层状的

Compared with the graphite, the coefficients of friction of the RL-C/C are lower under the same load of about 0.08-0.12, and the increasing range of the volume losses are still lower than those of the graphite. Compared with the SL pyrocarbon material, the COF and the volume loss of the SL-C/C are about 0.02-0.05 and 0.2 mm^3, lower than those under the same load. The COFs of most RL-C/C and SL-C/C specimens remain stable or decrease slightly with time, while those of the graphite and pyrocarbon specimens increase. The thickness of the integrated friction film of the RL-C/C decreases with load, but the wear surface of the SL-C/C is rough. Tough the wear surface of the graphite is integrated, the serious abrasive wear make the debris move easily and accumulate on the edge of the wear trace to form a restacked morphology. On the wear surface of the pyrocarbon material, some loosed debris, circular worn holes and flake worn out pyrocarbon has been found.

结果表明：PAN炭纤维改善C/C复合材料的摩擦磨损行为；在实验载荷范围内，与高强度石墨材料相比，含RL炭C/C复合材料的摩擦因数降低0.08~0.12；体积磨损量增幅降低；与热解炭试样相比，具有SL炭C/C复合材料的摩擦因数降低0.02~0.05，体积磨损量低0.2立方公厘左右；随着时间的延长，大部分C/C复合材料的摩擦因数基本相对稳定或呈小幅下降，而石墨、热解炭块的摩擦因数均呈不同幅度的上升；具有RL炭的C/C复合材料摩擦表面膜厚度随载荷增加而降低，具有SL炭的C/C复合材料摩擦表面较粗糙；高强石墨能形成较完整致密的摩擦膜，但磨粒磨损严重，磨屑易在摩擦膜边缘形成层状堆积；热解炭块摩擦表面磨屑堆积松散，有较多的孔洞以及热解炭层整体剥落的形貌。

Compared with the graphite, the coefficients of friction of the RL-C/C are lower under the same load of about 0.080.12, and the increasing range of the volume losses are still lower than those of the graphite. Compared with the SL pyrocarbon material, the COF and the volume loss of the SL-C/C are about 0.020.05 and 0.2 mm3, lower than those under the same load. The COFs of most RL-C/C and SL-C/C specimens remain stable or decrease slightly with time, while those of the graphite and pyrocarbon specimens increase. The thickness of the integrated friction film of the RL-C/C decreases with load, but the wear surface of the SL-C/C is rough. Tough the wear surface of the graphite is integrated, the serious abrasive wear make the debris move easily and accumulate on the edge of the wear trace to form a restacked morphology. On the wear surface of the pyrocarbon material, some loosed debris, circular worn holes and flake worn out pyrocarbon has been found.

结果表明：PAN炭纤维改善C/C复合材料的摩擦磨损行为；在实验载荷范围内，与高强度石墨材料相比，含RL炭C/C复合材料的摩擦因数降低0.08~0.12；体积磨损量增幅降低；与热解炭试样相比，具有SL炭C/C复合材料的摩擦因数降低0.02~0.05，体积磨损量低0.2 mm3左右；随着时间的延长，大部分C/C复合材料的摩擦因数基本相对稳定或呈小幅下降，而石墨、热解炭块的摩擦因数均呈不同幅度的上升；具有RL炭的C/C复合材料摩擦表面膜厚度随载荷增加而降低，具有SL炭的C/C复合材料摩擦表面较粗糙；高强石墨能形成较完整致密的摩擦膜，但磨粒磨损严重，磨屑易在摩擦膜边缘形成层状堆积；热解炭块摩擦表面磨屑堆积松散，有较多的孔洞以及热解炭层整体剥落的形貌。

Business card printing and membership card-making machine to outages, we can see on the surface of the rollers in a accumulational of a thick layer like mesh irregularities with Burr's virtual of inks, this is the naked eye can be directly observed very obvious process of emulsive envirogluvtm.

