实际速度

The practive effect shows : this kind of hardware implementation method , not only has a simple structure, but alse improved the speed of algorithm greatly . It set a basis for the applic...

实际效果显示，这种硬件实现方法，不仅结构简单，而且大大提高了算法的运算速度，为算法在实时、高速场合的应用打下基础。

The phytotron which was designed for orchard fruit, run well with nice stability, high sensitivity and rapid response speed by practice checking.

1、根据龙眼等木本果树的特点研制了一个智能人工气候室，经过实际运行检验，表明各控件、仪表系统具有稳定性好、灵敏度高、响应速度快等特点。

Based on the model calculation,an FAPP ventilation system was madein Beijing Poultry Breeding Company.Through running test and a series ofphysical and chemical characteristic measurement,the distribution of flowspeed in length,and breadth was given.The average temperatureand rel-ative humidity,the amplitude of T and RH per day of 30 days in winter,and instantaneous T and RH in 24 hours wre measured in FAPP house,com-paring house and outside,the result shew that FAPP ventilation system wassuperior to comparing house.The dust concentration and microrganism con-tent were also measured in the rearing piriod of poultry,the value in FAPPhouse was junior to comparing house.

在模拟结果的基础上，设计了一套FAPP通风系统并在北京市种禽公司原种后备场种雏舍进行了实际运行试验和一系列的理化特性参数的测试，试验给出的正压管道式送风舍纵轴方向及横截面上气流速度的分布规律与模拟结果相吻合；通过对FAPP舍、对照舍及舍外冬季30天的逐日平均温湿度、温湿度振幅以及24小时瞬时温湿度的测试分析，显示了FAPP通风系统在冬季通风中明显优于负压通风系统；在雏鸡全周期的饲养过程中还对舍内粉尘与微生物的含量进行了测试，FAPP舍的值明显低于对照舍，这一结果为FAPP通风系统的推广应用提供了实验依据。

Of actual steps, the steps recorded by the pedometers placed at the front and side of the wrist are not significantly different.

受试者身体右侧平肚脐锁骨中线处和腋前线交点处分别佩带计步器，在跑台上分别以2mph、3mph、4mph、5mph、6mph 5种速度步行800m，记录计步器计数和实际步数，通过间接热量法测试步行代谢情况。

The research result cannot satisfy the need of engineering design.In this paper, according to practical liquid differential equation ,allowing for moving rule and characteristic of moving field of vertical vortex , simplifying N-S equation, I have studied the discipline of condition, velocity and pressure of vertical vortex and analyzed some theory solutions such as plain vortex solution and solution in axial direction.

本文从实际流体运动微分方程出发，结合立轴旋涡运动规律和流场特征，采用对称恒定性假设，简化N—S方程，研究了立轴旋涡的水流流态、速度与压力的分布规律，分析了若干理论解，如平面螺旋流解、轴向流解等。

According to a report in Battery Bimonthly, there is an annual market demand of 40,000—50,000 tons of hydrogen storage alloy powder in the world, and the annual demand of hydrogen storage alloy for common Ni-MH chemical battery in China is around 8,000 tons, however the annual output is less than 5,000 tons. At present, demands of hydrogen alloys for Ni-MH chemical batteries are increasing by over 30% in each year and there is still a big vacuum in the market.

据《电池快讯》报道：全世界每年约需贮氢合金粉40000—50000吨，我国普通镍氢电池用贮氢合金每年需求量约8000吨，国内实际年产量不足5000吨，镍氢电池用贮氢合金目前国内需求量每年以30%以上的速度递增，市场需求缺口很大。

The multi-blade cutting which exceeded two-blade occurred for the reason of matching among parameters of speed of rotation, forward velocity, and numbers of blades, and it could be avoided; different oblique angle would lead to different passing through distance of the blade, and it is equivalent to different blade thickness in cutting; different position of sugarcane to basecutter would influence on the stress of the stubble when being cut.

给出了甘蔗受到多刀切割和重复切割刀数的计算公式，出现多于两刀切割的现象主要是由于刀盘转速、收获机前进速度和刀片数之间的匹配问题，是可以避免的。刀片安装角度影响刀片切入甘蔗所经历的路程，并且相当于改变了实际切入甘蔗的刀片厚度。甘蔗和根切器的相对位置影响根茬与刀片之间的作用力。

Finally, based on the theory of Timoshenko beam, a beam model of this crankshaft is built, which is compared with solid model. The results indicate that this beam model can meet the needs of calculation precision and calculation efficiency. With this beam model, the condition in which real loads are put on the crankshaft is simulated. The displacement curves、velocity curves、acceleration curves of the main journals and the pulley of this crankshaft and torsion vibration curve of the pulley are then gained. With these curves, the dynamic characteristic of the crankshaft is analyzed. The conclusion indicates that this crankshaft has good dynamic characteristic.

最后利用Timoshenko梁理论建立了曲轴的梁单元模型，将此梁单元模型与体单元模型进行了比较，结果表明梁单元模型能够满足精确度和计算效率的要求；利用该梁单元模型，模拟了实际条件下的载荷作用时曲轴的响应，得到了曲轴各主轴颈和皮带轮端的位移、速度、加速度曲线以及皮带轮端的扭转振动曲线，分析了曲轴的动态特性，结论表明该型曲轴具有良好的动态特性。

The currency-used equations for calculating the life of the main bearings on rotary table and swivel take no consideration of all the affecting elements. The author offers thereby new equations that take an overall consideration of the load, rotary speed, lubrication, assembling, working environment, material and surface hadness.

针对现有文献给出的转盘和水龙头主轴承寿命估算公式对多种影响因素考虑不充分，与实际工况有一定出入的问题，推导出全面考虑载荷、速度、润滑、装配、工作环境和材料及表面硬度等多种影响因素，估算转盘和水龙头主轴承寿命的新公式。

According to the actual case, a suit of schemes were brought forward to treat the boundary condition of rate.

结合本文具体实际，提出了一套速度边界条件的处理方案。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。