头的

The assembly method of the invention has the main principles that a semiconductor laser, an optical coupled apparatus and a fiber head are orderly arranged, and the optical axes of the semiconductor laser, the optical coupled apparatus and the fiber head are arranged in a same straight line; the focal plane of an output beam which is focused on the fiber head is changed through utilizing and adjusting an adjusting device which can cause a beam to deviate; the sensitivity of the assembly adjustment of the adjusting device in the course of fixing is reduced.

本发明的方法的主要原理是将半导体激光器、光学耦合器件、光纤头依次排列，并使它们光轴在同一直线上，然后通过利用一使光束发生偏移的调节器件，通过调节该调节改变聚焦于光纤头的输出光束的焦平面，降低调节器件装配调节的固定时的敏感性。

The results show that the flow distribution in plate-fin heat exchangers can be effectively improved by changing the header configuration. It is also found that the effect of header configuration on the flow maldistribution in crosswise direction at the outlet area is greater than that in lengthwise direction.

实验结果表明，通过改变封头的结构，可以有效地改善换热器内部的物流分配；封头结构对物流分配不均匀性的影响主要表现在出口截面的横向方向上，而对纵向方向上的物流分配不均匀性的影响较小。

It is pointed out that the error of indication E0 for the calibrated test length which are measured when the offset length between the ram axis and the stylus tip is zero shall neither exceed the maximum permissible error MPEE0 nor exceed 1/3 of the probe error,that the repeatability of E0 shall neither exceed the maximum permissible error MPE Rnor exceed the repeatability error of the probe,and that if the measuring data is rejected in acceptance and reverification,measurement must be carried at least 5 times at the same position for reducing the possibility of misjudgement.

提出探测轴探针针头零偏置长度的校准测试长度的示值误差E0应不超过最大允许校准测试长度的示值误差MPEE0，且不应超过测头误差的1/3；E0的重复性误差R不应超过最大允许重复性误差MPER，且不应超过测头的重复性误差。建议验收校准测量数据超差剔除后，必须在相应位置重复测量5次以上，以减小误判的可能性。

I had no choice but to stare breath, and after a while, it fears Disturbed by the small head out the reconnaissance to see if there are no enemies around us, only carefully stretch out my head, my hand just want to go to its bumper, timidly it reduced head back, I am fed up, It accidentally dropped it,"snapped" out of its shell was Shuaipo, I hand-pick, at best sticky Yi Mo, Ji Li also hinted at the small things.

我没有别的选择，只能盯着呼吸，经过一段时间，它担心不安小头的侦察，看看有没有我们周围的敌人，只有仔细地伸出我的头，手刚要到它的保险杠，怯生生地降低头部回来，我受够了，它不小心把它丢"终结"了它的外壳是Shuaipo ，我亲自挑选，最好的粘性易模，季李鹏还暗示，小的东西。

It was found that the mechanical properties of the joints decreased by the alclad and it will be increased dramatically by removing the alclad. The effect of alclad on the bottom surface is larger than on the top surface. The mechanical properties of 2024-T3 joints will fall down because alclad is entrapped into the welded joints by the rotating and stirring tools during the friction stir welding, similar with "inclusion" in fusion welding.

研究结果表明，包铝层的存在明显降低了2024-T3铝合金搅拌摩擦焊接头的力学性能；去掉包铝层后接头的性能显著提高；下表面包铝层对接头性能的影响大于上表面包铝层；当2024-T3铝合金表面带有包铝层进行搅拌摩擦焊接时，在搅拌头的旋转和搅拌作用下，包铝层被卷入焊缝中，形成类似于熔焊的&夹杂&，从而使得接头的力学性能下降。

The methods of theory analyses and digital simulation have been used in this thesis and several schemes of strapdown guidance law based on analyzing the performance of several classical guidance laws have also been present according to the characteristics of strapdown Anti-Radiation homing seeker. The stapdown guidance systems were built for a certain Anti-Radiation missile, adopting acceleration autopilot and the attitude autopilot, and the paper has focus on analyzing the performance of low frequency strapdown Anti-Radiation homing seeker. The Approaches of lead correction and dead-zone relay control were given to improve the guidance precision, and also the increasable observability law was attempt and validate.

