实验法

Finally,the calculated result is compared with experimental result and result obtained with finite element method.

最后 ，将公式的计算结果、实验结果和有限元法的计算结果进行比较，得出几点结论。

The reliability of this method has been proved by comparison between the results of model test and finite element analysis model.

通过模型实验结果与有限元分析结果的对比，验证有限元法的可靠性。

Second order incident boundary condition on fixed incident boundary is derived for numerical simulations, based on the cnoidal or sinusoidal motions of wave maker paddle, which shows that the prediction with second order incident boundary condition is more accurate than the prediction with first order incident boundary condition. 2 The analytical solution for higher-order Boussinesq equations is derived and its applicable range is discussed. 3 A 2-D fully non-linear numerical model using boundary element method is developed to obtain wave forces acting on rectangular obstacle. 4 The three-dimensional fully non-linear waves are studied in a numerical wave tank using finite element method.The studies on the coupled numerical model combined Boussinesq equations with Laplace equation are following.

非耦合非线性波浪计算模型：1 根据造波板做椭圆余弦运动或正弦运动速度，推导出数值模拟波浪水槽时固定入射边界上的二阶波浪入射边界条件，数值计算结果和实验结果的对比表明采用二阶入射边界条件对波面升高的预报比采用一阶入射边界条件对波面升高的预报更为精确；2 推导了波浪水槽造波板做正弦运动所产生波浪的高阶Boussinesq方程摄动展开解析解，讨论了该解析解的适用范围；3 对整个波浪水槽应用边界元方法数值模拟了波浪对物体的非线性作用；4 用有限元法求解三维Laplace方程模拟了三维完全非线性波浪水槽。

The essence of water absorbing is explained from the thermodynamics. Some phenomena in experiments are explained by Flory equation.

广西大学硕士论文《辐照法淀粉接枝合成高吸水性树脂》}本文还对高吸水性树脂的吸水机理进行了讨论，从热力学角度解释了吸水本质，通过「lory公式解释了实验中的一些现象。

In the wet-process phosphoric acid production from the Hubei phosphate ore, one of the bothersome problems is that potassium fluosilicate and sodium fluosilicate scales are liable to form on the filtration system owing to its high potassium and sodium content, which greatly restrains the application of Hubei phosphate ore.

本文首先采用人工冷却系统模拟湿法磷酸生产的真空过滤系统冷却过程，研究垢物的析出规律，实验结果得知：垢物的主要成分为氟硅酸钠和氟硅酸钾，氟硅酸钠首先析出，结构致密，其次是氟硅酸钾，最后是二水硫酸钙，氟硅酸钠对氟硅酸钾有很强的结晶诱导作用；然后在三种生产中常用的不同的材质钼二钛、聚氯乙烯和聚四氟乙烯表面进行结垢试验，发现聚四氟乙烯表面最不易结垢，而在钼二钛表面最易结垢。

Methods The BHD vector and the small interfer RNA targeting BHD was constructed and transfected into the cell line A549. The expression of BHD was examined by immunofluorescence. Transwell test was used to detect the invasion ability of A549 cells. Results After transfected BHD vector into A549 cells, immunofluorescence showed the expression of Folliculin located in cellular plasma.

制备BHD真核表达质粒，转染肺腺癌细胞，用免疫荧光法检测Folliculin蛋白在肺癌细胞中的表达位置；筛选sRNAi片段，选取有效抑制片段转入肺癌细胞，与转入BHD质粒的肺癌细胞对比，用Transwell实验了解BHD基因对肺癌细胞运动方面的影响。

Simulation results prove that,compared to the zero forcing method,the proposed method achieves 9 dB gains under 10-4 of average bit error rate and similar simulation conditions.

仿真实验表明，所提出的方法与迫零法相比，在相同的仿真条件下，在平均误比特率为10-4时可以获得约9 dB的性能增益。

The results show that, both normal and tangential blowing are effective means of flow control, the influence of blowing on the cone-cylinder is strongest, followed by the influence of blowing on the elliptic forebody and on chine forebody.

实验表明，法向吹气和喷管切向吹气都是有效的控制手段，吹气对其中圆锥截面模型的影响最大，椭圆截面模型次之，对带棱截面模型影响最小。

This experiment, the extract from fresh seaweed polysaccharide formulation flooding thermal pre-treatment of water and alcohol kelp, iodine after extraction of the waste material to fucose sulfate polysaccharide extraction, and anthrone-sulfuric acid method with its total glucose.

本实验，采用从鲜海带中提取多糖的热水浸提法对海带预处理水和醇、碘提取后的废弃料进行岩藻多糖硫酸酯的提取，并用硫酸蒽酮法测定其总含糖量。

Plasma technology the main body of a book has been studied mainly--The corona discharging follows process and law handling fugacity organic experiment , also is the form to the reactor having assumed the research going a step further.

本文主要研究了等离子体技术——电晕放电法处理挥发性有机物的实验过程和规律，更是对反应器的形式作了进一步的研究。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。