多电路的

This paper analyzed and researched the characteristics of Schmitt trigger, single-stable-state trigger and astable multivibrator constituted by 555 timer based on PSPICE. Against the phenomenon of astable multivibrator constituted by 555 timer has no oscillation in PSPICE, an effective analysis method was brought out for 555 timer circuit to simulate the actual oscillator.

作者在文中应用PSPICE对555定时器构成的施密特触发器、单稳态触发器和多谐振荡器的工作特性进行了仿真分析和研究，针对PSPICE中555定时器构成的多谐振荡器不起振的问题提出了模拟振荡电路的有效起振方法，对电子电路的分析与设计具有一定的参考意义。

The LCD driver circuit has several inspection units, logic operation unit and drive change-over switch in its driving stage.

本发明是关于一种液晶显示驱动电路及其使用的检验装置与容错方法，该液晶显示驱动电路的驱动级具有多个检验装置、逻辑运算单元与驱动切换开关。

With full mesh, every site is connected to every other site. Unlike with leased line interconnections, this can be achieved in Frame Relay without additional hardware.

在存取线路使用多重虚拟电路会比单一虚拟电路有效率，因为这使用到内建统计多工的优势。

It discusses the way that is made use of GAL to realize logic circuit.

本文从用GAL实现单稳和多谐电路的角度，探讨利用GAL实现给定逻辑电路的方法。

When the Mealy circuit state number is 2n, Moore circuit is more complex than the Mealy electric circuit because of more than one state.

当Mealy型电路的状态数为2n时，Moore型比Mealy型电路因多一个状态而更为复杂。

Summary This paper analyzes the working principle and stability of a transistor mul- tivibrator operating as a frequency divider,with both sides being synchronized by the input signal.It is found that the frequency division stability of this circuit can further be increased when the multivibrator operates in the second class of oscillating condition,and that the optimum operating point is best determined from the actual base voltage changing characteristic.

本文分析了晶体管自激多谐振荡器用作双侧同步分频电路的一般理论和分频稳定性，并考虑基极电压变化规律来确定最佳分频的工作状态和运用点，同时对同步脉冲的引入问题亦作了原理性补充，还提出了振荡于第二类状态下的自激多谐振荡器可获得高稳定性的分频，以及此类双侧同步分频电路的设计方法。

A new way of distance measurement is introduced in this paper, it is similar to traditional measurement way, and has its origination. In the new measurement way, the rough measurement of the distance is realized by countering high frequency pulses filled in discriminable phase pulses. Discriminable phase pulses go through integral circuits, and then are sampled by Analogue Digital Converter, so the accurate measurement of the system is obtained by the sampling value.

本文提出了一种新的测距方法，该方法与常规相位测距仪比较，既有相似之处也有其创新之处，常规相位测距仪一般使用多波长测尺频率组合、差频数字测相的方法，本系统虽然也采用多波长测尺频率组合，但并不采用差频数字测相，该方法摒弃了传统的内外光路的切换方式及电路的混频，粗测采用对鉴相脉冲填充高频脉冲的办法实现，精测则利用鉴相脉冲对积分电路进行积分，然后由ADC 对积分电平进行转换，通过对ADC 的输出值的计算处理实现精测。

By using the measure and research of the emulating two-port network parameters of using direct-current analysis and figure value output function of sinusoidal steady state circuit in circuit emulating sofeware PSPICE8.0,the measune and reseavch have solved the problem of the measuring purely resistive network of simple and odd one in traditional experimient,and also brought about the analysis of alternating current and direct-current for two-port network of any one complex and measure and research of Y、Z、T、...

利用电路仿真软件PSPICE8.0中直流分析及正弦稳态电路的数值输出功能仿真二端口网络参数的测量与研究，解决了传统实验中只能测量简单、单一的纯电阻网络问题，实现了对任一复杂二端口网络交、直流的分析及Y、Z、T、H等参数的测量与研究，为更多的不易完成的传统实验以及复杂电路的分析研究开辟了一条新路。

In the last new years , as the demands of wireless communication system grows rapidly , the bands of microwave frequency had been saturated with various communication applications . To achieve wider spectrum for high-speed and high-capacity transmission , bands of millimeter-wave frequency are the solution of this problem . The advantage of MMW wireless communication systems is wider bandwidth comparing with microwave communication systems . To utilize the spectrum efficiently , many methods of complexly digital modulation is proposed . The more complex modulation , the higher linearity is required , and more various phase of signals are required to accomplish process of modulation . Therefore high-linearity and quadrature-phase modulator and demodulator are the emphasis of this thesis . For high level of integration , high performance and low cost , this chip is fabricated by the complementary oxide semi-conductor 0.13um process . A compact size of direct down-conversion and direct up conversion circuits will be presented in this thesis .

近年来随著无线通讯产业的蓬勃发展，微波频带已经趋近於饱和，为了追求更宽的频谱来达到更快传输速率及高资料容量的传输，宽频的毫米波频段提供了解决此问题的途径，毫米波无线通讯系统提供了相对於微波通讯系统宽频的优点，且为了更有效的使用频谱，各种不同且复杂的数位调变方式及方法被发表出来，越复杂的调变方式其所需的线性度越高，且需要更多不同的相位讯号来完成调变的过程，因此高线性度及四相位的调变及解调器将是此篇论文的研究重点，为了达到高整合性，高效能，及低成本的电路设计，我门利用互补式金氧半导体制程来完成此电路设计，因此一小面积的直接降频(Direct down-conversion)及直接升频(direct up-conversion)电路将在文中介绍。

This design main be how average type beam drill electricity charge circuit be in progress design, main content include host circuit design, control circuit design, instruction circuit design and under the control of component choice, not bad come true Z3050 type beam drill starting, stop, be rotating, roll back and a few corresponding protection function.

本设计主要是多普通型摇臂钻床的电控线路进行设计，主要内容包括主电路的设计、控制电路的设计、指示电路的设计和控制元器件的选择，可以实现Z3050型摇臂钻床的启动、停止、正转、反转以及一些相应的保护功能。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。