本文采用理论分析和仿真实验相结合的方法，在对经典制导律进行理论分析和验证的基础上，针对捷联反辐射导引头的特点，提出了捷联制导律多种设计方案，并以某型反辐射导弹为应用背景，分别采用姿态角反馈自动驾驶仪和过载反馈自动驾驶仪构造了捷联制导系统，重点基于反辐射导引头的低频端特性，开展了捷联制导律的导引性能对比分析工作，提出了应用超前校正和带死区继电控制提高制导精度的方法，并对提高可观测性的捷联制导算法的实现思路进行了尝试和验证。

Its head -the head is the part of the animal that better defines and characterizes the breed- well proportioned (6-4), the snout straight, never turned-up, Nasofrontal depression is little noticeable, marked depression cranium-frontal, the skull flat, or hardly convex, thick-lipped gathered, non-hanging, the masseters muscles well developed, bite in scissors, the eyes of medium size and attentive gaze, intelligent as if it was a person.

它的头，头的特点是该品种最好的定义，匀称（6-4枪口）的一部分，鼻子直，没有出现跟进，鼻额几乎没有明显的抑郁症，头颅平或微凸，厚的嘴唇聚集收紧，非挂、大咬肌发达的，剪状刀咬，中等大小和警惕的眼睛凝视，智能，就好像它是一个人。

On the basis of design of a new type bilateral excitation electromagnetic vibrating head, a simplified mathematic model was set up through predigesting electromagnetic field to electromagnetic route method, and motion function of the system was also obtained based on variational theory and non-conservative system Lagrange function.

在设计了一种新型的双边激励的电磁式振动头的基础上，采用将磁场简化为磁路进行分析计算的方法建立振动头的简化数学模型，并根据变分原理及非保守系统拉格朗日方程得出系统的运动方程。

The possiblehost objective reason all is very many, but, our country numericalcontrol engine bed function part development backwardness -- varietyfew, unit technical level low, performance quality insufficientlystable, the cost stays at a high level, the delivery insufficientlywas prompt and so on -- not to be able to satisfy the numericalcontrol engine bed main engine product need to develop, had noalternative but to say was most direct, the most main reason, Becauseall numerical controls engine bed all is by each kind of function part(including host 轴头, straight line rolls guide rail, ball bearingguide screw vice-, numerical control tool rest, knife storehousemanipulator, rotary table, numerical control servosystem, surveyfeedback as well as safe protective equipment and so on), the functionpart which on foundation rack and so on the lathe bed, column thecollection attire becomes is the numerical control engine bedimportant component, moreover is the indispensable part.

可能主客观原因都是很多的，但是，我国数控机床功能部件的发展落后──品种少，单元技术水平低，性能质量不够稳定，成本居高不下，交货不够及时等──满足不了数控机床主机产品发展的需要，不能不说是最直接、最主要的原因，因为所有的数控机床都是由各种功能部件（包括主轴头、直线滚动导轨、滚珠丝杠副、数控刀架、刀库机械手、回转工作台、数控伺服系统、测量反馈以及安全防护装置等）在床身、立柱等基础机架上集装而成的，功能部件是数控机床的重要组成部份，而且是不可或缺的部份。

I had no choice but to stare breath, and after a while, it fears Disturbed by the small head out the reconnaissance to see if there are no enemies around us, only carefully stretch out my head, my hand just want to go to its bumper, timidly it reduced head back, I am fed up, It accidentally dropped it,"snapped" out of its shell was Shuaipo, I hand-pick, at best sticky Yi Mo, Ji Li also hinted at the small things.

我没有别的选择，只能盯着呼吸，经过一段时间，它担心不安小头的侦察，看看有没有我们周围的敌人，只有仔细地伸出我的头，手刚要到它的保险杠，怯生生地降低头部回来，我受够了，它不小心把它丢&终结&了它的外壳是Shuaipo ，我亲自挑选，最好的粘性易模，季李鹏还暗示，小的东西。

Neither the killing of Mr Zarqawi nor any breakthrough on the political front will stop the insurgency and the fratricidal murders in their tracks.

在对危险的南部地区访问时，他斥责什叶派民兵领导人对中央集权的挑衅行为。

In fact,I've got him on the satellite mobile right now.

实际上 我们已接通卫星可视电话了