宽度

And this from a Battalion Commander: The average frontage assigned to an Infantry battalion in Korea was between 4000 and 5000 yards.

一位营长也作了如下评论：在朝鲜，我军一个步兵营负责的平均正面宽度为4000到5000码。

An Nd:YAG Q-switched laser operating at a wavelength of 266 nm, a pulse duration less than 10 ns, and a repetition rate of 10 Hz, was used to ablate a ZnO target of 99.9% purity.

所使用的光源为Nd：YAG Q-switched雷射，其波长为266 nm、脉冲宽度小於10 ns、重覆频率10 Hz；使用的靶材为纯度99.9％的氧化锌。

The belt widths must be between 44 and 76 millimetres and between 50 and 76 millimetres, depending on the most comfortable setting for the driver.

安全带的宽度必须在44到76毫米之间，以及50到76毫米之间，具体宽度根据车手感觉最舒适的位置来确定。

First thought is to want to look for a function, appoint the width of the picture and height directly, geometric ratio exemple cuts, the result was not found, can use calculative earth method only, again conveniently used Transform function, after having Crop, need not pass into width and height, feel they are a bit redundant.

最初的想法是想找一个函数，直接指定图片的宽度和高度，等比例剪切的，结果没有找到，只能使用计算的土办法，再随手使用了transform函数，有了crop以后，就不用传入宽度和高度了，感觉他们有点多余了。

You can easily control the height and width of the iframe, as you already know the div height and width.

您可以轻松地控制高度和宽度，你已经知道的div高度和宽度。

Light grade - paper backed vinyls, wide width and narrow width, to all surfaces except old painted surfaces.

轻度- 裱糊支持的乙烯基，宽宽度和狭窄的宽度，对所有表面除了旧涂面的表面。

In chapter 2 and 3, experimentally, using the Angular-Resolved high-resolution fast Electron Energy Loss Spectrometer , at the condition of 2. 5 keV incident energy and 50-60 meV energy resolution, we measured the Optical Oscillator Strength Density Spectra for the excitations of 4p, 4s or 3d electron. The oscillator strengths for excitations of the valent shell 4p electron were obtained, and comparisons were done between presently experimental and previously experimental and theoretical results. The experimental results of different groups agree with each other approximately, but the semi-experientially theoretical results do not match with the experimental results. The delayed maximum in the photoabsorption spectra was discussed. It should arise from the transition of 4p→∈d. For the excitation of the inner-valent 4s electron, the discrepancies for the resonant structures in previous electron-impact results and photoionization results were clarified in present work, which confirms again that the fast electron impact method is suitable to measure the optical oscillator strengths. The autoionization Rydberg series 4s〓ns (n=5, 6, 7) and 4s〓nd (n=4, 5, 6, 7) were identified without ambiguity by the measurement at 0°, 2° and 4°scattering angles. The energy levels and natural widths of the excitations of Kr3d and Ar2p inner shell, including optically allowed and forbidden transitions, were determined. The widths of these inner shell excitations are nearly the same, which was interpreted by the Resonant Auger effect .

在第二章和第三章，实验上，使用角分辨的高能量分辨快电子能量损失谱仪，在2.5keV电子入射能量和50-60meV能量分辨下，测量了Kr原子由价壳层4p到内价壳层4s，再到内壳层3d电子激发的光学振子强度密度谱；得到了价壳层4p电子激发束缚态的光学振子强度，与前人实验和半经验理论结果作了细致的比较，说明几家实验是比较符合的，但半经验的理论计算存在问题；分析了光吸收谱中的延迟极大现象，说明在第一电离阈值以上几个eV范围内的极大值源于4p→εd跃迁产生的延迟极大；对于内价壳层4s激发的自电离区，澄清了前人实验中电子碰撞方法和光学方法在共振结构上存在差异的问题，再一次肯定了快电子碰撞方法是获得绝对光学振子强度的一种好方法；通过在非0°散射角的测量（如2°和4°），清楚地标识了4s电子激发的光学禁戒跃迁自电离里德堡系列4s〓ns（n=5，6，7）和4s〓nd（n=4，5，6，7）；通过在0°和4°散射角的测量，观测并标识了几个新的内壳层光学禁戒跃迁能级，得到了Kr原子3d和Ar原子2p内壳层激发态（包括光学允许和禁戒跃迁形成的）的能级位置和自然宽度，用共振俄歇效应解释了这些内壳层激发态（不管是光学允许还是禁戒跃迁产生的）的自然宽度彼此比较接近的原因。

