实验法

The effects of some parameters, such as mandrel ball numbers, mandrel extension length, bending angle, lubrication condition of pressure die, relative bending radius and material, on ovalization have been investigated by experimental method, and the effective methods to reduce the ovalization are proposed.

文章采用实验法，研究了芯头个数、芯棒伸出量、弯曲角度、压块润滑状态、相对弯曲半径、材料等因素对截面畸变的影响；并提出了减小截面畸变的有效措施。

Using phenylamine and acetic acid as raw materials,cyclohexane and toluene-p-sulfonic acid as dehydration and catalyst respectively.

以苯胺和冰醋酸为原料，环己烷为脱水剂，对甲苯磺酸为催化剂，采用正交实验法，探讨了乙酰苯胺合成的适宜工艺条件。

Cetyl pyridinium bromide monohydrate is used to exchange the metal irons in the innerlayers of sodium-based bentonite which is used as raw material and the organobentonites are obtained with orthogonal technique by changing the reaction conditions such as reaction time,reaction temperature,pH,the quantity of quaternary ammonium,and the ratio of bentonite to water.

采用正交L16(45)实验法，以Na基膨润土为原料，用溴化十六烷基吡啶为插层剂，与膨润土层间的金属离子进行离子交换，通过改变反应温度、反应时间、pH值、固液比、季铵盐添加量5个因素，得到不同条件下的有机膨润土。

Morphology and grain size of alloys were analysed by SEM. The effect of current density, pH value, organic additives and rare earth samarium on cobalt content were studied, the adhesion of the film were tested by heating.

采用扫描电镜分析了镀层的微观形貌及晶粒尺寸，研究了电流密度、pH等工艺条件以及有机添加剂和稀土钐对镀层中钴含量的影响，采用加热实验法测定了镀层的结合力。

By regression of experimental data, therules of the linkage between these factors, which will provide a theoretical basis for designing BBP with different scales.3 Using thermal analysis technology and dynamic thermogravimetry, the paper studies combustion kinetic characteristics of 3 types of agricultural crops at different rate of temperature rise, and thus, achieved dynamic parameters of these fuels at different rate of temperature, established dynamic model of straw combustion, which reflects the dynamic process in the fast combustion area.4 Characteristics of straw briquette combustion was experimented, focusing on the impact of straw type, temperature, air supply, and density, diameter, and weight of briquette on the combustion speed, and the following conclusions were drawn:(1) combustion of straw briquette fuel is static permeation diffusion combustion;(2) temperature has a larger impact on the speed of straw briquette combustion than air supply; the higher the combustion temperature is, the faster volatilizable component separates out, and the less steady the combustion is;(3) density of briquette fuel has impact on the speed of volatilizable component separation and therefore the combustion speed;(4) increase of diameter and weight of briquette fuel increases the average combustion speed in the initial stage, and that in the later stages is comparatively steady;(5) the proportion of volatilizable component in straw briquette fuel is high, therefore, the temperature control during combustion under the rational ventilation condition is essential to ensure its safe combustion.5 Using the above-mentioned results of experiments and theoretical analysis, and based on thought of hydraulic driven and bi-direction compression, the hydraulic system and compression parts of the HBP BBP are re-designed in terms of industrialization.

利用热分析技术，采用动态热重实验法，对我国的三大农作物秸秆在不同升温速率下的燃烧动力学特性进行了较系统的研究。得到了各原料在不同升温速率下的动力学参数；建立了秸秆燃烧的动力学模型，该模型反映了秸秆迅速燃烧区的动力学过程。 4 对秸秆成型燃料的燃烧特性进行了试验研究。着重研究了秸秆河南农业大学博士学位论文巫的种类、温度、空气供给量、成型燃料密度、直径、质量对成型燃料燃烧速度的影响并得出如下主要结论：①秸秆成型燃料的燃烧方式属于静态渗透式扩散燃烧。②秸秆成型燃料燃烧速度受温度的影响大于通风量燃烧速度的影响：燃烧温度越高，挥发分析出速度越快，燃烧平稳性愈差。③成型燃料密度影响成型燃料挥发分的析出速度，影响燃烧速度。④成型燃料直径和质量的增加，使得燃烧初期的平均燃烧速度增大，中后期的平均燃烧速度相对平稳。⑤秸秆成型燃料含挥发分比例高，因此合理配风下的控温燃烧是保证其完全燃烧的关键。 5运用已取得的试验和理论分析结果，以液压驱动、双向成型为基础，从产业化的角度对HBP型成型机进行了液压系统和成型部件的改进设计；同时采用了二级预压机构，使该成型机的生产率达到 500kg.hd；单位能耗 60kwh。上'左右，磨损件修复周期 300小时左右，基本解决了影响生物质固化技术在国内推广的技术难题。

In this study, we used experimental method primarily,supplemented by qualitative methods.

本研究以实验法为主，辅以定性的研究方法。

The results show that the ultrasonic wire bonding between the CZT contact electrode and the down-lead wire is easier to realize when the CZT wafers are mechanically polished and their contact electrodes are prepared by ion sputter technology.

摘 要：为实现高电阻CdZnTe半导体接触电极与外引线的超声波焊接，采用正交实验法探讨CZT接触电极与引线超声波焊接质量的影响因素及其作用规律。

MethodsThe orthogonal test was adopted to study the eluting effect of MDG with the elution rate as an index, and concentration of eluant, amount, elution velocity as the influence factors.

方法以猫豆胍洗脱率为考察指标，运用正交实验法考察了洗脱液浓度、用量和洗脱速度对洗脱效果的影响。

A realistic four-cylinder with a hydraulic system is used for modeling, and is simulated with neurons in different control algorithm.

用一个4液压缸实际系统作为对象，采用实验法建模，分别用不同的神经元控制算法进行仿真研究。

The glaze formula and conditions of fritting are determined by orthogonal experiment.

通过在釉料中引入银系抗菌剂，采用正交实验法优选出抗菌白色陶质釉面砖的釉料配方及烧成条件。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。