (100) surface has three surface states, the multi-layer relaxed surface has two surface states. The surface energy of the ideal surface is higher than that of the relaxed surface, that means that the multi-layer relaxed surface is more stable than the former one, which supports the LEED results. The mono-layer relaxed Ag (111) surface is the most stable one among several" stable surface models"presented by several researchers. The surface energy of Ag (111) surface is higher than that of surface Ag (001), which supports some experimental results such as different reaction rate at different surface orientations for the same material. The surafce states of Si (111) surface not only locate near the Fermi level, but also in the valence band, which agrees well with Cohen's conclusion. Si (111)-H is an effective model for analysing the surface states and H adsorbed on the back surface is a good method for improving the convincingness of the results obtained on thinner slab models. The surface stability depends on three different kinds of MoSi〓(001) surfaces, the surface with mono-layer Si is the most stable one, and the surface with Mo at the first layer is the most unstable one among them. These are consistant with the Kemoda's experimental results. The valence bands of clean or K adsorbed CdTe (111) surface agrees well with the synchrotron radiation studies. The surface of CdTe (111) consists of four kinds of surface models which show different surface electronic structures and different surface structure stabilities. The conclusion agrees well with Wu's experimental work. The different absorbed alkali metals on the CdTe (111) surface give different adsorption characteristics which have relations not only with the valence electrons, but also with the core ones of the alkali metals. The electonic structures of Si-C alloys are different from that of Si-Ge alloys, and the energy band gaps of Si-C alloys do not increase linearly with Carbon concentration, our conclusion supports Alexander's results, but conflicts with Soref's one.

现分述如下： LMTO方法及其应用方面：1）通过对Nb（100）表面电子态分析发现清洁理想表面有三个表面态，多层弛豫表面有两个表面态；表面能大小说明多层弛豫表面更稳定，支持了LEED结果。2）通过对采用不同方法获得的几种不同Ag（111）表面稳定结构的表面能计算分析，给出了单层弛豫表面为Ag（111）表面的最稳定结构；从Ag（111）单层弛豫表面和Ag（001）表面的表面能比较，发现了Ag（001）表面表面能要比Ag（111）小的，表明了同种物质不同表面取向将表现出不同物理、化学性质，这是与实验中得出的结论是吻合的，3）通过对Si（111）表面态分析，不仅发现了Si（111）表面不仅具有居于费米能级附近的悬挂键所对应的表面态，而且还有很多表面态位于价带能量范围内，与Cohen等结果一致，H饱和slab模型背表面相当于增加了slab层的厚度，是一有效的变相增加slab层厚的方法，弛豫表面较清洁理想表面价带谱们低能端的少许移动，预示着总能降低，说明弛豫表面较清洁理想表面稳定。4）MoSi〓具有三种表面，从费米能级上态密度值大小得到单层Si表面最稳定，Mo原子为表层原子的表面最不稳定，双层Si原子表面居中的结论，这与Kemoda等人实验结果是一致的。5）通过对CdTe（111）表面表面电子态、表面结构稳定性及表面H、碱金属吸附的电子结构系列研究，不仅得出了CdTe（111）清洁及碱金属K吸附价带谱与同步辐射光电子谱相吻合的结果，而且发现了CdTe（111）表面具有四类不同原子近邻特征，表现出四类不同的表面结构及电子结构特征：不同表面态分布、不同的表面结构稳定性（表层原子与次层原子成三键有一悬挂键的表面要比表层原子与次层原子成一键有三悬挂键稳定（与Wu等人实验结果一致））、不同的H吸附特性。

Want to know, the person's skin can be divided into three-layer of cuticular, dermal, subcutaneous tissue about; All maintaining the limits that tastes generation action is in only cuticular layer, in thin thin divided in the cuticular layer that is less than one centimeter 4, quintuplicate cell, be located in the bottommest for base layer, full vivid cell can grow ceaselessly reach dissension, slowly when upgrade is advanced, the cell can squash gradually, at the same time evaporate, nutrient, until most the corneous layer outside, already was flowing do not have the corneous layer cell of life however.

要知道，人的肌肤约可分成表皮、真皮、皮下组织三层；所有保养品产生作用的范围都仅在表皮层，在薄薄不到一公分的表皮层中分了四、五层的细胞，位于最底部为基底层，布满的活细胞会不断生长及分裂、慢慢往上推进时，细胞会渐渐变扁，同时失去水分、养分，直到最外的角质层，就已是平滑却没有生命的角质层细胞了。

Use Layer, Set Layer Properties, Set Layer Format, Protect Object, Protect Document, Introduction to ShapeSheet

图层的使用，设置图层属性，设置图层格式，保护对象，保护文档，ShapeSheet 简介

Secondly, the interphase layer is homogenized as a micropolar material model, and the analytical expressions for the local stress and couple stress and their corresponding average are derived for a coated fiber embedded in an infinite matrix under remote classical loading. This exact relation is compared with that determined through an approximate average equivalent inclusion method , and results show that the AEIM has good accuracy to be applied to evaluate the effective property.

就有效性质而言，对于所考察的硬界面复合材料来说均匀界面层的估计要高于非均匀界面层，但两者相差不大；对局部应力分布的预测，均匀界面层与非均匀界面层有较大差别，这说明对于与局部应力密切相关的损伤现象的预测，考虑非均匀界面层是十分必要的。

The fold-and-thrust structure in the northwestern margin of the Junggar Basin is composed of the northern monocline belt,the middle syncline belt,the Ke-Wu faulted belt and the frontal slope belt,and is divided into the upper and lower structural layers in vertical.