For an aluminum plasma at a temperature of 40eV and a density of 0.0135 g/cm〓, the widths of the K-shell 1s-2p excited autoionization states of aluminum ions are larger than the widths caused by the Doppler and Stark broadening. Therefore, the autoionization resonance broadening is one of the main broadening mechanisms of spectral lines.

研究表明，对温度为40 eV，密度为0.0135g/cm〓的铝等离子体，1s-2p内壳层激发态的自电离共振宽度往往超过由Doppler展宽效应引起的宽度，因而前者是主要的谱线展宽机制之一。

Its width is varied, from more than 2,000 kilometers (1,250 mi) in the north and less than 220 kilometers (137 mi) at the Isthmus of Tehuantepec in the south.

墨西哥位在北美大陆的西南方，从北到南绵延3000公里。宽度则有所不同，北边宽度超过2000公里，南边到特万特佩克地峡则有220公里。

New box design with durable 0.5 inch (13 mm) paving skin Vertically-adjusting mold mount for precise leveling of mold to machine Telescoping end sections with 12 inches (305 mm) of width variation on each side are available Standard paving depth is zero to 24 inches (610 mm)Edge slump adjustment Hydraulic Vertical Hinged Sideplates, self-contained inside the mold for track clearance Split, pressure-compensated sideplates Folding side plate wings for transporting without removing Pivoting mold mounting beam to eliminate stress points Self-supported TA is hydraulically driven with 3.5 inch (89 mm) ACME screws for up to a six inch (152 mm) crown Front and rear top T-bar on mold for attaching accessories and structural integrity Inserts are bolted together with front and rear alignment pins for easy mold assembly New vibrator mounting tube attaches to T-bar on mold – Vertical vibrator lift – Rear lubrication system with grease zerks accessible from the work bridge New strike-off – Mounted on paver frame T-rail, independent of the mold – New modular design with wedge lock system for ease in changing widths – 10 inches (254 mm) of hydraulic height adjustment – Hydraulic crown adjustment Spreader plow mounted to paver frame T-rail, optional auger available Tamper bar optional

与耐久性的新的箱子设计铺精密水准测量的0.5英寸(13 mm)皮肤垂直调整的模子登上模子用机器制造挤撞与12英寸(305 mm)的末端部分在每边的宽度变异是可利用的标准铺的深度是零对24英寸(610 mm)边缘暴跌调整水力垂直的取决于的Sideplates，独立性在轨道清除分裂的模子里面，折叠运输的pressure-compensated sideplates旁边板材翼没有去除在轴上旋转的模子架置射线消灭重音点Self-supported TA水力驾驶与3.5英寸(89 mm)由六英寸(152 mm)冠决定的尖端螺丝在前后冠上在模子的T酒吧附有的辅助部件并且结构正直插入物与容易的模子汇编新的振荡器架置管随员T酒吧的定位销一起在前后被闩上在模子–垂直的振荡器推力与油膏zerks的–后方润滑系统容易接近从新工作的桥梁触击–在摊铺机框架足迹，模子的独立登上了与楔子锁系统的–新的模块设计在改变的宽度的舒适的– 10英寸(254 mm)水力高低调整–水力冠调整分布器犁登上了对摊铺机框架足迹，任意任意木钻可利用的堵塞器的酒吧

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。