大孔

The result of clustering based on quantitative data of vessel elements suggests that the Sonneratia species evolved into two clades, one including S. caseoalris and S. paracaseolaris that has the wider vessel and lower pore density suggesting a high conducting efficiency, the other including S. alba, S. ovata, S. apetala and S. hainanensis that has the narrower vessel and higher pore density resulting in high conducting safety.

导管数量特徵的聚类分析可以推测海桑属植物沿两支进化，一支进化为水分输导效率高的种类（即导管直径宽和输导面积大，管孔密度小，如海桑和拟海桑），另一支进化为水分输导安全性高的种类（即导管直径窄、输导面积小，管孔密度大，如杯萼海桑、卵叶海桑、无瓣海桑、海南海桑）。

The result of clustering based on quantitative data of vessel elements suggests that the Sonneratia species evolved into two clades,one including S. aseoalris and S.paracaseolaris that has the wider vessel and lower pore density sug esting a high conducting eficiency,the other including S.alba,S. ovata,S.apetala and S.hainanensis that has the narrower vessel and higher pore density resulting in high conducting safety.

导管数量特征的聚类分析可以推测海桑属植物沿两支进化，一支进化为水分输导效率高的种类(即导管直径宽和输导面积大，管孔密度小，如海桑和拟海桑)，另一支进化为水分输导安全性高的种类(即导管直径窄、输导面积小，管孔密度大，如杯萼海桑、卵叶海桑、无瓣海桑、海南海桑)。

The research shows that, when fluidized gas is used only, it had little effect on the quantity of returning solids, and that the effect of loosed gas is significant. Horizontal opening has distinct effect on the circulating rate only when the loosed gas is larger; the appropriate horizontal opening is corresponding to the gases quantity. The combining of the arced gas distributor and the gases regulating could eliminate the fluidized dead zone in the U-valve effectively.

结果表明，单一流化风对循环量的影响较小，而松动风对循环量的调节幅度比较大；水平孔口开度只有在松动风量较大时对循环量的影响比较明显，而且合适的水平孔口开度与输送风量的大小相对应；利用圆弧形布风板和气量调节相结合可以很好地消除阀体内的流化&死区&。

Maximum value of ring-porous species-Fraxinus mandshurica , Fraxinus mandshurica , Phellodendron amurense, Quercus mongolica, semi ring-porous Juglans mandshurica, diffuse-porous Betula platyphylla, Tilia amurensis and non-porous Pinus sylvestris, Pinus koraiensis were as following: 430.53, 516. 36, 234. 00, 625. 93, 945. 83, 199. 49, 507. 93, 142. 43, 286. 21cm〓cm〓h〓 in diumal course during the growing season, The sap flow persisted after leaf senescence until the mid-October.

在生长季中环孔材水曲柳、水曲柳、黄波罗、蒙古栎树干液流密度日最大峰值分别为430.53（8月末）、516.36（9月中旬）、234.00（7月下旬）、625.93 cm〓cm〓h〓（9月初）；半环孔材胡桃楸为945.83 cm〓cm〓h〓；散孔材白桦和紫椴分别为199.49（9月上旬）、507.93 cm〓cm〓h〓（8月上旬）；针叶材樟子松、红松分别为142.43（7月中旬）、286.21cm〓cm〓h〓（7月下旬）。

The displacement of the left articular facet was larger than that of the right articular facet,the same to the cervical foraminal area.The right-posterior-lateral disc protruded toward back-inner.

左侧小关节面相对位移较大，左侧椎间孔变大；右侧椎小关节面间移位小，右侧椎间孔变小，椎间盘右后外侧部向后突出。

Disc around the mouth and has a large number of small sentry post mouth, big mouth post holes for the bass, small mouth post holes for the treble, to the mouth of the disc number of posts are classified as shuang xiang, four-ring, 6 ring, until the 36 ring.

