层

The sedimentation is the foundation, affecting the basic pattern of the reservoir,and the sedimentary facies zones beneficial to the formation and evolution of the reservoir includes platform edge bank facies, introplatform point beach facies and acclivity sedimentary facies, etc.; the diagenesis is the key factor, determining the pattern and scope of the final distribution of the reservoir and being of great influence on reservoir structure, and the diagenesis of promoting the formation of storage rooms is mainly the dissolution occurred during hypergene stage and burial stage;and the tectonism is the condition of influencing the connectivity among various reservoir bodies and among the storage rooms within a single reservoir body.

该套储层是在4亿年左右的地质历史中，由沉积、成岩和构造作用相互影响而形成的最终成果：其中沉积作用是基础，影响着储层的基本形态，有利于储层形成与演化的沉积相为台地边缘滩、台内点滩和上斜坡等沉积相带；成岩作用是关键，决定了储层的最终分布形态和范围，对储层结构的影响至关重要，促进储集空间形成的成岩作用主要有表生期和埋藏期的溶解作用；构造作用是条件，影响着各储集体之间以及单一储集体内部储集空间的连通情况。

As a result, if the iridescence is produced by thin-film interference, not only the thickness of lamellar structure must be defined within a certain nanometer, but also the refractive index need to be different between lamellar structure. In other words, the chemical composition, refractive index and thickness of exsolution lamellae need form to trinity, such as labradorite, albite, andradite and orthoamphibole. If the iridescent color is produced by grating-diffraction, the lamellar structure just needs to be arrayed regularly, the spacing of the edges of lamellar structure needs to be regular and narrow, but not necessarily within the range of the wavelength of visible light, such as shell of abalone, pearl and opal.

薄膜干涉式晕彩不仅要求宝石内部结构层的厚度必须在一定的纳米范围内，而且结构层内部的折射率也必须有所差别，也即，当结构层由两相组分出溶而成，其化学成分、折射率和结构层厚度形成三位一体时，符合薄膜干涉式晕彩，如拉长石、钠长石、石榴石和角闪石；而光栅式衍射晕彩则仅要求结构层排列规则，边缘狭窄但不需要窄到可见光波长范围内，能使入射光的振幅或位相，或两者同时产生周期性空间调制的结构即可，如鲍贝壳、珍珠和欧泊。

The results indicated that the ice sample was obviously divided into four layers as micro-pollution layer,cleaned layer,mixed layer and precipitate layer after aqueous bromamine acid solution was completely frozen.

试验表明，溴氨酸水溶液完全冻结后，冰样可分为4层：微污染层、洁净层、混合层和析出层。

The saltation boundary layer is divided into an inner boundary layer in which the saltating particles exert significant force on the airflow, and an outer boundary layer in which saltating particles exert insignificant force on the airflow, but the out layer is affected by the inner boundary layer.

将风沙边界层划分为跃移颗粒所产生的阻力不可忽略的内边界层和跃移颗粒阻力可以忽略但受内边界层影响的外边界层，分别建立了内边界层和外边界层的风速廓线表达式。

In this paper , the sex-effects of the cocoon quality characters in silkworm was predicted with Mixed linear model :The fact that the probability of effect variance and predictability of random gender of whole cocoon weight, cocoon shell weight, ratio of cocoon shell and pupa weight reached a level of extreme significance showed that the gender effect of the four traits was extremely significant, which matched with the reality completely.

研究采用混合线性模型，对家蚕全茧量、茧层量、茧层率和蛹体重等性状的性别效应进行理论估算：全茧量、茧层量、茧层率和蛹体重等4性状的性别随机效应的方差的概率和性别随机效应的预测值概率都达到极显著水平，证明全茧量、茧层量、茧层率和蛹体重等四性状的性别效应极显著，这完全符合实际情况。

Firstly, according to study dynamic changes of the elements structures in succession about natural and artificial forest, then summarized regular patterns;at the same time.based on the study of Coupling Relationship between structure and function of water conservation forest established the ideal structures from the stand level and the watershed level. The ideal structures from the stand level: uneven-aged, double layer and mixed structure, and trend to natural forest. The watershed level followed the same principle, that is double layer patches, uneven-aged forest well-distributed and to build up different forest patches in watershed.

首先，经过对北京山区水源林天然林和人工林结构要素的演替动态研究，提出其发展规律，同时依据水源林结构与功能耦合关系研究，从林分层次和流域层次上分别构建了水源林的理想结构，其中，林分层次上水源林的理想结构为：异龄、复层、混交的结构状态，林分结构趋于天然林结构的特征；在流域层次上水源林的理想结构为也应形成&复层&、&异龄&、&混交&的结构，即：在流域各水源林斑块间形成林冠层复层、斑块内部乔木、灌木、草本层的复层；不同水源林年龄面积上的均匀分布；形成不同水源林斑块间的镶嵌分布。

This paper studied penetration of asphalt emulsion and asphalt diluted by paraffin and infection of preservation; presented optimal prime coat material and dosage, and determined optimal dosage of SBS modified asphalt and base asphalt as seal coat binder sprayed on cement stabilized gravel. This paper also analysed influence of different material combination on shear intensity between base and surface. The shear intensity of earthwork cloth is also researched through analysis on different cloth, temperature and treatment on gravel.

