大部

RESULTS:In vertebral pulp extirpation group, the stress was proved to be the highest at superior edge, posterior middle part, lower edge and anterior middle part of small joints under anteflexion, backward extension, compression, lateroflexion and revolving states, moreover, small joint stress in artificial lumbar intervertebral disk was higher than that in normal intervertebral disk, but obviously lower than that in vertebral pulp extirpation group;however, the small joint of the middle part of artificial lumbar intervertebral disk bore the highest stress under revolving states.

结果：髓核摘除组小关节的上边缘部、后中部、下边缘部和前中部在前屈、后伸、压缩、侧屈、旋转状态应力最大，人工腰椎间盘组的小关节的应力比正常椎间盘高，但明显小于髓核摘除组，但正中部在旋转状态下，人工腰椎间盘小关节的中心部位承受的应力最大。

The largest pressure part is the second metatarsal when jogging, the pressure center in the foot locates in the middle of half sole, and the largest impulse is the second metatarsal, most of the impulse focus on the front end of the first to the third metatarsals of the half sole.

大学生慢跑时，足部最大压强部位在第2跖骨，压力中心在足前掌中部较为密集，足部最大冲量部位在第2跖骨，前掌第1，2，3跖骨前端承担了大部分的冲量。

Finally, we study the structure of the maximum matching graphs and give an algorithm for constructing the maximum matching graphs on bigraphs.

最后深入研究了二部图最大匹配图的结构性质并给出了构造二部图的最大匹配图的一种算法。

Stamens 4, inserted on corolla tube or at base, alternate with petals; filaments filiform or base dilated, free or basally united or adnate to corolla base; anthers ovoid, dorsifixed, 2-locular, back-to-back; connectives often in an apical mucro, dehiscing longitudinally.

雄蕊4，着生于花冠筒或在基部，与花瓣互生；花丝丝状或者基部膨大，离生或基部合生，或与花冠基部贴生；花药卵球形，背着，2室，背靠背；药隔通常在顶端有短尖头，纵向开裂。

The results show that structure curvature is negatively related to coalbed gas content,relative gas emission rate,outburst gas and coal amounts which reflect No15 coalbed of Ji is above the neutral plane of folds.That is,the No15 coalbed of Ji Group is compressed in incline and is tensed in anticline,and the higher structure curvature is,the higher stress is.

结果表明，构造曲率与瓦斯含量、瓦斯相对涌出量、突出瓦斯量、突出煤量呈负相关关系，反映研究区己15煤层位于褶皱中和面以上，即煤层在向斜轴部受挤压而背斜轴部受拉张，正曲率值反映煤层受到拉张应力作用，负曲率值反映煤层受到挤压应力作用，曲率绝对值越大，受力越大。

We shall first review past attempts to answer the question of rural stability and pinpoint some of their shortcomings.

后者的讨论分为四部份，第一部份为新界在建立殖民统治前的情况；第二部份叙述新界殖民地化的经过及至二次大战前的发展；第三部份探讨战后新界在社会经济结构上之重大改变的政治脉络；最后我们以几个个案来验证我们的主要论据。

Bracts 4-8 mm; corolla tube broadly tubular to narrowly funnelform, gradually ampliate from base to mouth, adaxial lip 2-lobed from near base

苞片4-8毫米；对狭漏斗状管状的宽的花冠筒，对嘴的逐渐膨大的自基部，正面的唇从近基部2裂 24 Oreocharis benthamii 大叶石上莲

Corolla yellow, salverform; tube subquadrangular or basally inflated and urn-shaped, base slightly narrowed; lobes longer than tube.

花冠黄(或白色，红色，粉红色，或橙)，；基部的筒部近四棱或膨大和坛状，基部稍狭窄；裂片长于筒部。

If the tectonic uplift is not considered, the relief of Dabie orogen will reach at least 3km in Late-Cretaceous. As to the value of the relief reduction factor in Dabie orogen at 90Ma, the largest value appeared in northeast region, followed consecutively by the core and southeast Tanlu fault zone, with the smalleast value appeared in northwest and southwest region. The results reflect the strong uplift difference between core and North Huaiyang flank in Dabie orogen during doming extension period. Relief in the core region and southeast Tanlu fault zone is higher than those in the peripheral regions, northwest and southwest flanks are more stable than other regions.

如果不考虑构造抬升，大别造山带在晚白垩世地形起伏至少可达3km.90Ma时大别造山带地形起伏变化率在空间上呈现如下特征：东北区块最大，热窿核部其次，东南郯庐断裂区块再次，西北、西南区块最小，反映大别造山带热窿伸展期，核部与北淮阳翼之间强烈差异隆升，核部地形和东南郯庐断裂区块起伏高于周边地区，西北、西南两个翼部比其他地区稳定。

From the point of view of structure,bamboo cell wall ratio,amount of bundle per unit area,fraction of bundle sheath,fraction of vessel increase from the root to the top of the bamboo,while fractionof parenchyma.Single bundle sheath area decreases with the increase of height.Fiber length,fiber width and vessel length increase from the root to the top andget theirs maximum value at the length of 17th node to 23rd node and thendecrease.Fiber length and width ratio slightly decreases while vessel widthincreases with the increase of height.

从构造角度来说，竹材胞壁率、单位面积维管束个数、纤维束比量、输导组织比量从基部到到梢部随着高度增加而增加，而薄壁组织比量、单个维管束纤维束面积随着高度增加而减小；纤维长度、纤维宽度、导管长度从基部到梢部随着高度的增加而增加，在第17竹节到第23竹节达到最大值，而后下降，纤维长宽比随着高度的增加而缓慢下降，导管宽度随着高度增加而一直增加。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。