制卡和会员卡制作机在停机时，我们可以看到墨辊的表面上堆积的厚厚的一层如同网状的凹凸不平带毛刺的虚状油墨，这是我们用肉眼可以直接观察到的非常明显的油墨过程度乳化现象。

In Wistar rats, latent period of a-wave in scotopic rod response after 1-week transplantation was shorten (P.05); and latent period of a-wave in scotopic rod response after 2-week transplantation was prolonged (P.05); while latent period of b-wave in scotopic maximum response after 1-week transplantation was shorten (P.05). In RCS rats, amplitude of a-wave in scotopic rod response and photopic response after 4-week transplantation was increased (PO.05); while latent period of a-wave in scotopic rod response after 4-week transplantation was shorten (PO.05).Conclusion 1. At the age of 3 months, photoreceptors of the RCS rat degenerated completely, which leaded to the reduction of amplitudes of a-wave and b-wave.

Wstar大鼠术后1周的暗适应视杆反应，a波潜伏期缩短o叼。05）；术后2周的暗适应视杆反应，a波潜伏期延长o功刀5）：术后1周的暗适应最大反应，b波潜伏期缩短o功刀5卜＊CS大鼠术后4周的暗适应视杆反应和明适应反应，a波振幅增大o功刀匀；术后4周的暗适应视杆反应，a波潜伏期缩短o＜0卜结论1、RCS大鼠在3月龄时感光细胞变性死亡，导致FERG的a、b波振幅明显降低；视网膜下腔仍存在感光细胞外节盘膜碎屑，外丛状层缺乏感光细胞的突触末端，同时Muler细胞出现反应性胶质纤维增生。

The rules of fluid rate with different technical parameters: the increase of electromagnetic force causes the increases of the fluid rates at S/L interface and free surface, the decrease of skin depth, the increase of electric current density which will make the fluid at free surface flowing faster, while it doesnt affect the fluid rate at S/L interface. When the height of melt increases, the both of fluid rates will increase too. The increase of the width-thickness ratio augments the fluid rates along the wider edges at S/L interface evidently, while the rates along the narrow edges will have little change, and the rate at free surface has little change too. The increase of overheat degree minishes the range of mush zone, while the fluid rates at S/L interface and free surface will increase evidently.

流速的大小随各种不同工艺因素的变化呈现出一定的变化规律：随电磁力的增大，固液界面以及自由表面处的流速都会增大；集肤层渗入深度变薄，电流密度增大，会导致自由表面上流动的加强，但对固液界面处的流动速度影响不大；熔区高度的增加，也会使固液界面及自由表面处的流动增强；宽厚比增大时，固液界面上沿宽面方向的流动显著增强，但窄面方向流速变化不大，同时自由表面上流速变化也较小；过热度及温度梯度的增大，使糊状区减小，导致固液界面及自由表面处的流速显著增大。

At the beginning of the thesis, the structure of usually used radome is introduced and the parameters of electromagntic characters are described in Chapter Ⅰ; the different methods for analysis of the electromagnetic characters of radome are summarized in Chapter Ⅱ; the propagation of 3-D beam in free space is conducted in Chapter Ⅲ; then in Chapter Ⅳ, the 3-D Complex Ray Theory are analyzed and the characters of transmitted field of sum and difference beams through radome are studied, and the relative formulations of calculation are rekened; at last the electromagnetic characters of the ellipsoidal sandwich radome and the plane single-layered radome are discussed, and suggestions for optimization of electromagnetic properties of radome are given.

本文第一章介绍了常用雷达罩的结构和描述雷达罩电磁特性的参量，第二章概述了目前分析雷达罩电磁特性所采用的各种方法，第三章分析了三维波束在自由空间传输特性，第四章研究了三维复射线理论，并应用它分析了单脉冲和差波束穿过雷达罩透射场的特性，导出了有关计算公式，在第五章，通过大量的数值计算和实验研究，讨论了椭球形三层夹心状实用雷达罩和单层介质平板模拟雷达罩的电磁特性，并提供了雷达罩电气特性优化的建议。

As she looked at Warrington's manly face, and dark, melancholy eyes, she had settled in her mind that he must have been the victim of an unhappy attachment.

每逢看到沃林顿那刚毅的脸，那乌黑、忧郁的眼睛，她便会相信，他一定作过不幸的爱情的受害者。

Maybe they'll disappear into a pothole.

也许他们将在壶穴里消失