对轴

Then I drilled the shaft holes in the rudders on the drill press.

然后我钻轴孔，在舵对这次演习的新闻。

This article mainly design the various parts of the steering driving axle, such as designing, the computation, the examination.

本文主要对转向驱动桥各部件进行设计、计算、校核，同时绘出了转向驱动桥的装配图，外半轴、转向节外壳、主减速器的主、从动齿轮的零件图。

Objective:Since some limitaions of SRK Ⅱ formula,the dual cubic curved regressive formula was designed. methods:By means of computer,statistical analysis and regressive treatment of kerato diopter,axial length and emmetropic IOL diopter of 415 pseudophakia was done.

针对目前临床上常用的SRKⅡ公式在计算人工晶体屈光度时的局限性，对415只后房型人工晶体眼的角膜屈光力、眼轴长度和正视化人工晶体屈光度进行回归分析后，设计出一种不同于传统的线性回归公式的曲线回归公式——二元三次计算公式。

Then, by the aid of the self-made piezoelectric vibration table, experiments of vibration drilling were done on duralumin (2A12) and stainless steel (0Cr18Ni9), and the aperture size, surface topography and surface roughness were tested.

在此基础上，利用自制的压电式振动工作台进行了硬铝和不锈钢的轴向振动钻削实验，并对孔径大小、表面形貌和表面粗糙度进行了测量。

Combined transfer of the galea aponeurotica and temporal fascia was used to repair severe infra-orbital soft tissue depression and ectropion of lower lid in 6 cases.

经过对颞区解剖分析，采用带颞浅动脉顶支的帽状腱膜、颞膜轴型瓣加游离植皮的方法，修复眶下组织重度凹陷及下睑外翻6例。

Methods 15 patients with different type and degree of cicatricial ectropion were repaired with the method of simple skin grafting, posterior auricular refluxing axial skin flap or anchyloblepharon.

对15例不同类型和不同程度的瘢痕性睑外翻，采用局部瘢痕松解睑缘粘连、耳后返流轴型皮瓣修复及瘢痕松解植皮修复。

The animate simulation for the coaxial collision of two elastic bars is performed onthe basis of the analyses for the stress waves.

在应力波分析的基础上，对两根弹性杆纵向共轴撞击过程进行了动画模拟。

The results demonstrated that:(1) some primary unit after-discharges were synchronized with electrographic after-discharges in the anterior dorsal HPC network after eight or nine tetanic trains were administered.

结果， ATPDH可以沿长轴向前1.8 mm处对前背HPC神经网络产生下述效应：(1)同步或非同步原发性单位与深部电图后放电，在同步性后放电锁时关系明显。

The efficiency curve was fit using least-square method. The empirical formula of the efficiency curve slope of Ge detectors relative to their sensitive volume-S = a log + b -has been demonstrated in extremely large sensitive volume range. Using thisformula it can be estimated that the full en...

在极大的灵敏体积范围内，验证了锗探测器效率曲线斜率与其灵敏体积关系的经验公式：S=alogV+b，采用本公式可在小于3％的相对误差范围内，对已知灵敏体积的同轴HPGe探测器的全能峰效率随γ射线能量的变化作出估价。

Methods Through the triaxial creep test, the triaxial creep curves and isochorounous stress-strain curves have been obtained, then the creep characteristics of mica-quartzose schist have been obtained by analyzing the triaxial creep curves, and the isochrounous stress-strain characteristics of mica-quartzose schist have been obtained by analyzing the isochorounous stress-strain curves. Finally, an empirical formula of creep curve is obtained by data fitting and the analysis of the relation between time and parameter of fitting formula.

通过三轴蠕变试验首先得到了云母石英片岩的蠕变曲线和应力应变等时曲线，然后对试验曲线进行分析得到云母石英片岩的蠕变特性和云母石英片岩的等时应力应变特性，最后拟合应力应变等时曲线，并分析时间和拟合公式中参数的关系，得出了蠕变经验公式。

Lugalbanda was a god and shepherd king of Uruk where he was worshipped for over a thousand years.

Lugalbanda 是神和被崇拜了一千年多 Uruk古埃及喜克索王朝国王。

I am coming just now,' and went on perfuming himself with Hunut, then he came and sat.

我来只是现在，'歼灭战perfuming自己与胡努特，那麼，他来到和SAT 。