准噶尔盆地西北缘冲断构造自西向东由北部单斜带、中部向斜带、克—乌断裂带和前缘斜坡带4个部分组成，在纵向又可划分为上、下两个构造层，上构造层的冲断序列要先于下构造层。

Change the layer type with the lilac-colored butterflies on Linear Dodge.

把淡紫色小蝴蝶层的层类型设置为线性减淡，黄色蝴蝶层类型设置为滤色。

The electrochemical analysis results show that the polarization potential of gradient coating was obviously lower than that of the non-gradient coating electrode.

电化学测试结果表明，与非梯度镀层相比，梯度镀层的极化电位在各电流密度条件下都显著低于非梯度镀层电极。

This article that focuses on the systematic and in-depth research in the current primal problem about abnormal burst pressure reservoir depress burst pressure has procured following main fruits:1 It forms the method which could obtain massive vertical static state mechanics parameters.2 In a foundation of acquisition of rock mechanics parameters,apply bent lamella that as mechanical model along with characteristic of actual geologic characteristics to analysis curvature for anticlinal strcture, get homologous tectonic stress value throug relation between the curvature and stress and different principal curvature in anticlinal structure,consequently set up laminational stress model for anticline reservoir. The block lamination for existed fracturing date has formed method of setting up mechanical model of lamination terrestrial stress by abtaining the block tectonic stress coefficients which are got by complex utilization test, laboratory test and fracturing date playback.3 Analysesing the main reason which lead to high burst pressure by considering the characteristic of reservoir geology,reservoir,and rock mechanics and reservoir damage,etc.Establishing burst pressure quantitative prediction model which provide gist for depressing construction risk and optimizing construction craft under the condition of open hole completion ,gun-perforated completion and damaged reservoir.4 Provding theoretical basis for interpreting acidification pretreatment which could depress busrt pressure by finding the relation between the influencing factors and rock machanics parameters and analysing the factors that have effect on rock mechanics parameters. Expounding the mechanism of reaction of mixed monomineral and acid from the angle of microcosmic element, evaluating quantitatively acid sensilility of different kinds of mineral effectively, and determing the first-order reaction dynamical equation of each mineral.5 Revealing rock mechanics property chage as a result of acid flooding in different condition by sandstone traumata experiment in different temperatures which combined with rock mechanics triaxial stress experiment.6 Associating damage mechanics with sandstone acidizing, established sandstone damage mechanics model in the foundation of the recognition on the rock mechanics parametric variation which is caused by acid-rock reaction in both macroscopic view and microscopic view ,also demonstrated those processes and quantitative estimated the acid busrt pressure to direct the site operation.

本文针对目前异常破裂压力储层降低破裂压力的主要问题展开较为系统和深入的研究，取得了以下主要成果：1形成了利用测井资料，结合室内岩芯测试结果，获取静动岩石力学参数的相关性特征，从而获得纵向上大量静态力学参数的方法。2在获取了岩石力学参数的此基础上，利用弯曲薄板作为力学模型，结合区块实际地质特征对背斜构造进行曲率分析，通过曲率与应力的关系，利用背斜构造不同部位的主曲率求得相应的构造应力值，从而建立起背斜储层的分层应力模型；对已有压裂资料的区块分层，形成了综合利用测试、室内实验、压裂资料反演获得该区块构造应力系数，建立起分层地应力的力学模型的方法。3综合考虑储层地质、油藏、岩石力学特性和储层伤害等因素，分析造成高破裂压力的主要原因，综合利用岩石力学、弹性力学等知识，建立了裸眼完井、射孔完井条件下以及储层受到伤害后的储层破裂压力定量预测模型，为降低施工风险和优化施工工艺提供了依据。4完成了物性、岩性影响岩石力学参数的因素分析，找出了各影响因素和岩石力学参数之间的关系，为从机理上解释酸化预处理降低破裂压力提供了理论基础；从微观元素的角度阐述了单矿物与酸反应的机理；并在此基础上，有效评价了各种矿物的酸敏感性，定量确定了岩石中各矿物的一级反应动力学方程。5完成了不同温度下的酸液类型、酸液浓度、注酸量等一系列砂岩损伤实验，结合岩石力学三轴应力实验，系统揭示了在不同条件下注酸而引起的岩石力学性质变化。6将损伤力学与砂岩酸化相结合，在宏观、微观两个方面认识酸岩反应引起岩石力学参数变化基础上，建立了砂岩损伤力学模型，并对其进行验证，在此基础上定量计算酸化后的破裂压力，有效指导现场施工

Thus,the standard for reservoir dividing and sorting is established combining with the data as core experimental analysis,logging,well log,well testing and geologic studying. This paper describes the reservoir distribution in wells and predicts 3-D reservoir distribution of Archaeozoic reservoir in the Chengbei-30 burried hill with 3-D seismic inversion.

为此，岩心、录井、测井、试井结合建立了储集层划分和分类标准，识别描述了井点储集层的分布；以井点储集层为约束条件，应用三维地震反演技术，预测了埕北30潜山太古宇油藏的储集层三维空间展布。

With Death guitarist Schuldiner adopting vocal duties, the band made a major impact on the scene.

随着死亡的吉他手Schuldiner接受主唱的职务，乐队在现实中树立了重要的影响。

But he could still end up breakfasting on Swiss-government issue muesli because all six are accused of nicking around 45 million pounds they should have paid to FIFA.

不过他最后仍有可能沦为瑞士政府&议事餐桌&上的一道早餐，因为这所有六个人都被指控把本应支付给国际足联的大约4500万英镑骗了个精光。