实验研究

DATA EXTRACTION: Forty-eight articles on experimental study relating to embryonic scarless healing were collected in all. Sixteen experiments accorded with the inclusive criterion and 32 were excluded.

资料提炼：共收集到48篇与胚胎无瘢痕愈合相关的实验研究，16个实验符合纳入标准，排除32篇。

In this paper, the mechanism research of lime dry hydration was studied using small equipment. Then the effect tendencies of operational parameter of hydration process(water/solid) on lime slaking rate、 particle size and specific surface was put forward.

本文利用小型机理实验装置进行了石灰干式消化机理实验研究，得出了消化工艺操作参数对生石灰的转化率、消化产物的粒径和比表面积的影响趋势。

An experiment on forming of cross-hatch on the ablation material surface has been done under the condition of Mach 5 and tur-bulent boundary layer regime.Artifitial disturbances created by randomly setting several pins along a line perpendiculer to the flow direction have shown stochastical character of local cross-hatch and independence of global orderly structure,therefore the pattern appeared fractal behavior.

在外流M＝5湍流边界层状态下，模型为170×300mm￣2蜂蜡平板上进行了烧蚀花纹图案生成的实验研究，通过实验证明了人工安置干扰源并不影响烧蚀材料表面花纹的有序结构，对大面积烧蚀花纹的分析表明，局部花纹结构具有随机性质，因此烧蚀花纹具有分形结构的特性，用分形方法可以大致模拟花纹生成图案。

Intention: The study will find the condition of extraction to crude fish oil in optimization temperature with the materials of subiculum of carps,using the influence of temperature in the experiment as extaraction in the way of kalium.

目的：实验研究的是以鲤鱼的下脚料为原料，利用钾法提取粗鱼油时反应温度对实验的影响，找出提取粗鱼油的最佳温度条件。

Methods: With priming experiment under tachistoscopic visual half-field technique, fourty-eightsubjects performed the lexical decision task.

采用半视野速示技术下的启动实验范式，对南京几所高校的48名英语专业硕士研究生进行实验研究。

From these experiments, it was confirmed that catalytic reductive dechlorination by zero-valent iron was a valid method to reduce the chloroform and tetrachloromethane in the wastewater from the chlorinated compound industry. The experiments results as above would been validated with the industrialisation Equipment.

实验结果表明，铁催化还原法可以有效的去除甲烷氯化物生产废水中的氯仿、四氯化碳；实验研究结果在中试工程中得到验证。

Using titanyl sulfate as the TiO_2 source,the experiments for synthesizing TiO_2 nanoparticles were carried out by detonating the mixed explosives composed of the TiO_2 precursor,ammonium nitrate(NH_4NO_3)and cyclortrimethylenetrinitramine,the structures and properties of the as-prepared TiO_2 nanoparticles were also characterized, meanwhile in combination with detonation theory and experimental measurement,detonation parameters,such as detonation heat,detonation temperature were calculated,and detonation velocity was also measured.

以硫酸氧钛为钛源，引爆由氧化钛前驱体、硝酸铵和黑索金组成的混合炸药，进行爆轰合成氧化钛纳米粉的实验研究，对纳米氧化钛的结构和性质进行表征；结合爆轰理论计算和实验测量得到爆热、爆温和爆速等爆轰参数。

The influence of thickness d of ZnO varistors on the residual voltage ratio K \-r has been experimentally studied.It is showed that K \-r also has dimensioned effect. The results show that there is a residual voltage ratio K \-r decreases propor tonally with E \- 1mA ,and increase μ as grain mean size.

实验研究了厚度d 对ZnO压敏电阻片残压比Kr 的影响规律，表明残压比同样存在几何效应；实验还表明残压比Kr 随电位梯度E1m A成反比例下降，随平均晶粒尺寸μ的增大而增大；找到了一个综合微观结构参数平均晶粒尺寸μ和晶粒尺寸方差σ2 的乘积（σ2μ），能较好地反映电性能与微观结构参数的关系。

With respect to the experimental research on the unsteady flow fields of oscillating cascades, a two-dimensional oscillating cascade test rig is constructed, in which the blades can vibrate torsionally around their midchord at frequencies up to 18Hz.

在振荡叶栅非定常流动的实验研究方面，本文建设了二维低速振荡叶栅实验台，叶片可绕弦中点作扭转振动，振动频率最高可达18Hz，采用压力传感器测量叶片表面的非定常压力。

This paper presents the experiment research for unchamfered peg in hole assembly task based on the principle of ARCC, introduces the structure of the experiment system, the close loop stiffness of the ARCC system and the element setting of the decoupling force feedback matrix.

本文根据ARCC的工作原理，对机器人的无倒角插轴入孔装配作业进行了实验研究，介绍了实验系统的组成，ARCC系统闭环刚度和去耦力反馈矩阵的设置。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