孔穴

The acoustic analysis results of axial configurative tongue design with aperture or comb shaped can reduce the BPF peak effects. Therefore we can not only receive better sound quality on the experiments, but also get a similar effect in fluent 6.2 simulations.

结果在声场分析方面，应用孔穴或梳状轴向舌端构形确有降低叶片通过频率声压峰值之效果，因此可获得较佳的音质优化程度，同时在fluent 6.2 中所模拟得到与穿孔型舌端有相近的结果趋势，且其出风口质量流率高转速时明显优於标准舌端

Contrary to the feature of the void contents of the cross-section image of wood-based panel,the areas of multiply connected domain in an image are required to be calculated.

针对人造板横切面孔穴含量的微观图像的特点，经常要对一幅图像中多个连通区域的面积进行计算。

It is suggested that during the nucleation and growth process of the ordering of migration of vacancy in the crystal lattice plays an important role.

在有序化成核成长的过程中，我们认为孔穴起主要作用。

The results show that the periodic average yield of acrylonitrile under any forced periodic oscillation of oxygen concentration among this experimental conditions,thus obtained could higher than that under the steady-state condition.

而为完成整个氧化还原循环过程，气相氧分子就必须在不同丙烯吸附中心的再氧化中心上吸附，获得电子，解离后扩散进入催化剂中的阴离子孔穴，如图1所示。从该机理可知，反应气氛中的氧烯比大小对催化剂表面的氧化还原反应过程的循环有重大影响。

In Chapter 4, eight two- and three-dimensional non-interpenetrating open-networks having diverse sizes and shapes have been constructed with a potential tetradendate ligand hexamethylenetetramine and characterized by X-ray single-crystal structural analysis.

第四章描述了包括第一例由 m 4-hmt 配体形成的二维网络结构（配合物20）在内的八种具有各种形状的孔穴或通道的二、三维非穿插网络配合物的构筑与晶体结构。

Moreover, the test results are compared with the empirical correlations of reference literatures to verify the accuracy of present pool boiling experiment. The test results indicate the higher boiling incipience and lower CHF value for a new plain surface at first test run and slightly improvement at last two test runs.

结果显示平滑加热面有极高的沸腾起始过热度及明显的沸腾迟滞现象，而比较沸腾次数的实验发现，由於表面成核孔穴被活化的结果，后续实验的起始过热度明显降低许多，沸腾曲线亦向左偏移，且临界热通量也有些微增加。

The study suggests that the carboxyl of the template is the function group responsible for the formation of complementary interacting site in the polymer P1, and the double hydrogen bonds formed between the carboxyl groups of ferrocenecarboxylic acid and methacrylic acid are the main interactions in the recognition process.

研究还表明，FCA的羧基是在聚合物的孔穴中产生识别位点的功能基，模板分子上的羧基与MAA的羧基形成双重氢键作用是分子识别的主要作用力。

Impedance. The results show that this polymer membrane has rich micropore and its electrochemical stability window reaches 5.5 V.

结果表明：直接挥发溶剂制得的聚合物电解质孔穴丰富，电化学稳定窗口达5.5 V。

If under ideal conditions, one electron-hole pair injected yields one blue photon and the quantum efficiency of the phosphor equals one, the numbers of electron-hole pair must equal to the numbers of white photons. So LW white LED radiation power output has to consume 1.51 W electric powers and the luminous flux efficiency limitation of electrical to optical conversion for the white LED is 197.8lm/W at above condition.

在理想情况下，注入一个电子－孔穴对产生一个蓝光光子，设荧光粉的量子效率为1，因此，注入的电子－孔穴对数亦等于白光光子数，进而计算出白光LED每辐射1W的光功率所需的电功率为1.51W，上述白光LED发光光谱对应的白光LED的电－光转换的理论极限流明效率为197.8lm/W。

The result showed that the luminous flux for LW white LED radiation power output is 298.7 lm and the total photons are 2.7×1018. If under ideal conditions, one electron-hole pair injected yields one blue photon and the quantum efficiency of the phosphor equals one, the numbers of electron-hole pair must equal to the numbers of white photons.

在理想情况下，注入一个电子-孔穴对产生一个蓝光光子，设荧光粉的量子效率为1，因此，注入的电子-孔穴对数亦等于白光光子数，进而计算出白光LED每辐射1 W的光功率所需的电功率为1.51 W，上述白光LED发光光谱对应的白光LED的电-光转换的理论极限流明效率为197.8 lm/W。

The reasons of iron ions content overproof in grade Ⅱ desalting water system,such as variation water quality,contamination of regenerant , operation adjustment of pretreatment system and switching operation of bed were discussed.

对二级脱盐水系统中铁离子含量超标的原因，如来水水质发生波动、再生剂受到污染、预处理系统操作调整、床体运行切换等进行了论述。

You were hired to drum up new business, so go and do it.

公司雇你招徕新业务，你就做你的事好了。