多面

The scan line method is one of the most commonly used methods in rock joints survey. To ensure the quantity of collected joint samples enough, and at the same time, to save surveying workload, the optimum scan line length should be determined first of all.

为了保证采集的结构面样本数量足够多，同时又使测量工作量最省，测线法应用时首先需要确定一个能够保证测量精度的最小测线长度——最佳测线长度。

It can be applied in refraction seismology and multichannel analysis of surface waves survey as well.

认为这种方法在提高野外施工效率的同时，也可以提高数据的信噪比和速度分析的精度，并且可兼顾折射法和多道面波的应用。

Model updating; Response surface model; Sequential quadratic programming; RBF neural networks; Multi-island genetic algorithm.

模型修正，响应面模型，序列二次规划法，RBF神经网络，多岛遗传算法。

We adjust the parallelism of three-roll, you can add a printing plate cylinder to nano-imprint lithography, side drum Department UV ink of sticktness a little bigger, you can mitigate high number of small wire mesh point of cataplasm version, you can also have a small dot less wear and are protected by extending the service life of the plate.

我们在调量不一辊的交错量时，可以不兵印版滚筒稍微向不抬印滚筒处偏一些，UV油墨的黏量稍微不小些，既可以缓和矮网线数洪不小网不面的糊版，还可以让洪不小网不面多施磨损而获得爱护，不收不小印版的搁置寿命。

The Shatterer mobile sonic tank doesn't necessarily do area damage in the traditional sense, but it is capable of damaging multiple units in one shot if used correctly.

震裂者机动音波坦克从传统上来说并不具备面杀伤能力，但如果使用得当，它也能一击摧毁多个单位。

Three optimal structures were gotten in this paper by the model of elastic modulus along the grain, elastic modulus in tangential direction, in-plane shearing modulus and laminate rigid:①0/90/0/90/0/90/0/90/0, the outside four veneer is modified, the along grain MOE and MOR are 8377MPa, 60.9MPa respectively; The across grain MOR is 35.1 MPa, and TS is 17.2%.

4通过应用杨木单板顺纹弹性模量、横纹弹性模量、面内剪切模量及层合板刚度模型进行杉木胶合板结构设计，经多次修正，得出较好结构有以下几组：①0/90/0/90/0/90/0/90/0，最外四层为杉木改性单板，顺纹弹性模量和静曲强度分别达到了8377MPa，60.9MPa；横纹静曲强度为35.1 MPa，吸水厚度膨胀率为17.2%。

Besides, the concepts, such as SIB and multiple energy function sheets, are explained by picture.

此外，还以图形形象地解释了多能量函数面和奇异诱导分岔等概念。

The results of Monte Carlo simulation disclose that in large range of nitrogen fugacity the solubility of the interstitial nitrogen in αFe obeys Sievert's law. This range is much larger than that in γFe-N system. The results also show that in order to get the same level of interstitial nitrogen solubility in αFe-N system during solid state nitride, larger nitrogen fugacity is needed at the lower temperature.

该逸度范围比面心立方结构的Fe-N体系中大得多；由模拟计算结果还可知，在固体渗氮过程中，若要使合金含有同样浓度的固溶氮，渗氮温度较低时应保持较高的氮分压。

A technique which can control the iteration step length of the single step full Newton Raphson method is presented to get the converged solution.

纺织物的弯曲刚度比其面内拉伸剪切刚度小得多，其下垂过程具有高度几何非线性，它能在经向和纬向同时屈曲，形成漂亮的圆角形状。

Organization: Center of Engineering Mechanics, School of civil Engineering and Architecture, Nanchang UniversityAbstract: The situation of singular yield surface are very common in the research of constitutive relation of geo-materials, for example, two-yield-surface soil model, four-parameter concrete model, and so on.

摘 要：在岩土材料本构关系的研究中，奇异全屈服面的情况非常多见，如土的双屈服面模型、混凝土的四参数模型等。

Plunder melds and run with this jewel!

掠夺melds和运行与此宝石！

My dream is to be a crazy growing tree and extend at the edge between the city and the forest.

此刻，也许正是在通往天国的路上，我体验着这白色的晕旋。