对轴

A new and skillful method in alignment of the pulse laser range finder s aim axis and receiving axis was put forward.

介绍一种测试设备，它可对激光测距机的接收光轴与瞄准光轴的平行度进行测试。

Finally, We analyze and experimentally demonstrate that both the bandwidth of the fiber Bragg grating's short wavelength loss and the bandwidth of fiber Bragg grating's reflection increase with the increase of strain gradient along the length of grating.

最后，我们对光纤光栅的反射和短波损耗的应变特性作了理论分析和实验测试，发现在光纤光栅的反射带宽随光栅轴向应变梯度的增加而增加的同时，光栅短波损耗带宽也随光栅轴向应变梯度的增加而增加。

In chapter 4, the in situ measurement system composed of the six-port reflectometer and the coaxial probe is introduced and some guidelines for in situ measurement is highlighted.

第二章建模和计算先对建模方法和反演方法进行了概述，然后建立了同轴探头的谱域全波模型，着重讨论了伽辽金矩量法求解积分方程有关的积分计算问题，分析了同轴探头高次模式的影响，最后给出了波导探头的谱域模型。

Basing on electromagnetism theory characteristic of light wave, the formula of the relation of refringence e light is inferred under any axis location and any angle, when it is refracting.

基于平面光波在晶体中传播的电磁理论特性，推导了光波在晶体表面折射时，双折射光波中e光线透过晶体出射点的位置受到任意光轴取向、任意入射角影响的关系式；利用MATLAB对关系式进行了数值计算分析，绘出双折射e光与任意光轴取向、任意入射角关系曲线，并给出了对应的定量关系式；实验验证了该公式是正确的。

Through using the computer in the teaching of critical speed experiment of flex rotor axis , this paper measurers the revenant data as the flex rotor axis passing the critical speed, and expounds the advantages of using computer in this experiment.

通过将计算机用于柔性转子轴的临界转速实验教学，对柔性转子轴在通过其临界转速时进行了相关数据的测量，并阐述了将计算机应用于该实验的优点。

Took the different diameters double-row bearing slewing ring asexample, this dissertation studied the distribution of axial press ofthe rolling body under axial load and throw moment, the contact pressbetween two outer seat-rings which are connected to the main machinewith high strength screw bolts.

本文以双排异径球式回转支承为例，对球式回转支承在承受轴向载荷和倾翻力矩时的滚动体轴向正压力大小、分布及由高强度螺栓与主机连接的滚圈接触面的接触力进行了详细的理论推导和实际计算，说明在双排球式回转支承的结构静力分析过程中，可以将滚圈安装接触面的接触力简化为铅垂方向的均布载荷。

Leaf sheaths glabrous or pubescent; auricles acute erect swellings or absent; leaf blades conduplicate,(1.5–)5–10(–14)× 0.2–0.4 mm, 0.5–0.8 mm deep, veins 5–7(–9); adaxial to abaxial sclerenchyma strands absent, abaxial sclerenchyma in 3 narrow discrete strands; ligule 0.1–0.4 mm, margin ciliolate.

叶鞘无毛或被短柔毛；叶耳锐尖直立或无；叶片对折，( 1.5-)5-10(-14)* 0.2-0.4 毫米，0.5-0.8毫米深，脉5-7-9；缺席背轴sclerenchyma股，在3 狭窄的分离的股的背轴sclerenchyma正面；叶舌0.1-0.4毫米，边缘具短缘毛。

Setscrew Type: Two setscrews have a angle of 90 °,this low-cost type features the most conventional attachment.However,the point of setscrew may cause damage to the shaft and may be difficult to remove.

定位螺丝固定：两个定位螺丝间隙 90 °对所固定的轴进行锁紧，是一种传统的固定方式，由于螺丝的前端与轴心接触，可能会造成轴新的损伤或拆卸困难。

This paper remarks the vibrational models of shafting existed today firstly so as to research the coupled vibration of shafting effectively.

为了有效地研究轴系的耦合振动，本文首先对现有的轴系振动模型进行了评述。

Relatively speaking, the drawing for tube with fixed short plug technology would reduce the difference of the residual stress between inside and outside of the tube, and increases its uniformity.

外模半锥角对固定短芯头拔管材的轴向残余应力具有显著的影响；当半锥角为12 时，拉拔后管材的轴向残余应力值较小且分布均匀。

Plunder melds and run with this jewel!

掠夺melds和运行与此宝石！

My dream is to be a crazy growing tree and extend at the edge between the city and the forest.

此刻，也许正是在通往天国的路上，我体验着这白色的晕旋。