多孔的

A new type of porous silicon carbide was fabricated by filter paper-phenolic resin composite through mold-stacking, drying, carbonization and Si infiltration process.

以滤纸和酚醛树脂为原料，通过模压成型、固化、碳化和渗硅制备出微观结构均匀的多孔碳化硅。

It has been experimentally observed in many engineering materials such as in the clay that a shear band of intense plastic deformation caused by strain softening possesses a finite width.

对饱和多孔介质(也能作为退化情况用于固体材料)提出了一个归结为线性互补问题求解过程的梯度塑性连续体有限元-无网格耦合方法。

The catalyst composition includes active metal oxide and the composition of porous melt-resistant inorganic oxide.

该催化剂组合物包括活性金属氧化物和多孔耐熔无机氧化物的复合物。

In the paper,the alternative characters of current electric conduction of rock-coal porous medium with gas are studied.

研究了煤岩多孔介质及其充瓦斯后的交流导电性。

Based on the air drying theory of capillary porous media, mathematics model of through air drying of paper was established, and the mathematics model was analysed and calculated.

基于多孔介质气流干燥理论，建立了纸张气流穿透干燥的数学模型，并对数学模型进行了分析求解。

Techniques of forced injection of donor egg albumen to replace recipient egg albumen were adopted.

用多孔挤出法把新汉西鸡蛋白、北京鸭或华南鸭蛋白调换到鸽蛋中，观察雏鸽的体重增长及其他变异。2。

Electrochemical Behavior of Porous Biomorphic Carbon/Platinum Particle Composite.

多孔生物形态碳/铂颗粒复合材料的电化学行为。

Aligned Silicate-2 zeolite membrane was synthesized by in situ seeding and secondary crystal growth in microchannels of biomorphic porous SiC ceramics support.

榉木经高温热解转化为生物碳模板，通过液相渗硅反应工艺制备了保持木材微观结构的多孔SiC陶瓷。

The gold bonder can increase mechanical bonding between porcelain and electroformed copings. The copings and porcelain combined tightly, simple elements diffusion was observed obviously in interfacial area.

喷砂使金沉积基底表面粗糙度增加，涂金黏结剂后表面形成了多孔样结构，有利于机械结合；金沉积烤瓷金瓷结合紧密，界面存在元素的扩散。

In this study,the porous Al/(TiB2+Al2O3)MMCs are densified by hot-pressing and good mechanical properties of the composites are obtained.

本文用热压技术将多孔Al/(Al2O3+TiB2)MMCs致密化并得到了很好的力学性能。

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。