对圆的

The multiple cracks and multiple circular holes problem of the particular antiplane regions are studied in the paper by the complex variable function and integral equation method.

利用Fredholm积分方程和复函数方法对断裂力学中的一些特殊反平面区域内的多圆孔、多裂纹问题进行了计算。

Antiplane responses of a scalene triangular hill or structure, an isosceles triangular hill or structure, an isosceles triangular hill with a subsurface cavity to incident SH waves are studied in this paper based on methods of wave function expanding, complex function, moving coordinates and by employing idea of assistant function.

本文在"分区"和辅助函数思想的指导下，综合利用了波函数展开、复变函数、移动坐标三种方法，研究了等腰三角形凸起地形和坝体结构、非等腰三角形凸起地形和坝体结构、浅埋圆孔附近等腰三角形凸起地形等三类问题对SH波的散射。

These Chuarids of various kinds, which are small and circular carbonaceous fossils, have attracted many attentions.

各国学者对这些小圆蕊状为主的炭质薄膜化石的生物学分类位置有不同认识。

With the methods of conformal mapping and the Cauchy integral, two cases of crack geometries are studied: one is for a crack emanating from a circular hole and the other is for two symmetric cracks emanating from a circular hole.

利用保角变换和 Cauchy 积分的方法，对含有圆孔孔边单裂纹和双裂纹的压电弹性体分别进行了分析。

N experiment combining flow visualization and temperature measurement is carried out in the present study to investigate the possible presence of new inertia-driven vortex rolls and some unique characteristics of the time-dependent mixed convective vortex flow resulting from a high speed round air jet impinging onto a heated horizontal circular disk in a vertical cylindrical chamber.

bstract：本篇论文利用实验流场观测方法及温度场量测方法对於垂直圆柱容器中一高速空气圆形喷流冲击至一加热圆盘之可能产生新的惯性力驱动涡流和一些独特的周期性混合对流涡流流场特性进行研究。

Two-dimensional finite difference time domain simulation results show that, in a wide angle range (about 20 degrees), in a normalized circular frequency range of , the transmission intensity can reach over 98% for both TE and TM polarization.

二维有限时域差分模拟结果显示，在较宽的角度范围内（约20度），约化圆频率处在范围内，分束器对TE和TM偏振光的透射强度都能达到95%以上。

The research on microstructure pattern and mechanical properties of the circular ring parts by liquid forging experiment under different specific pressures and casting temperature s were stated.

通过圆环零件的液态模锻成形实验，对在不同比压和浇铸温度条件下，锻件的微观组织形貌和力学性能进行了分析研究。

The research on microstructure pattern and mechanical properties of the circular ring parts by liquid forging experiment under different specific pressure s and casting temperatures were stated.

通过圆环零件的液态模锻成形实验，对在不同比压和浇铸温度条件下，锻件的微观组织形貌和力学性能进行了分析研究。

The research on microstructure pattern and mechanical properties of the circular ring parts by liquid forging experiment under different specific pressures and casting temperatures were stated.

通过圆环零件的液态模锻成形实验，对在不同比压和浇铸温度条件下，锻件的微观组织形貌和力学性能进行了分析研究。

And then the point spread function can be acquired through Abel reverse transform, according to the circular symmetry characteristic of the defocused image.

由于离焦造成的图像模糊是圆对称的，对线扩散函数进行阿贝尔逆变换就得到了点扩散函数。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。