孔径
- 与 孔径 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
At high heat flux, due to the larger pores in the porous structure, the biporous surface really prolongs the critical heat flux to 869 kW/m2, which is about 2.2 and 1.3 times over a smooth and monoporous surface, respectively.
单孔径毛细结构性能提升的原因在於树枝状粉末拥有较广大的热传面积及通道,能够加速薄液膜的蒸发速率。
-
The structural and photocatalytic properties of TiO〓 as well as surface acidity were greatly improved by sulfation. SO〓〓/TiO〓 solid superacid with Hammett constant Ho less than -12.14 was prepared by treating the TiO〓 with 1.0mol. L〓 sulfuric acid solution and then calcining at 450℃ for 3h. When compared to unmodified TiO〓, the SO〓〓/TiO〓 superacid catalyst exhibited higher anatase content, smaller crystal size, higher specific surface area, centralized pore size distribution, and the blue-shifted band edge of uv-vis adsorption spectra. Furthermore, the SO〓〓/TiO〓 superacid also showed excellent reaction activity and stability for CH〓Br photocatalytic decomposition even under the moist reaction conditions. The apparent quantum efficiency of SO〓〓/TiO〓 was 10 times of that of TiO〓 catalyst for the photocatalytic degradation of bromomethane. Therefore, the SO〓〓/TiO〓 superacid catalyst is promising for practical application in environmental remediation.It was found that both L and B acid sites exist on SO〓〓/TiO〓 photocatalyst while only L acid sites on TiO〓 photocatalyst. On the basis of experimental results, the synergistic model of superacidic centers was proposed for SO〓〓/TiO〓 photocatalyst to explain the photocatalytic behavior and the mechanism of superacidifing effects, assuming that the adjacent L and B acid sites induced by SO〓〓 comprise cooperatively the superacidic center on superacid photocatalyst. The group cooperation of the superacidic center could strengthen the surface acidity, increase surface acid sites and the adsorbtion of O〓, promote separation of photogenerated electron-hole pair, enhance the interfacial transfer of charges and reversibility of water adsorption. Consequently the excellent photocatalytic activity, reaction stability and resistibility to humidity of SO〓〓/TiO〓 superacid photocatalyst may attributed to the group cooperated effect of the superacidic center on the photocatalyst.
研究结果表明:SO〓〓与TiO〓表面的结合为螯合式双配位结构;TiO〓光催化剂表面经H〓SO〓浸渍处理后,提高了表面酸性,改善了催化剂结构和光催化性能,当H〓SO〓浸渍浓度为1.0mol.L〓、烧结温度为450℃时,可制得SO〓〓/TiO〓超强酸催化剂(H〓<-12.14),其结构和光催化活性得到明显改善,与TiO〓相比,SO〓〓/TiO〓光催化剂的锐钛矿含量高、晶粒小、BET比表面积大、孔径分布集中、光谱吸收边蓝移,具有优异的光催化氧化活性、稳定性及抗湿性能,光催化降解溴代甲烷的表观量子效率比TiO〓催化剂提高了一个数量级,是一种有实际应用前景的高效光催化剂;由此提出了SO〓〓/TiO〓超强酸催化剂表面集团协同作用的超强酸中心模型,认为在SO〓〓/TiO〓超强酸催化剂表面,由SO〓〓诱导的相邻L酸中心和B酸中心组成了集团协同作用的超强酸中心,其集团协同作用显著地增强了催化剂表面酸性、增大了表面酸量及O〓吸附量、促进了光生电子和空穴的分离及界面电荷转移,具有可逆吸附水的性能,是SO〓〓/TiO〓超强酸催化剂具有优异的光催化氧化活性、很好的活性稳定性及抗湿性能的重要原因。
-
The apparent quantum efficiency of SO〓〓/TiO〓 was 10 times of that of TiO〓 catalyst for the photocatalytic degradation of bromomethane. Therefore, the SO〓〓/TiO〓 superacid catalyst is promising for practical application in environmental remediation.It was found that both L and B acid sites exist on SO〓〓/TiO〓 photocatalyst while only L acid sites on TiO〓 photocatalyst. On the basis of experimental results, the synergistic model of superacidic centers was proposed for SO〓〓/TiO〓 photocatalyst to explain the photocatalytic behavior and the mechanism of superacidifing effects, assuming that the adjacent L and B acid sites induced by SO〓〓 comprise cooperatively the superacidic center on superacid photocatalyst. The group cooperation of the superacidic center could strengthen the surface acidity, increase surface acid sites and the adsorbtion of O〓, promote separation of photogenerated electron-hole pair, enhance the interfacial transfer of charges and reversibility of water adsorption. Consequently the excellent photocatalytic activity, reaction stability and resistibility to humidity of SO〓〓/TiO〓 superacid photocatalyst may attributed to the group cooperated effect of the superacidic center on the photocatalyst.
