多孔性

Inthe last stage of reduction,the iron substrates formed on the surface of Wüstite areporous and permeable to gaseous diffusion.The reduction rate is controlled by thesurface reaction on the Wüstite-iron interface,but the rate of this surface reactionis limited by the velocity of CO formation.

在浮士体还原成金属铁的阶段，所生成的多孔性金属铁并不阻碍气相的扩散；还原的速率由浮士休-金属铁相界面的表面反应所控制，而表面反应的速率则受CO的生长速率所限制。

The determination of surface tension and surface tension components of porous particle with sub-pores by wicking technique was studied.

研究了用薄层毛细渗透技术测定多孔性颗粒的表面张力和表面张力成分。

SO〓〓/M〓O〓 solid superacid was applied to the photocatalytic oxidation of organic pollutants for the first time. Porous SO〓〓/TiO〓 solid superacid catalysts with high specific surface area were prepared by sol-gel method. The photocatalytic degradation of bromomethane was used as model reaction. The influence of impregnation with H〓SO〓 solution on the structure of catalysts and their photocatalytic performance was systematically studied by using X-ray diffraction, X-ray photoelectron spectroscopy, N〓 sorption analysis applying BET method, UV-Vis diffuse reflectance spectroscopy, FTIR spectroscopy, O〓-TPD and photocatalytic activity measurement. The acidity of TiO〓-based catalysts was investigated by Hammett indicator method, NH〓-TPD and IR spectra of pyridine adsorbtion. The mechanism of superacidifing effects on photocatalytic performances such as the photocatalytic degradation rate of bromomethane, apparent kinetic constant and apparent quantum efficiency was discussed.The results indicated that SO〓〓 is combined with metal ions of TiO〓 in a chelating bidentate mode.

本文首次将SO〓〓/MxOy型固体超强酸催化剂用于光催化氧化有机污染物研究，采用溶胶-凝胶法制备了具有多孔性和大比表面结构的二氧化钛基固体超强酸光催化剂SO〓〓/TiO〓，以光催化降解溴代甲烷为模型反应，系统地研究了H〓SO〓浸渍处理对催化剂表面酸性及其气相光催化性能的影响，结合XRD、BET、XPS、FTIR、Hammett指示剂法、吡啶吸附红外光谱、NH〓-TPD、O〓-TPD、紫外可见漫反射光谱等多种表征手段，深入地讨论了超强酸化对TiO〓的改性机理，阐明了引起SO〓〓/TiO〓超强酸催化剂光催化降解溴代甲烷的转化率、表观反应速率常数和表观量子效率变化的本质原因。

To apply to circulating cooling water treatment more effectively, a column apparatus was devised by biocidal PVA balls, and some parameters of the column apparatus were researched such as length of filled column, treating time of water and outflux, etc.

结果表明：抗菌PVA小球具有良好的杀菌性能，在杀生剂添加量为m：m=3：2时，杀菌率达到（92 2）％；扫描电子显微镜显示，包埋了杀生剂的抗菌PVA凝胶小球是一种多孔性的球形颗粒，结构较密实，并且包埋效果理想。

Plasma processing quality determines the roller surface coatings (such as polyporous, hardness, distribution, and so on), so the entire coating process would take control by professional workstations.

等离子处理质量决定了辊筒表面涂层的微观结构(如多孔性、硬度、结构分布等)，因此整个涂布过程需由专业计算机工作站控制进行。

Ash composition and background gain as the non-coated material opacity and polyporous increases, GCR application may not suitable for all non-coated material users.

灰身分替代和底色裨益由于否涂布质料不透明性的贬矮和多孔性的增增，GCR搁置或者并不得当所有的否涂布质料用户。

The products are porous solids with high specific surface area (83m^2/g for NaH) and pyrophoric in air. They are far more active than the commercial alkali metal hydrides.

该反应的产物是一类大比表面积(NaH的比表面积为83m^2/g)、多孔性固体粉末，在空气中可自燃。

Marble is porous material, because this is easy smeary , the expert answers to use water less when the proposal is clean.

大理石是多孔性材料，因此轻易染污，专家建议清洁时应少用水。

In a previous study, a porous acellular bovine pericardium was developed by our group as an extracellular matrix to repair a surgically created myocardia defect in the right ventricle of a rat model.

再先前的实验里，我们以一多孔性的去细胞牛心包膜，当做天然细胞外间质，来修补缺损的老鼠右心室组织。

By using microscopic contact angle meter to measure the hollow fiber membrane contact angle, it could be found that the contact angle were higher than 120° for different solvent system. It was showed that the porous membrane structure could enhance the hydrophobicity.

利用显微镜接触角量测仪量测中空纤维膜外表面对水接触角发现，其接触角都大於120°，表示外表面多孔性结构有助於疏水性质之提升。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