多孔板

Aerogel films are prepared to investigate the feasibility to serve as inverse structure for preparation of porous film electrochemically.

气凝胶薄膜主要是用来当作以电化学的方式制备的多孔性薄膜的基板。

Background of Project: taking industrial waste residue and municipal refuse as raw material, Luohe Huaxia New Type Building Materials Co., Ltd is a professional firm to manufacture free burnt supporting brick, air brick, ordinary brick, cork brick and light partition board, fire plate, light silico calcium plate and other new type building materials.

项目背景及建设条件：漯河市华夏新型建材有限公司是一家专业利用工业废渣和城市垃圾为原料，生产免烧承重砖、空心砖、砌块砖、多孔砖、轻质隔墙板、防火板、轻质硅钙板等新型建材的企业。

YM-tensioned anchor client 1, YM strand tensioned anchor client system includes: YM15 anchor (for §15.2,§15.7mm strand) YM13 anchor (for §12.7,§12.9mm Steel Stranded) BM15, BM13-type flat anchor YMZ15, YMZ13-ring anchors (applied to the structure of cyclic stress) 2, YML Series connectors include: single as used prestressing tendon lengthening, usually with in pre-tensioned law; porous as the next long prestressed beam, normally used in the continuous beam. 3, P-type anchorage system for P-type anchorage system includes extrusion anchor (from compression set and a triangle composed of copper wire extrusion spring), anchor anchor plate, spiral reinforcement, constraint circle bellows.

YM张拉端锚具1、YM钢绞线张拉端锚固体系包括：YM15锚具（适用于ф15.2、ф15.7mm钢绞线）YM13锚具（适用于ф12.7、ф12.9mm钢绞线）BM15、BM13型扁锚YMZ15 、YMZ13 型环锚2、YML型系列连接器包括：单孔作为接长预应力筋用，通常用于先张法中；多孔作为接长预应力束，通常用于连续梁中。3、P型锚固体系P型锚固体系包括挤压锚具（由挤压套和三角形铜丝挤压簧组成）、锚固锚板、螺旋筋、约束圈、波纹管。

Tea wants wear 150--200 micron atomic, join plant sex starch and protein next, add again 35, 40% water is moved into mushy, in the compressor that pulls in poriferous model, with every square centimeter 50 kilograms pressure, squeeze a strip form tea, thin fry batter in a thin layer is put on breaker plate, blow with sirocco do water content 10% the left and right sides, reoccupy low temperature is long carbonado sufficient dry, arrange the norms that agrees into accident next, pack with moistureproof material.

茶叶要磨成150--200微米的微粒，然后加入植物性淀粉和蛋白质，再加35—40%的水调成糊状，在多孔模扳的压力机中，用每平方厘米50公斤的压力，挤出长条形茶，薄摊放在筛板上，用热风吹干到含水量10%左右，再用低温长烘到足干，然后整理成长短一致的规格，用防潮材料包装。

But when the cholesterol was substituted by its oxide result, the membrane life time extended to nearly 60 hrs ;besides the diameter of the hole on which the membrane exists 、temperature、PH value cause great effects to the life time of the membrane, and the diameter was the most important element. When the diameter larger than 3mm it is almost no way to form a membrane on the hole under experiment condition. Between 1mm and 3mm it has a better result by change the prescription of the membrane. when it is 0.5mm all the membrane can last more than 40 hrs ,and the prescription like Och : phosphatidylcholine / cephalin＝4:1; 3:1; 2:1; 1:1; 2:3 need the request of the experiment basically, when cooperate with multi hole structure it is very to detect the concentration and found the model.

研究结果说明，成膜在普通胆固醇/磷脂配方下不能达到满意的结果，无论如何改变外界条件成膜始终超不过7小时，而将胆固醇换成氧化胆固醇再和磷脂按照一定配比的时候，成膜时间则大大延长，可达60h左右；另外除成膜配方，成膜孔径、温度、PH值等因素对成膜有着很重要的影响，成膜孔径对膜的影响最为关键，在3mm以上的孔径时成膜比较困难，在1－3mm适当提高成膜液浓度可以改善，孔径为0.5mm左右成膜比较稳定基本都能达到40h以上，合适的几个配方如卵/脑磷脂：氧化胆固醇＝4：1；3：1；2：1；1：1；2：3基本满足实验要求，配合一板多孔结构，可以保证单位时间的离子传输量的检测和计算。

Simply place work on spring-loaded, perforated dasher plate, press down and agitate, then release to return dasher to drain position.

简单的将工作放置于弹簧式多孔搅拌板上，压下并搅拌，然后释放，将搅拌板回放至出水口的位置。

Methods The porous glass plate absorber valve was used to sampling, the contents of hydrogen chloride and sulfate was determined by hydronium chromatography method at the best determination condition and suitable mobile phase.

以多孔玻板吸收管采样，离子色谱法测定，选定最佳测定条件，确定适宜的流动相，测定氯化氢和硫酸的含量。

Recently, people pay more and more attention to ceramic porous monolith infrared burner.

近年来，人们对天然气多孔陶瓷板红外线燃烧器的研究越来越关注。

The product includes:SJSZSeries plastic extruder,∮20～630mm PVC Pipe material production line,∮20～710mm PE Large aperture pipe material production line,∮300～2500mm SBG Series double-wall sewer pipe production line, Production line of multiple-hole pipe communication, Random polypropylene pipe production line, Silicon-core pipe production line, Alumiunm-plastic complex pipe production line, SJYF Model plastic special-shaped material extruding unit, PVC Micro-foaming special-shaped material unit, PVC Plastic printing making unit, Recovered film prilling unit, Plastic blowing film unit, plastic blowing bottle machine, Medical injector full set equipment, Medical infusion unit full set equipment, Medical absorbent cotton full set equipment, Drink machinery, etc.

我公司生产的设备有：SJSZ系列塑料挤出机、∮20～630mmPVC管材生产线、∮20～710mmPE大口径管材生产线、∮300～2500mm PE双重壁下水管生产线、PP-R管材生产线、SJYF型塑料门窗异型材装饰板生产线、塑竹木异型材生产线、通讯用多孔管生产线、硅芯管生产线、铝塑复合管生产线、PVC芯层发泡管生产线、塑料板生产线、回收造粒生产线、塑料吹瓶机、塑料吹膜机组、医用注射器全套设备、医用输液器全套设备、医用药棉全套设备、饮料机械及塑料制品。*主要业务：塑料机械，医用耗材制造设备，饮料机械，塑料制品。

Metal strainers are manufactured from wire mesh, perforated metal, or expanded metal, and are often placed in-line with process piping to remove larger particulate matter and contaminants that may damage pumps, valves and other process equipment.

金属过滤器用金属丝网，穿孔金属板或多孔金属板加工生产，经常是嵌套在工艺流程管路中，用于去除大颗粒物质和赃物（容易毁坏泵，阀和其他的工艺设备）。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。