研究结果表明:SO〓〓与TiO〓表面的结合为螯合式双配位结构;TiO〓光催化剂表面经H〓SO〓浸渍处理后,提高了表面酸性,改善了催化剂结构和光催化性能,当H〓SO〓浸渍浓度为1.0mol.L〓、烧结温度为450℃时,可制得SO〓〓/TiO〓超强酸催化剂(H〓<-12.14),其结构和光催化活性得到明显改善,与TiO〓相比,SO〓〓/TiO〓光催化剂的锐钛矿含量高、晶粒小、BET比表面积大、孔径分布集中、光谱吸收边蓝移,具有优异的光催化氧化活性、稳定性及抗湿性能,光催化降解溴代甲烷的表观量子效率比TiO〓催化剂提高了一个数量级,是一种有实际应用前景的高效光催化剂;由此提出了SO〓〓/TiO〓超强酸催化剂表面集团协同作用的超强酸中心模型,认为在SO〓〓/TiO〓超强酸催化剂表面,由SO〓〓诱导的相邻L酸中心和B酸中心组成了集团协同作用的超强酸中心,其集团协同作用显著地增强了催化剂表面酸性、增大了表面酸量及O〓吸附量、促进了光生电子和空穴的分离及界面电荷转移,具有可逆吸附水的性能,是SO〓〓/TiO〓超强酸催化剂具有优异的光催化氧化活性、很好的活性稳定性及抗湿性能的重要原因。
-
Any of various brightly colored Australasian parrots having a tongue with a brushlike tip that is used to feed on nectar and pollen .
花粉显像密度计的计算结果,可以表明每一平方毫米孔径上吸入的花粉粒数。
-
When the burring process of 12×4J wheel is processed taking the deformation area as the plane stress condition,the deformation characteristics of normal and radius directions are studied,which is influenced by the factors such as height and the inner hole initial radius and the deformation law of circle strain.
利用斜冲模对12×4J轮辐进行翻边时,将变形区看做是平面应力状态,探讨了翻边高度、初始孔径及斜冲模角对翻边变形区径向应变和轴向应变的影响,对12×4J轮辐翻边不同斜冲模角下的冲压力变化规律进行了计算。
-
In this paper, several approximate methods are put forword to calculate the limited burring factor through analyzing stress and strain at the edge of the round-hole in the burring process.
这种极限变形程度可用极限翻边系数来描述,即在翻边过程中,翻边系数(K =d0 /Dm,式中d0 、Dm 分别为板料原始孔径和翻边后竖边中径图 1),不能小于极限翻边系数。目前,在冲压理论中,有关极限翻边系数的理论探讨还很少[1,2 ,3] 。
-
The isolate grew well in R2 liquid medium and could pass through 0.22 μm and 0.45 μm filtrate membranes. The colony was grain-like in solid medium. Through electron microscopy, the isolate YY0801 exhibited helicity during their exponential growth phase. The isolate YY0801 was able to ferment glucose and D-fructose and to catabolize arginine, but did not to hydrolyse urea. The isolate was resistant to ampicillin (2000 U/mL).
分离菌株在R2液体培养基中生长良好,能通过孔径为0.22 μm、0.45 μm的微孔滤膜;在R2固体培养基上呈颗粒状菌落;在对数期呈典型的螺旋状;能利用葡萄糖、D-果糖作为碳源;能强烈代谢精氨酸;不能利用尿素,在含氨苄青霉素钠(2000 U/mL)的R2液体培养基中生长良好。
-
The strong infraction between cellulous and casein exists in the blendmembrane. The membranes with various pore size were successfully prepared bycoagulating the mixture solution of cellulose cuoxam and PEG as pore former.
在膜形成过程,较低分子量的PEG(PEG400,PEG2000)具有较高的扩散速度和碰撞频率而易形成较大的&二次粒子&,导致形成较大的孔尺寸,其孔径约为PEG分子线团直径的二倍。
-
Taken dried Chaenomeles fruit as a raw material,Chaenomeles fermented vinegar was produced by the way of alcohol fermentation and acetic fermentation.
以宣木瓜干为原料,经过酒精发酵和醋酸发酵生产木瓜醋,并采用孔径为0.1μm的无机陶瓷膜对产品进行过滤杀菌。
-
Gold quantum dot arrays were self-assembled inside pore channels of ordered amino-functionalized mesoporous silica thin films, employing the neutralization reaction between chloroauric acid and amino groups.
利用氯金酸与氨基官能团的中和反应,在氨基化有序二氧化硅介孔薄膜中自组装了金量子点阵列。通过改变介孔的孔径在2.3nm至8.3nm间改变,能够控制量子点的尺寸随之变化。
- 推荐网络例句
-
The split between the two groups can hardly be papered over.
这两个团体间的分歧难以掩饰。
-
This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.
这种做法不仅鼓励了更多的反应,而且减少跟风的可能性。
-
The new PS20 solar power tower collected sunlight through mirrors known as "heliostats" to produce steam that is converted into electricity by a turbine in Sanlucar la Mayor, Spain, Wednesday.
聚光:照片上是建在西班牙桑路卡拉马尤城的一座新型PS20塔式太阳能电站。被称为&日光反射装置&的镜子将太阳光反射到主塔,然后用聚集的热量产生蒸汽进而通过涡轮机转化为电力