圆盘四周都有一个大哨口和许多小哨口，大哨口为低音孔，小哨口为高音孔，以各圆盘哨口的数量而分为双响、四响、六响，一直到三十六响。

The body has drum mixed with four leaves, stirring with a good performance out of the concrete mix to make a more uniform 2: mixed leaves on a mixed open hole to raise the quality of concrete mixing; 3 ----- sealed tube was funnel shape, Large caliber to ensure a smooth feed: 4: Lo leaves were added to the top surface wear protection, to extend the service life of the leaves, 5 leaves on a few large rectangle-shaped hole and the hole in the concrete to reduce the adhesion of the leaves; 6 : Mixing cylinder B520JJ optional alloy steel materials, wear resistant materials; 7 from the first block plate spinning, 8: ZG35 stirring drum track using the material, casting molding.

筒体内有四块拌叶、具有良好的搅拌性能，使拌出的混凝土更加均匀2：拌叶上开有拌孔能提高混凝土搅拌质量；3密封管-----呈漏斗形状，口径大能确保顺利进料：4：螺叶片呈曲面顶端加防护耐磨条，延长叶片使用寿命，5叶片上有几个圆孔及长方钜形孔减少混凝土在叶片上的粘附； 6：搅拌筒体材料选用B520JJ合金钢、抗耐磨材质；7封头由整块钢板旋压成型，8：搅拌筒轨道采用ZG35材质，经铸造成型。9：搅拌筒壳体各部件由高强度及高耐磨材质制作而成。10：搅拌筒整体焊接采用自动埋弧焊技术。

Given the same total flow effusion from holes, the results show that the heat shield gets a higher average cooling effectiveness when the opening ratio is 3% compared with 6%; cooling effectiveness is sensitive to the height of ripple board, the heat shield gets the highest cooling effectiveness when the dimensionless height of ripple board is 1% compared with 2% and 3.33%; but there is a little influence on the cooling effectiveness of the liner with the change of the diameter of holes and the height of cooling passage.

研究表明：在气膜孔出流总量相同的情况下，3%开孔率比6%开孔率的隔热屏平均冷却效率较高；波纹板高度对隔热屏冷却效果影响较大，波纹板无量纲高度为1%比波纹板无量纲高度为2%和3.33%的隔热屏平均冷却效率高；孔径和冷却通道高度的改变对隔热屏冷却效果几乎没有影响。

Experimental results show that, using the UV-LIGA process, hexagon micromesh nickel sieves (200 μm in side length, 50 mm in diameter and 120 μm in thickness) with an open-area percent of 88% and a sheet-thickness of 120 μm, which can hardly be achieved by the conventional machining methods, are successfully machined. The machined sieves are characterized by their smooth surfaces and aperture walls, high precision sizes as well as rigid and homogeneous structures.

结果显示，采用优化的工艺条件（前烘65℃/20min，95℃/20min；适量曝光剂量；后烘65℃/10min，95℃/15min；匀胶后静置、随炉冷却；超声辅助显影等）所制备的六边形镍网（边200μm），不仅开孔率高(88%)，厚度大(120±3μm，且具有尺寸精度高（形位误差±2μm）、孔形一致性好（筋宽偏差＜3μm）、孔壁平滑等特点。

High pressure revolving water jet technology has an obvious advantage in drilling large hole diameter and long continuous holes and is also characterized by high efficiency,energy saving,large and regular borehole,high rock-breaking efficiency when drilling coal seams.

高压旋转水射流技术在钻大井径、长连续孔方面具有明显优势，在煤层中钻井又具有高效、节能、钻孔大、成孔规则、破岩效率高等优点，因此在煤层气地面径向水平井技术和井下采空区钻长直井技术中广为应用。

What would he tell Judith and the children?

他将怎样告诉朱迪丝和孩子们呢？

I this is at that time, the opinion with peacockish true girl is full of in a heart.

这就是当时的我，一个心中布满虚荣的女孩子真实的想法。