实验法

In the respect of data interpretation proceeding, the paper carried out the inversion calculation of experiment data with the resistivity CT method, gave some study on the image effect when the iron bodies were placed flatly close to water level under semi-space condition and were placed flatly, vertically or aslope to the water level under whole-space condition.

在资料解释处理方面，本文采用了电阻率CT法对实验数据进行反演计算，研究了半空间和全空间条件下铁块水平、垂直和倾斜放置时的成像效果，由效果图可以看出，通过电阻率CT法反演出的铁块的位置与水槽模拟实验中铁块的实际位置吻合的较好。

This thesis consists of two parts. The first one was that boundary value problem was discrete with five point difference method. Three kinds of memory formats were studied, which were full matrix, half band width and row compress sparse. Full matrix memory format and half band width memory format first was contrasted. The results show that half band width has efficiency in space. Then the algebraic system of finite element method was solved by Gauss-Seidel iteration method to popular row compress sparse memory format.

本论文由两部分组成，第1部分针对边值问题，用5点差分格式进行离散，并对离散矩阵这类大型稀疏矩阵，研究了系数矩阵的3种存储格式的优劣，即：满矩阵存储格式、半带宽存储格式和按行压缩稀疏存储格式，首先我们将满矩阵存储方式和半带宽存储格式进行了对比，迭代法的数值实验表明：利用半带宽存储的矩阵在空间运算方面具有高效性；然后针对目前数值实验中流行的按行压缩稀疏存储格式，实现了有限元离散代数系统的迭代法的求解。

In order to reduce error of experimental data treatment, to strengthen accuracy of the result in conductivity determination of the dissociation constant of acetic acid, and also to further synthesis of experiment for training students' ability to treat data and to graph with computer, both Excel and calculator with statistical function have been utilized to perform a linear regression analysis of temperature-limiting molal conductivity of acetic acid solution.

为了减少实验数据处理的误差，提高结果的准确性；也为了进一步加强实验的综合性，培养和提高学生应用计算机处理实验数据和作图的能力，本文在电导法测定醋酸解离常数的实验中分别采用Excel电子表格和具有统计功能的计算器对醋酸溶液的温度和极限摩尔电导率数据进行线性回归分析，得到一元线性回归方程和相关系数，进而确定实验温度下醋酸溶液的极限摩尔电导率。

Combining the experimental results and theoretical analysis, the following work has been accomplished.(1) Reasons of the decrease of interelectrode capacitance and the increase of discharge gap caused by the powder suspended in dielectric fluid are explained. And the mechanism that surface quality of workpiece improved by powder-mixed EDM is analyzed from this viewpoint.(2) The variation regularity of the percentage of silicon on the machined surface of workpiece has been summarized according to the experiment results when silicon powder was added into the working fluid. The entropy is introduced to explain the reasons for this variation regularity by thermodynamics.(3) The dimensional accuracy is greatly influenced by the overcut resulting from discharge gap and electrode wear in practice application. Empirical formulas for the overcut in EDM and powder-mixed EDM are established based on the experimental results using the ternary linear regressive method in this paper.(4) The influence of main factors on the machined surface characteristics has been evaluated based on the orthogonal experimental design method.

通过一系列普通电火花加工与混粉电火花加工的对比实验，运用工艺实验和理论分析相结合的方法，重点做了以下工作：(1)探讨了粉末颗粒导致极间电容减小、放电间隙增大的原因，并从这个角度解释了混粉电火花加工可以改善工件表面质量的机理；(2)以混合硅粉的电火花加工为例，实验得出峰值电流和脉冲宽度对加工表面层成分中硅元素含量的影响规律，并引入熵的概念从热力学的角度对硅元素含量变化的原因寻找了理论依据；(3)在实际加工中，由于粉末的加入使放电间隙变大，这使得混粉电火花加工的尺寸精度难以控制，本文利用三元线性回归的方法，在实验数据的基础上，建立了两种电火花加工过切量的计算公式；(4)将正交试验法应用于混粉电火花加工实验研究，并通过对实验指标极差的直观分析，得出各电参数对加工指标影响的敏感程度。

The main research methods are:(1)Theory analysis:from the 2D plane geometry analysis, dots continuity characteristics are found. The first time irrational fraction algorithm is used in FM program.(2)Experiments reaearch:experiments of condition halftone function are designed under the cross-experiment principles. The first time variable information printer and C# language are used in experiment.(3)Data processing:new type digital density apparatus is used to measure data. Compare is used in processing data and error cause are explained. The main works as follows:The dot area percentage has been gained and new condition halftone function has been set up.(2)After being corrected, speed of irrational fraction algorithm has been compared with multiplicative congruence algorithm's.

