大孔

Pore structure experiment shows that porosity of high volume fine mineral mixture RPC is about 5%, the pore distribution is uniform and the main pore is small. When the cement content of high volume fine mineral mixture RFC is 300 kg/m^3, its sclerotium hydration products is dense packed by irregular equal Ⅲ style C-S-H gels. The gels are fine, dense, and integrate with the aggregate.

孔结构试验表明，大掺量矿物细粉活性粉末混凝土的孔隙率均在5%左右，孔分布情况很均匀，主要以微小的小孔为主；水泥用量为300 kg/立方公尺的大掺量矿物细粉活性粉末混凝土硬化体水化产物主要由不规则等粒子状的Ⅲ型C-S-H凝胶紧密堆积在一起，凝胶精细、致密，且与骨料融为一体。

SBA-15 samples obtained from both silica sources were highly ordered p6mm symmetric pillar structure,as was evidenced by XRD patterns,with similar surface area and slightly larger pore volume for the samples prepared from TEOS than those from sodium metasilicate.

通过X射线粉末衍射对样品进行表征，发现两种硅源合成的SBA-15都具有高度有序的二维六方立柱形结构。它们的比表面积相近，用TEOS作为硅源的SBA-15的孔容比用硅酸钠作为硅源的SBA-15的略大；用硅酸钠作为硅源的SBA-15有更高的微孔率和更厚的孔壁。

Classification and principle of rigid waterproofer;2. The circinal cavities were found in calcium alginate beads and the cylinder holes were observed in zinc alginate beads from the SEM,which indicated that the volume of fraction of zinc alginate polymer was relatively bigger and the zinc alginate polymer chain was more rigid than that of calcium alginate .

凝胶的SEM照片可见，海藻酸钙的冷冻干燥颗粒内为较大的圆孔，海藻酸锌凝胶内为较小的长孔，表明海藻酸锌高分子链在凝胶颗粒中的体积分率相对较大同时刚性较强；卵清蛋白从海藻酸凝胶颗粒中释放的试验结果表明，由于上述海藻酸锌凝胶的特性，导致海藻酸锌对卵清蛋白扩散阻滞作用相对较强；根据试验数据计算得卵清蛋白在海藻酸钙、海藻酸锌凝胶颗粒中的扩散系数分别为1。

The bigger average pore of the porosity system,the smaller size of the micro-residual oil droplet and the more dispersed micro-residual oil droplet after waterflooding, that is to say, when the average pore width is big enough,the micro-residual oil is mainly composed of isolated single-pore and dual-pores droplets whereas the blocklike remaining oil is hardly exist.

微观驱替效率随平均孔宽的增加而增加，孔隙大小决定微观剩余油液滴的大小，孔隙系统的平均孔隙半径越大，水驱之后微观剩余油的尺寸越小，分布越分散，也即当孔隙的平均孔宽较大时，微观剩余油主要是由孤立的单孔隙和双孔隙液滴组成，连片的块状剩余油几乎不存在。

The circinal cavities were found in calcium alginate beads and the cylinder holes were observed in zinc alginate beads from the SEM,which indicated that the volume of fraction of zinc alginate polymer was relatively bigger and the zinc alginate polymer chain was more rigid than that of calcium alginate .

凝胶的SEM照片可见，海藻酸钙的冷冻干燥颗粒内为较大的圆孔，海藻酸锌凝胶内为较小的长孔，表明海藻酸锌高分子链在凝胶颗粒中的体积分率相对较大同时刚性较强；卵清蛋白从海藻酸凝胶颗粒中释放的试验结果表明，由于上述海藻酸锌凝胶的特性，导致海藻酸锌对卵清蛋白扩散阻滞作用相对较强；根据试验数据计算得卵清蛋白在海藻酸钙、海藻酸锌凝胶颗粒中的扩散系数分别为1.19×10-7、0.07×10-7cm2/s，利用阻滞模型计算得海藻酸锌高分子链在凝胶颗粒中体积分率约为海藻酸钙高分子链在凝胶颗粒中体积分率的1.7倍。

And for the stress in the directional direction, which is imposed on the lathe-bed, the bending plane is an epiplastron, therefore, the batten wall pore should be designed in the epiplastron.

而当孔的位置是位于弯曲中性轴附近的时候，其对弯曲刚度的影响比较小，而当其远离中性轴即靠近边缘的时候，对弯曲刚度的影响就越大，所以应该将板壁孔布置在弯曲中性轴附近，这样可以减少孔对床身刚度的影响。

And for the stress in the directional direction, which is imposed on the lathe-bed, the bending plane is an epiplastron, therefore, the batten wall pore should be designed in the epiplastron.