文中通过室内试验，研究了乳化沥青和煤油稀释沥青作为半刚性基层透层材料的渗透效果，以及基层不同养生龄期对其的影响，提出了水泥稳定碎石和二灰稳定碎石基层上最佳的透层材料及其最佳洒布量；研究和分析了下封层不同透封层材料的组合、不同结合料以及不同基底材料对封层材料用量以及基面层间抗剪强度的影响。

There are some main conclusions as follows:1、 In Inner Mongolia, Mean cloud amount, low cloud amount, middle cloud amount , liquid stratocumulus liquid stratus、 ice stratocumulus、 ice stratus、 ice nimbostratus cloud amount are getting more from west to east.

主要研究结果如下： 1、内蒙古地区总云量、低云量、中云量、液态层积云、液态层云、冰像层积云、冰像层云、冰态雨层云云量呈自西向东依次增多，高云量、卷层云、深对流云云量自西南向东北依次减少的空间分布特征。

Firstly, we investigate the influence of the hole injection layer on the performance of the OLED. Evidence shows that m-MTDATA exhibits a dense film structure and fine surface morphology, leading to easy hole migration. Furthermore, a low-voltage driving of OLEDs has been achieved by doping 4F-TCNQ into m-MTDATA layer. Secondly, we obtain a highly efficient OLED by using a new oxidiazoles, an efficient electron-transporting molecular materials. Finally, we have realized the efficient electron injection and transport in organic light-emitting diodes using an electron-transport layer composed of BPhen with Liq co-deposited layer. With this cohost strategy, we improve the power efficiency by～21 % while reduce the driving voltage by～13%.

首先研究了不同空穴传输层对有机电致发光器件的影响，结果表明，由于m-MTDATA具有良好的成膜性，以及空穴注入能力，可以改善空穴向发光层的注入，提高了器件的效率，进一步在m-MTDATA中掺入4F-TCNQ可以显著降低器件的驱动电压；其次，利用一种新型含氟噁二唑类衍生物做电子注入层获得了高效有机薄膜电致发光器件；最后，研究了Bphen：Liq混合层的电子传输特性，表明混合层的电子传输能力显著提高，基于共基质电子传输层的器件的电压比传统器件降低了13％而效率却提高了21％。

A process for making an electronic device which comprises applying a nonaqueous plate-resistant ink by ink jet printing to selected areas of a dielectric substrate, optionally laminated with an electrically conductive metal, exposing the plate resistant ink to actinic and/or particle beam radiation to effect polymerisation, adding one or more metal layers by electrolytic or electroless deposition, the upper layer of which is an etchresistant metal, removing the polymerised plate-resistant ink with alkali and finally removing the electrically conductive metal which are optionally directly laminated to the dielectric substrate and not protected by an upper layer of etch-resistant metal by chemical etching wherein the plate-resistant ink is substantially solvent-free and comprises: A 30 to 90 parts acrylate functional monomers free from acid groups comprising mono- or higher functionality wherein 5 to 95% by weight are mono-functional monomers; B 1 to 30 parts acrylate functional monomer containing one or more acid groups; C 0 to 20 parts polymer or prepolymer; D 0 to 20 parts radical initiator; E 0 to 5 parts colorant; F 0 to 5 parts surfactant; and where the ink has a viscosity of not greater than 30 cPs at 40 DEG C and all parts are by weight.

一种制备电子装置的方法，所述方法包括以下步骤：通过喷墨印刷在任选层压了一种或多种导电金属的介电底材的选定区域涂覆非水的阻沉积油墨，将所述阻沉积油墨暴露在光化辐射和/或微粒束辐射中以完成聚合，通过电解沉积或无电沉积增加一层或多层金属层，其中最上层的金属层为一种或多种阻蚀刻金属，用碱除去聚合的阻沉积油墨，最后通过化学蚀刻将任选直接层压在所述介电底材上并且不被一种或多种阻蚀刻金属的上层保护的导电金属除去，其中所述阻沉积油墨基本不含溶剂，并且包含以下组分：A30-90份不含酸基团的丙烯酸酯功能性单体，所述单体包括单官能或多官能单体，其中5-95％重量为单官能单体；B1-30份包含一个或多个酸基团的丙烯酸酯功能性单体；C0-20份聚合物或预聚物；D0-20份自由基引发剂；E0-5份着色剂；和F0-5份表面活性剂；其中所述油墨的粘度在40℃下不高于30cPs，并且所有的份数以重量计。

I will endeavour to find you some assistance.

我尽力帮你找人帮忙。

At first I only know bruck is the idol of American younglings, afterwards I returned back to Taiwan ,even in Beijing last year ,I saw her poster everywhere, I was so surprised at her charm.

起初我只晓得布鲁克雷德丝是美国少男少女崇拜的偶像，后来回台湾，甚至去年在北京，居然也四处看见她的海报，才惊讶她的魅力之大。