宽面

This thesis discusses the following. First, we use the condition of inference and the concept of wildhabor cone to design the addendum circle. Second, we use TCA technique to obtain the relationship between the slip track and the angle of action, which then leads to the calculation of contact ratios. We can then design the tooth face width and the numbers of teeth based on contact ratios.

本文一开始先对空间渐开线齿轮之齿冠圆范围使用齿轮干涉条件与Phillips提出的Wildhabor Cone进行设定，再利用Litvin提出的齿面接触分析方法，得到空间渐开线齿轮对在啮合过程中作用角与滑动轨迹之间的关系，藉由此关系可以建立一套设计流程来调整齿面宽以及齿数等参数，使其能符合设计需求。

Results Sacroiliac joints in 62 cases were abnormal:in early stage,articular face was affected and the bone cortex incrassated and osteosclerosis partly,joint space was normal;in late stage,vermiform destruction of bone was seen in articular face,the density of cortex was heighten irregular,joint space widen or narrow,and at last the joint space vanished,the joint ankylosed.

结果 62例患者骶髂关节表现异常，包括：早期，骨关节面受侵蚀、骨皮质局限增厚、硬化，关节间隙正常；后期，关节面呈虫蚀状改变，关节面皮质密度不规则增高，关节间隙增宽或变窄，最终关节间隙消失，关节强直。

In the investigation of micromagnetism, in-plane magnetoresistance and in-field magnetic force microscopy on a series of permalloy planar wires were performed. Here, the wire length and thickness are kept constant, 20μm and 30nm, respectively. The width of the wire spans from 10 to 0.1μm. The magneto-transport behavior and magnetic configuration are quite different regarding their widths, corresponding to the aspect ratio.

在研究微磁学时，我们以平行膜面磁阻的量测和施加磁场下观察磁区的磁力显微来从事一系列镍铁合金毫微米线的磁矩翻转研究，这一系列毫微米线的线长和厚度分别固定为20微米和30奈米，线宽则由10微米变化至0.1微米，线宽的改变将造成磁电传输行为和磁区结构有截然不同的结果。

The result of the calculation indicates that there are a rather sectional rigidities of arch rib , cross beam and radio of width-long ,the dead load of arch will much bigger than the vehicle load and wind load in operation, and the in-plane stability will larger than the out-plane stability and the in-plane stability is the main factor controlling of design.

通过有限元理论计算结果表明，当采用截面刚度较大的拱肋、风撑以及较大的宽跨比时，拱桥结构的自重将远远大于运营时的车辆荷载和风荷载，拱桥面外稳定高于面内稳定，拱桥的面内稳定将控制设计。

The smaller ones are ca 70 nm wide and join the tectum and the larger columellae. These larger ones appear to be composed of several 70 nm in width rods. They join the distal surface of the foot layer. The proximal surface of the foot layer is marked by a white line (referred to as a junction plane) where it joins the endexine.

柱层中有种大小同的柱体，较小的宽约70 nm接盖顶层和较大的柱体，而较大的柱体是由多个宽70 nm的棒物所组成的，它们会和基层末端相，而基层顶端表面有著明显分布的白线特徵，就好像是它与外壁内层的接合面。

Seed cones borne in groups of 1-6, globose or subglobose, 0.9-1.6(-2.5)× 1-2(-2.5) cm; cone scales 20-30, proximal 2 margins often convex in outline, or all 4 margins ± concave in outline, middle part with or without distinct shoulders at widest point, apex usually recurved, umbo rhombic, distally with 4 or 5(-7) toothlike projections 1-3.5 mm. Seeds 2-5 per cone scale, brown or dark brown, irregularly ellipsoid or multiangular and ± compressed, 4-6.5 × 2-3.5 mm; wings 0.2-0.25 mm wide.

1-6个中的成群忍受的球果，球状或近球状， 0.9-1.6(-2.5)* 1-2(-2.5)厘米；珠鳞20-30，轮廓的下部的2个边缘通常凸面，轮廓的或全部4个边缘多少凹面，有或没有在宽点的离生的肩的中部，先端通常下弯，鳞脐，上部每珠鳞具4或5(-7)种子2-5 1-3.5毫米的齿状预测， 4-6.5 * 2-3.5 毫米；翅0.2-0.25毫米宽。

3M of farmland bizygomatic breadth is controlled, farmland is tall 15 ～ 20cm, farmland channel is wide 30 ～ 50cm.

畦面宽1.3m左右，畦高15～20cm，畦沟宽30～50cm。

In the generation of a face gear by a shaper, there is the possibility of undercutting in the dedendum area of inner diameter and the pointing of the teeth in the addendun area of outer diameter.

在面齿轮的加工中，面齿轮在内径处易产生根切，而在外径处易产生齿顶变尖现象，因此面齿轮的齿宽受到了限制。

Using two-flank-staining method, inspect the tooth flanks of the driven bevel gear, 3 to 4 equispaced spots along the circumference, at each spot apply color to 2 to 3 teeth, the correct meshing print requirements are: print width in the direction of face width not less than 50% to 60% of the facewidth , and that in the direction of tooth depth not less than 40% to 50% of the tooth depth.

用两面着色法，在从动锥齿轮的齿面检查，沿圆周均布3-4处，每处2-3齿涂色，正确啮合印迹要求为：在齿宽方向的印痕宽度不小于齿宽的50%---60%，在齿高方向的印痕宽度不小于齿高的40%---50%。

System cake: The well-fermented dough on the case, the roll into the surface film, the sesame oil, pastry or meat stalls in the surface film, the roll into a roll, cut into 50 cm wide, 30 cm face block; to face block bag into a circular stained with sesame seeds, and then one by one along the border, so that around the tilt, in the middle low surface level, into a circle around the pot-shaped tilt.

制饼：将发酵好的面团放在案上，擀成面片，把香油、油酥或肉馅摊在面片上，卷成卷，切成长50厘米、宽30厘米的面块；把面块包成圆形沾上芝麻，再逐个沿边，使四周翘起，中间低面平，成周边翘起的圆盆子状。

I am accused of being overreligious," she said in her quiet, frank manner,"but that does not prevent me thinking the children very cruel who obstinately commit such suicide.""

客人们在卡罗利娜·埃凯家里，举止就文雅一些，因为卡罗利娜的母亲治家很严厉。

Designed by French fashion house Herm è s, this elegant uniform was manufactured in our home, Hong Kong, and was the first without a hat.

由著名品牌 Herm è s 设计，这件高贵的制服是香港本土制造，是我们第一套不配帽子的制服。