完成式的

FeSi nanoparticles were synthesized via thermal decomposition of iron pentacarbonyl in the solution of dioctyl ether, stabilizers oleic acid and oleylamine. The TEM images showed that FeSi nanoparticles had cubic shape, but it seemed that the composition was not uniform. According to the EDS results, the Fe:Si ratio of gray-uniform nanopaiticles was almost 1:1, and blacker FeSi nanoparticles contained more Fe atoms. Although FeSi didn't have uniform structure, it still could be proved that the incorporation of Fe and Si existed in a single nanoparticle. All possible structure, lattice, binding, morphology, surface condition would be discussed. These results indicated that perhaps FeSi2 was the main structure of the new products; however, due to incompletely combination and less synthesized time, it might still contain some part of Si and Fe structure. Besides, FeSi nanoparticles preserved the optical properties from Si atoms, but the PL intensity was much lower. The maxima PL peak appeared at 388 nm with the excitation at 300 nm. Their saturation magnetization, remanent magnetization and coercivity were measured by the SQUID, exhibiting their nearly superparamagnetic behavior.

利用热裂解系统可成功将研磨矽奈米粒子及五羰铁结合，制备出铁矽奈米粒子；从穿透式显微镜照片可知其粒子呈现立方体型态，但颜色深浅及组成不均，EDS结果则显示颜色均匀之粒子铁与矽之组成大致为1：1，颜色较深之粒子则含有较高量的铁元素；尽管组成比例并不统一，但单颗粒子同时含有矽与铁两种元素，初步说明铁矽奈米粒子之形成；进行多种结构与表面分析并探讨所有可能之键结、结构及表面元素后，推测铁矽奈米粒子可能以FeSi2之结构形成，并同时包含未重组完成的矽及铁之结构；利用PL分析得知铁矽奈米粒子确实保留矽之放光特性，并在300 nm激发光源下，於波长388 nm处有一最强放光特性峰，但整体发光效益不及研磨矽奈米粒子之结果；最后，利用超导量子干涉磁化仪量测其饱和磁化量、残留磁化量、与矫顽磁力，发现磁滞现象并不明显而几乎呈超顺磁性。

In a previous project implemented by VAI, the sinter-strand length was extended by 18 m to increase the total sinter production.

之前，由VAI完成的工程，带式烧结机的长度已经增大到18米以提高总体烧结产量。

In this research, three groups of students consist of Anglo-Australian, Australian Hong Kong Chinese, and Hong Kong Chinese completed self-report measures of the above variables. Structural equation modeling was employed to test how well the Western fitted in the model.

本论文以三组学生为研究对象，包括香港人、英籍澳洲人和澳籍香港人，根据他们对以上变项所完成的自陈式量度，运用结构方程模型，检视本文建议的模型是否适用於西方研究。

Seller or Seller Authorized Representative issues to Buyer or Buyer Authorized Representative four fully completed signed the Bank Standard Sale and Purchase Contract; Buyer or Buyer Authorized Representative signs and returns two originals to the Seller or Seller Authorized Representative, and the bank endorsed IMFPA Paymaster for all participants to the said transaction.

卖方签署银行版本的买卖合同，四份原件，买方签署两份原件给卖方，并完成佣金协议背书和佣金支付分流，包括所有的与会者，返回一式两份原件给卖方。

Conveyor Belt gradeability have applied to transfer the level of bad circumstances, to be completed for transmission to smooth conveyor and roller conveyor or chain feeder plate.

爬坡式皮带输送机运用于有高低差的输送情况下，可完成连续输送，能平滑的与滚筒输送机或链板输送机接驳。

Also, the grinding action in this case is achieved by the end face of the grinding wheel (Fig.8.1b), contrary to the case of horizontal-spindle machines, where the workpieces ground by the periphery of the grinding wheel.

而且在这种情况下，磨削动作是通过砂轮端面完成的(图 8.1b)，这与通过砂轮周边磨削工件的卧式主轴磨床正好相反。

At present, enterprises continue to follow the path of plant science and technology, and actively organize human and financial resources, the full completion of "large, thin-walled, voltage transformer shell" of the National Torch Program and the "new type of oil-immersed transformer Express aluminum shell body to create" the Jiangsu Provincial Torch Plan.

目前企业继续走科技兴厂之路，积极组织人力财力，全力完成《大型、薄壁、耐压互感器壳体》的国家火炬计划和《新型油浸式互感器铝壳体快速制造》的江苏省火炬计划。

First nymph will get into buds to feed germen by piercing-sucking mouthpart as soon as hatched, which stop flowering and make it becoming galls. From first to 3th nymph complete their development in flower-galls. They have a low death-rate since protection of galls. the 4th nymphs were observed in the end of July at the moment that the period of summer-diapause may begin.

孵化后的初龄若虫即进入未开放的花苞内以刺吸式口器取食子房，致使花苞不能开放而成为虫瘿。1—3龄若虫在花部虫瘿内完成发育，死亡率较低，至7月底发育到4龄若虫时开始夏滞育。

Methods : We gave 0, 1, 2, 3, 4 times low dose total-body irradiation to control group (No. 1 group) and experiment group (No. 2, 3,4,5 group) respectively with γ irradiation .Each dose is 0. 1GY and dose rate is 1.28 cGY/min. The interval of each irradiation is 48 hours . Six hours after every group finished their own total dose , we kill the rats and get their thyme .

采用γ射线分别对对照组(1组)和实验组(2、3、4、5组)给予0、1、2、3、4次低剂量全身照射，单次剂量0.1GY，剂量率为1.28cGY／min，每次照射间隔时间48小时，各组在完成照射总剂量后6小时处死取胸腺，采用双参数直接免疫荧光流式细胞术，检测大鼠低剂量全身照射后胸腺细胞CD4、CD8、CD3~+T细胞的表达情况以及CD4／CD8的变化。

Turbines are equipped with safety devices for pressure,live steam pressure,extraction steam pressure vacuum,axial displacement of rotor,and the monitoring devices for speed,vibration,temperation,pressure etc.

本设计对凝汽式汽轮机调节系统的选用﹑原理进行了研究，选择了电液调节系统，介绍了其工作原理，完成各部件设计，配汽采用喷嘴调节法。调节气阀的启闭由油动机通过横梁﹑两阀杆和杠杆系统进行控制。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。