英语人>网络例句>大圆 相关的搜索结果
网络例句

大圆

与 大圆 相关的网络例句 [注:此内容来源于网络,仅供参考]

The comparison of the predominant bacterial community structure in the gastrointestinal walls between Lutjanus sebae (Cuvier, 1816) and Ephippus orbis (Bloch, 1787) based on 16S rDNA PCR-DGGE fingerprint using a culture-independent method was conducted in the paper. The results showed that abundant bacterium were planted in the gastrointestinal walls of both marine finfish species, the similarity was above 50% in the community structures in the gastrointestinal walls with the highest similarity of 67% in the bacterial composition between the intestinal wall of Luljonus sebae and that of Ephippus orbis, and the walls of the stomach and the intestinal in one fish shared the same most predominant bacteria species, which might reflect the same aquaculture environment and the diet fed for both finfish species.

本文采用免培养的16S rDNA梯度凝胶电泳技术对集约化海水网箱养殖川纹笛鲷Lutjanus sebae、及圆白鲳Ephippus orbis消化道壁优势菌群结构进行了比较分析研究结果显示川纹笛鲷及圆白鲳消化道壁存在着大量细菌群落,对DGGE指纹图谱聚类分析表明两种鱼肠道壁及胃壁菌群组成相似度高于50%,其中二者肠道壁细菌组成相似性最高(67%),这些可能与两种鱼养殖在同一水域、摄食相同饵料相关,另外通过软件对DGGE指纹带谱相对丰度分析表明同种鱼肠道壁及胃壁具有相同最大优势菌群。

Results:(1)Distance between two funiculuses on upper edge of pubic symphysis is 65.96±0.42mm, distance between two womb round ligaments on upper edge of pubic symphysis is 64.62 ±0.54mm, two of them have large movement ranges, so firstly finding funiculus or womb round ligament and extending them before operation can protect them.

结果 ①耻骨联合上缘两精索间距为65.96±0.42mm,耻骨联合上缘两子宫圆韧带间距为64.62±0.54mm,两者活动度都很大,手术先找到精索或子宫圆韧带并向两侧牵开,即可保护。

The third: a round-step, half step-by-step evolution version can be used to deal withbefore and after half-step or a step-by-step, step-by-step round of the advantages is that it's flexible, as long as theother side of a knife does not, then you have a good chance to kill Flying The enemy or the enemy's injury.

第三:圆步,半圆步的进化版,可以用来对付前后步或者半圆步,圆步的优点在于它的灵活机动,只要对方出刀不中,那么你就有很大的机会飞刀杀敌或者伤敌。

For the purpose of this requirement, a wire crossing the imaginary plane more than once is treated as separate wires and the cross-sectional area of a wire having a non-circular cross-section shall be taken as the cross-sectional area of a circular wire having a diameter equal to the maximum width of the wire having the non-circular cross-section.

为了达 到这一要求,电线不仅一次通过这个假想面。计算横截面积时,散线或非圆截面的电线的横截面积等同于圆线的最大直径横截面积。

The second research has also got that a function of slopes to C values is monotone decreasing function when target circles are bigger than distractors circles.

研究二针对目标圆大于干扰子圆大的条件,得到的目标搜索斜率对C值的函数也是单调递减函数,并确定了平行搜索与系列搜索的临界点〓(0.497)。

To some extend, photolithography area controls the performance of whole semiconductor manufacturing system.

在整个半导体晶圆制造系统中,光刻区是重入次数最多的区域,光刻设备被认为是利用率最高的瓶颈设备,并在很大程度上控制着整个晶圆制造厂的系统绩效。

This paper introduces the prefabricate technology in knitting three-dimensional structure , it also studies the characteristic and application of the warp knitting structure composite composed of it.

介绍了针织三维结构预制件技术及由其组成的经编结构复合材料的结构特点和应用,指出圆机间隔结构技术的发展将对圆机的革新起到很大的促进作用

If the area of first circle is greater that the second one, print the area of first circle.

如果第一个圆的面积比第二个大,列印第一个圆的面积。

If the area of second circle is greater that the first one, print the area of second circle.

如果第二个圆的面积比第一个大,列印第二个圆的面积

The combinations of 0.018 inch stainless steel round wire and all brackets produced significantly the lowest static and dynamic frictional resistance than that of other archwires . The 0.019× 0.025 inch stainless steel rectangular wire produced the highest static and dynamic frictional resistance combined with all preadjusted brackets combinations .

在4种弓丝中,0.019× 0.025英寸不锈钢方丝动、静摩擦力最大,0.018英寸不锈钢圆丝的动、静摩擦力最小,两者之间有显著性差异;0.020英寸不锈钢圆丝与0.019×0.025英寸不锈钢方丝之间无显著差异。

第13/56页 首页 < ... 9 10 11 12 13 14 15 16 17 ... > 尾页
推荐网络例句

However, as the name(read-only memory)implies, CD disks cannot be written onorchanged in any way.

然而,正如其名字所指出的那样,CD盘不能写,也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口,替代木托盘,免薰蒸,符合欧盟、北美各国对出口货物包装材料的法令要求;喷涂钢托盘适用于重载上货架之用,托盘表面根据需要制作成平板状、波纹状及间隔形式,满足不同的使用要求。

A single payment file can be uploaded from an ERP system to effect all pan-China RMB payments and overseas payments in all currencies.

付款指令文件可从您的 ERP 系统上传到我们的电子银行系统来只是国内及对海外各种币种付款。