大轴

He dip angle of the maximum and the minimum press axis are low, intermediate axis is steep, that shows the actuating force is from horizontal direction.

轴和P轴的倾角统计的平均值为20°左右，最大和最小应力主轴产状较缓，中间应力轴产状较陡，区域的构造活动的驱动力来自水平方向。

The richness center of the Theaceae plant species under study is located in the mountainous area of north Guaugdong (22.5°N, and 112~115°E). These plants species exhibited significant longitudinal difference (P=0.0012), and latitudinal variation (P=0.0049). Canonical Correspondence Analysis showed the distribution of plant species could be explained by caloric factors and moisture factors, and MAMI (mean annual minimum temperature) was the key factor determining the distribution pattern of Theaceae plant species richness in the study area.

对125种植物、72个网格和6个环境因子进行典范对应分析表明：CCA排序轴第1轴主要代表温度的变化梯度，第2轴主要代表水分的变化梯度，说明水分、温度等因素共同影响山茶科植物在广东的生长和分布，其中年均最低温度是影响广东省山茶科植物丰富度水平地带性格局的最大因子。

Secondly, in our methods, the essential geometry of the image single axis geometry may be specified by six parameters and this may be estimated from one conic and one fundamental matrix (a total of 12 parameters) or may be minimally estimated from two conics (a total of 10 parameters).

本文证明了单轴旋转运动的不变量可以通过一个基本矩阵和一条二次曲线来确定，在这种情况下，由于基本矩阵的自由度为7，二次曲线的自由度为5，所需确定的参量个数仅为12，大大减少了不变量的计算量；本文同时证明单轴旋转运动的不变量可以通过最少两条二次曲线来确定，在这种情况下所需确定的参量个数仅为10，该方法是目前同类算法中参数最少的；本文提出了用多条二次曲线求解单轴旋转运动的不变量的最大似然估计算法，其所需确定的参量个数为6+2n，其中n为二次曲线的个数，该公式更深刻地反映了二次曲线与不变量的参数关系。

Selection of drum gear coupling tooth gear coupling, gear coupling crown gear axis to allow the two larger angular displacement, load-bearing capacity is relatively strong, and easy to install and adjust.

齿轮联轴器选用鼓形齿齿轮联轴器，鼓形齿齿轮联轴器允许两轴线有较大角位移，相对承载能力较强，并且易于安装调整。

Along with the increase of steel ratio, the deformation ability will be raised, but with the increase of axial compression ratio, the deformation ability will be worse.

结果 得到不同轴压比和不同含骨率下的荷载－位移滞回曲线，含骨率和轴压比对钢骨－钢管混凝土柱有着明显的影响，随着含钢率的增加，构件的变形能力得到了提高，而轴压比越大，构件的变形能力越差。

According to the boundary relations of the electromagnetic field, and based on the phenomena of double refraction and double reflection in crystals, the reflectivity and transmissivity are deduced at boundary when an extraordinary beam is incident from an isotropic medium upon a crystal or from a crystal to an isotropic medium with optical ax.

为分析非常偏振光在晶体表面的能量损耗，给出一种求解反射率和透射率的方法，即根据电磁场的边值关系以及晶体的双折射和双反射现象，求解晶体光轴在入射面内时，非常偏振光从各向同性介质入射到晶体和从晶体出射到各向同性介质两种情况的反射率和透射率的方法，并给出反射率和透射率的解析解，同时得到对于晶体光轴在入射面内的情况，光轴的取向对非常偏振光反射率的大小几乎没有影响，但对产生全反射的临界角θc影响较大的结论。

A U-shaped friction disk A and several centrifugal springs connected to a friction block are installed to the output shaft of engine. Several centrifugal springs connected to another friction block are fixed to another U-shaped friction disk B. Said U-shaped friction disk has a central output shaft with small gear. The small gear, big gear and output chain wheel are installed to drive shaft.

在发动机的输出轴上装有&U&形摩擦盘和分别等分固接有连接摩擦块的数个离心弹簧，另一&U&形摩擦盘外等分固接有连接另一摩擦块的数个离心弹簧，另一&U&形摩擦盘开口朝向发动机内侧、镶嵌在摩擦块&U&形摩擦盘内侧间，另一&U&形摩擦盘外侧中心的输出轴上装有小齿轮；在传动轴装有另一小齿轮、大齿轮和输出链轮，大齿轮与另一&U&形摩擦盘上的小齿轮啮合；脚踩曲柄的轮轴上有与超越离合器相连的另一大齿轮与传动轴的另一小齿轮啮合。

In the oil hub with some wavy-coated layer of rubber, able to adapt to relatively large rotation axis eccentricity (usually only requires about 0.5mm) and axial deviation of the larger size range, there are better axial and the performance of radial buffer.

在油封内毂部份包覆一层波浪状橡胶，能适应旋转轴比较大的偏心度（通常只要求在0.5mm左右）和轴较大范围的尺寸偏差，有较佳的轴向及径向缓冲性能。

Fixed axis wheel system can achieve a large transmission ratio, large-axis pitch, speed or change direction, it is widely used.

定轴轮系可以实现大的传动比、大的轴间距、变速或变向、故应用广泛。

The direction perpendicular to the transverse ridge of the goat condyle has the highest Young's modulus.

山羊髁突在垂直于横轴方向上的弹性模量最大，而在沿横轴方向上的剪切模量最大。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。