本文的主要研究方法有：(1)理论分析：运用数字加网原理，从二维平面几何分析入手，借助实验验证研究网点连续特性；首次系统地把无理数取尾法随机数生成器引入到调频加网系统中，根据实验修正生成器的模型，运用统计假设检验理论，对生成的随机数序列进行统计假设检验；(2)实验研究：根据正交实验法则设计实验，首次采用可变信息印刷机(HP Laser PS印刷机)输出实验样张，克服了用传统胶印机作实验影响因素多的缺陷；采用新型数字式密度仪测量密度值，提高了数据精度；采用最新编程语言编写调频加网程序；(3)数据处理与分析：利用平均值比较法处理数据，对误差产生的原因进行讨论。

In the end, an example was used to demonstrate. Results indicate that Gauss-Seidel method and SOR method are move valid than Jacobi method, and SOR method is the best one.

最后，作为演示我们将迭代法，迭代法和迭代法用一个例题进行了比较，数值实验表明，迭代法和迭代法比迭代法更有效，而超松弛迭代法更优。

Methods The compound preparation was administered intragastrically in mice, whose spontaneous activity was observed along with their tolerance of the preparation after long-term administration. The hypnotic effect of the compound was assessed by investigating the changes in the pentobarbital sodium-induced sleeping. The compound was tested for its antiseizure effect in mice with pentetrazole-induced clonic and tonic convulsion. Diazepam was used as the standard control in all experiments.

利用光电计数法观察灌胃给予复方酸枣仁油栀子油对小鼠自发活动的影响，以及长期使用药物对小鼠耐受性的影响；利用延长戊巴比妥钠睡眠时间实验和戊巴比妥钠阈下催眠剂量实验，观察复方酸枣仁油栀子油的催眠作用；利用戊四氮诱发小鼠阵挛性、强直性惊厥观察复方酸枣仁油栀子油的抗惊厥作用；本实验用地西泮进行平行对照实验，并进行了组方设计和实验。

Methods:(1) Dissoluble PGN and CpG DNA were immobilized onto the surface of biotin cuvette for establishing target. Another effective tracking approach was established by immobilizing Escherichia lipid A F583 onto the surface of Non-derivatised cuvett. The biosensor technology was applied to screen anti-inflammatory TCM targeting on three key molecules.(2) The active compositions were isolated by AB-8 macroreticular resin from lycium bark. After the activities of compositions were evaluated, the most effective compositions was confirmed. In vitro, the affinities of different concentrations composition E binding with PGN, CpG DNA and lipid A were measured separately. The effect of composition E on vigor of RAW264.7 cells were tested by MTT and CCK-8, and its inhibition on TNF-α, which was released from RAW264.7 cells induced by PGN, CpG DNA and LPS, was also tested by ELISA. In vivo, murine sepsis models were made by intravenously heat-killed E.coli and heat-killed S.aureus, then protection of composition E on mice sepsis model were observed.

(1)将PGN及CpG DNA包被于生物素样品池，将lipid A包被于非衍生样品池，分别建立以PGN、CpG DNA及lipid A为靶点的技术平台，对114种抗炎中药水提物进行筛选、评价其活性物质含量，并评估出针对上述三种病原分子均具有较高结合活性的中药；(2)利用生物传感器跟踪检测技术、大孔吸附树脂分离技术，从地骨皮中定向分离与PGN、CpG DNA及lipid A均具有较高亲和力的活性组分；在体外实验中，测定不同浓度活性组分与PGN、CpG DNA及lipid A亲和力；MTT法及CCK-8法检测活性组分对RAW264.7细胞活力的影响；ELISA法检测活性组分对PGN(2μg/ml)、CpG DNA(10μg/ml)及LPS(100ng/ml)刺激小鼠RAW264.7细胞分泌TNF-α的抑制作用；在体内实验中，采用尾静脉注射致死剂量热灭活大肠杆菌和热灭活金黄色葡萄球菌，建立细菌脓毒症小鼠模型，观察活性组分对脓毒症模型小鼠的保护作用。

Wistar rats were randomly divided into normal group, sham-operation group, 4 weeks diabetes mellitus model group (M4), 6 weeks diabetes mellitus model group (M6) and 8 weeks diabetes mellitus model group (M8). Behaviour was tested with Morris water maze and shuttle box test.

穿梭箱实验、Morris水迷宫实验检测大鼠认知行为学改变，免疫组织化学法、免疫印迹法、RT-PCR和酶联免疫吸附法检测BACE1；ELISA法检测Aβ在糖尿病大鼠脑组织中的表达，用图像分析仪测定吸光度值。

Firstly, the single-phase flow field of a typical NACA cascade was calculated and the predicted pressure coefficient has good agreement with the experimental data.

文中首先采用不同的壁面处理方法（标准壁面函数法和两层区域模型法）计算了一典型NACA叶栅内的单相流场，两种壁面处理方法得到的压力系数与实验数据符合很好，两层区域模型在前缘处的压力系数好于标准壁面函数法，与实验数据更接近。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。