复合试验
- 与 复合试验 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
The machining of valve guider and valve set is one of the key process in production of engine cylinder-head.Arming at the precision finishing of valve guider and valve set,a special compound deep-hole cutting tool was designed and made out.
发动机气门导管孔和气门座圈的加工是发动机缸盖加工的关键工艺之一,针对气门导管孔与气门座圈的精密加工,设计制造了专用的复合深孔加工刀具,介绍了该刀具的结构与加工原理,并在试验的基础上优选了加工刀片材料,设计了加工刀片的结构参数。
-
In light of the actual condition in Pangang Group the high efficient compound dephosphorizer is developed by use of the dephosphorizing technology "single slag process" in converter smelting.
结合攀钢实际情况,利用转炉单渣法冶炼脱磷技术,开发应用了高效复合脱磷剂,使平均脱磷率达到89.40%,与转炉预处理双渣法脱磷技术相当,试验炉次的成品w≤0.015%,且未增加冶炼周期,为350km/h高速铁路用钢轨等钢种的稳定生产提供了技术支撑。
-
This study investigated effects of compounds of rare earth, LaNi 5 and CeO 2, on properties of cobalt-cemented tungsten carbide, diamond/carbide composite and diamond-tipped tungsten carbide insert for rock drilling under the active, low temperature sintering process which achieved by adding nickel and phosphorus into the mixed powders.
采用添加镍、磷的低温活化烧结工艺,分别用不同含量的稀土化合物LaNi5和CeO2 作为添加剂进行了试验,研究了其对硬质合金、金刚石硬质合金复合材料及由此构成的金刚石硬质合金复合凿岩柱齿性能的影响。
-
First, the theory of fretting wear and studies on fretting fatigue were introduced and the parametric method was used in the process of creating the model of dovetail joints in UG software. The elastic contact problem is analyzed in finite element method and is used to the parameters' distribution and contact stress of the joint are obtained on the base of ANSYS code. With the effect factor of load frequency, the prediction method of fretting fatigue life of dovetail joint under low and high/low cycle complex load is proposed. The proposed model and the approach were verified by experiments.
本文介绍了微动损伤的机理和微动疲劳寿命的研究方法;利用UG软件对燕尾榫联接结构创建了参数化实体模型;基于ANSYS软件平台求解弹性接触问题,获得了榫联接结构接触应力及接触状态量的分布;在已有微动疲劳寿命预测模型的基础上,引入载荷频率影响因子,对低周、高低周复合载荷作用下的燕尾榫联接结构进行了微动疲劳寿命的预测,与试验结果对比表明采用本文提出的方法预测榫联接结构的微动疲劳寿命是有效的。
-
Compared with the control, acidifiers could reduce the pH value, change the microbiological circumstances and stop the growth of E-coli and improve the quantities of lactobacillus.
试验结果表明,与空白对照组相比,复合酸化剂降低了肉鸡的肠道pH,改善了微生物环境,抑制了大肠杆菌的生长,同时促进了乳酸杆菌的增殖。
-
Effect of acid soil on dry matter accumulation and Al and nutrient contents of barleys differing in acid soil toleranceThe experiment was conducted by using 10 barley genotypes with different acid soil tolerance at seedling stages, each 5 genotypes for acid tolerance and sensitivity, to determine the difference in biomass accumulation, Al and nutrient content in the roots and shoots among genotypes under the condition of acid soil stress.
低pH和两种铝处理下植株各器官ca、Mg含量,茎杆和叶片P、K含量,叶片Fe、MO、Zn含量以及茎杆Zn、B含量和根系及叶片Mn含量均降低,铝福复合处理时降幅更大。100林MAI处理,大麦幼苗整个试验期间根系分泌的苹果酸、柠檬酸和唬拍酸含量与对照相比均增加,且耐铝基因型增幅大于铝敏感基因型,表明铝诱导这些有机酸分泌量增加可能与品种耐铝性有关。
-
were made on performance of fly ash on hydration process of complex binders, based on results from these experiments.
通过对试验结果的分析,研究粉煤灰在复合胶凝材料水化过程中的作用机理。
-
Results proved that PSAFS is one of the excellent coagulants for water cleaning and waste water treatment.
本文设计了一系列试验,用工业水玻璃和化学试剂合成了聚硅酸硫酸铝铁复合絮凝剂,并检验其除浊性能。
-
Through the setting time tests to the manifold substances which have retardant quality and their compound, a high tempeature retarder is confected which can make the RCC's initial setting time reach 6-8h when it is laid under the scorching sunshine at the high temperature of 30-40℃.
论文通过对多种缓凝物质进行试验筛选,组分配伍复合,研究配制出了可以在室外高气温日晒条件下使碾压混凝土的初凝时间达6~8h的复合型高温缓凝减水剂。
-
In this study, room-temperature-vulcanized silicone rubber and high-temperature-vulcanized silicone rubber are use to prepare silicone composites. Silicone composites were prepared by adding different proportion of mica, silica or carbon fiber. The inorganic filler was thoroughly dispersed in silicone rubber by two-roll mill. This study focused on the influences of various fillers and additive level on the mechanical, thermal properties, anti-ablation and 90peel strength of the silicone hybrids.
中文摘要本实验分别选用室温熟成型矽橡胶以及高温熟成型矽橡胶作为高分子基材,再加入不同比例各种填充材料,例如:奈米云母、奈米二氧化矽、碳纤维等无机材料,并以双滚筒混炼法来制备矽橡胶复合混成材料,再经由其机械性质、耐烧蚀、黏著试验等量测,来探讨添加不同填充材及其添加量对矽橡胶热物性之影响。
- 推荐网络例句
-
This one mode pays close attention to network credence foundation of the businessman very much.
这一模式非常关注商人的网络信用基础。
-
Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.
扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。
-
There is no differences of cell proliferation vitality between labeled and unlabeled NSCs.
双标记神经干细胞的增殖、分化活力与未标记神经干细胞相比无改变。