而当孔的位置是位於弯曲中性轴附近的时候，其对弯曲刚度的影响比较小，而当其远离中性轴即靠近边缘的时候，对弯曲刚度的影响就越大，所以应该将板壁孔布置在弯曲中性轴附近，这样可以减少孔对床身刚度的影响。

In this paper, the 3-D finite element relocating mesh method is used to calculate the temperature field and the thermal creep stress field of spillway dam and mid level outlet dam in certain roller compacted concrete gravity dam, sensitivity analysis have been down with different parameters, such as placing temperature, the location of cooling pipe, cooling temperature, time for water supply, ascended-layer of concrete, intermissive time and different placing time, and the commendatory construction scheme have been put forward in such analysis; according by the test result on the two scheme of concrete aggregate combination (basalt as coarse aggregate and limestone as fine aggregate, basalt as coarse aggregate and basalt as fine aggregate), simulation analysis on temperature field and thermal creep stress field of the commendatory construction scheme have been down, and analysis have also been down on temperature field and thermal stress field of the two different aggregate combination, the result indicates that the spillway dam and mid level outlet dam which adopted these two aggregate combination can both satisfy the require of design crack resistance in concrete, furthermore limestone as fine is better than basalt as fine aggregate; the effect of summer water storage and winter water storage on the temperature field and thermal stress field have been analyzed, comparing with winter water storage, in summer water storage scheme the maximum tensile stress at abnormal concrete in upstream fill is decreased by 0.1～0.3MPa and there are no evidence change of the maximum tensile stress at other parts, which indicate that summer water storage is avail for the crack resistance of upstream fill; according to the simulation calculating result and comparing temperature simulation calculating results and temperature controlling measures of some similarity projects both completed and construction, synthesis appraise have been carried to the design temperature controlling measures of dam, and the temperature controlling measures of this project have been brought forward, all these have great reference value on the design of temperature controlling measures and the optimization of the construction scheme.

本文采用三维有限元浮动网格法仿真计算程序，对某碾压混凝土重力坝的溢流坝段和中孔坝段分别进行了三维有限元温度场和温度徐变应力仿真计算分析，对浇筑温度、冷却水管的布置方式、冷却水温、通水时间、浇筑升程和间歇时间、不同开始浇筑日期等参数进行了敏感性分析，在此基础上提出了推荐的施工方案；根据两种骨料方案(玄武岩粗骨料+灰岩细骨料方案；玄武岩粗骨料+玄武岩细骨料方案)的混凝土性能试验研究成果，对推荐的施工方案进行了温度场和温度徐变应力仿真计算，并对比分析了两种不同骨料情况下的温度场和温度应力，结果表明溢流坝段及中孔坝段采用上述两种骨料均能满足混凝土的抗裂设计要求，且灰岩细骨料优于玄武岩细骨料；计算分析了夏季蓄水和冬季蓄水对坝体温度场和温度应力的影响，夏季蓄水方案与冬季蓄水方案相比，坝体上游变态混凝土区域最大拉应力小0.1～0.3MPa，其他部位最大拉应力无明显变化，夏季蓄水对坝体上游面混凝土的抗裂有利；根据仿真计算成果并通过比较国内一些已建和在建的类似工程的温度仿真计算成果及采取的温控措施，对大坝的设计温控措施进行了综合评价，并提出了该工程的温控措施，对温控设计和优化施工方案具有重要参考价值。

AQP2 mRNA was enhanced only in renal cortex in ligation group. While medullar Na-K-2Cl cotransporter was up-regulated significantly both in aortocaval shunt rats (A1, A3) and ligation rats.

4AQP2仅在冠脉结扎大鼠肾皮质表达增高，而Na-K-2Cl转运子在造瘘1孔、3孔和结扎大鼠的肾髓质表达均显著上调。

It was found the flow velocity gradients around the gas-tunnel was high enough to cause air mixture and sand-core washing-out, the casting should be with good sinkhead and gas-venting ability.

对铸造过程充型模拟的计算结果可知，在气道附近区域，流体流动的速度梯度很大，容易出现卷气、冲刷砂芯等现象，因此，在这些区域出现气孔、针孔和缩孔、砂孔等缺陷的可能性很大，为此，必须保证铸件凝固补缩良好、排气通畅。

What would he tell Judith and the children?

他将怎样告诉朱迪丝和孩子们呢？

I this is at that time, the opinion with peacockish true girl is full of in a heart.

这就是当时的我，一个心中布满虚荣的女孩子真实的想法。