复合分析

Its excellent slide properties and higher hardness were utilized so that the composite of Co－P－ PTFE has already possessed better tribological propetties with no heat treatment. The crystal analysis presents the composite of Co－P－PTFE has the structure of hexagonal system at plating state and its forming process has obviously the trend on a certain direction.

结构分析表明，Co－P－PTFE复合镀层镀态时即以六方密排晶体结构存在，它的形成过程有强烈的择优取向倾象，六方密排钴的(100)面平行于样品表面且衍射峰明显增强，热处理后的样品有部分固溶体形成。

The main results of the investigation are as following:(1) Some important criteria for the design of multi-layer structure are acquired: the ratio of the layer thickness to the contact diameter should be controlled to a value about 0.8; increasing the number of the gradient layers and elasticity modulus of the top layer would benefit to the yield strength and the stress status at the interface.（2）By means of molecular dynamics simulations for a indentation and sliding process, it is discovered that dislocations of 45 direction to the surface occur in the surfaces layer, which is correspond to the direction of the plastic flows observed in the macroscopic continuous medium. The irreversible deformation caused by the dislocation and the atom piles at the surface are responsible for the irreversibility of the force response. They are also the main factors for the friction generation. The temperature and the indentation velocity have significant effects on the deformation behaviors of the material of the surface layer. The yield strength would increase obviously if the indentation velocity is greater than 10 m/s.（3）A method to evaluate the fracture toughness of coating by estimating the crack-density functionβof a Wicker''s indentation was proposed. Meanwhile a new surface treatment technology was developed using non-equilibrium plasma.（4）A MD-FE hybrid method and corresponding software was developed to analysis the tribological behaviors for multiplayer system.

研究主要内容和结果有：（1）得到指导梯度膜设计的几个准则：控制膜层厚度与接触半径比在0.8左右为宜；适当增加梯度层层数和顶层弹性模量，有利于提高抗屈服能力和改善界面处的应力状态；（2）通过对嵌入和滑动摩擦过程的分子动力学模拟，发现表层产生一个与宏观连续介质的塑性流动方向观测一致的45 方向位错；位错造成的不可逆变形和表面的原子堆积，是力的响应不可逆性的原因，也是构成摩擦力的主要因素；温度和嵌入速度对材料变形特性有显著的影响，当嵌入速度大于10 m/s时，屈服强度明显增加；（3）提出压痕裂纹密度系数β半定量判定膜层断裂韧性的方法；并开发出表面强化新工艺；（4）开发出分析表面摩擦学特性的MD-FE复合模拟方法和相应模拟软件。

The hypereutectic Al-Si alloy produced by electro-thermal methods was modified with P and RE, then the microstructure and mechanical properties of alloy were analyzed.

中文摘要：对电热法生产铝硅合金配制的Al-20Si合金进行了P-RE复合变质处理，对变质后的微观组织和力学性能进行了分析。

The paper deals with hyphenated compound adjectives , classifying them under different types and analysing their structures.

本文论述带连字符的英语复合形容词，对其作了分类和结构分析。

Study the surface energy of multi-component composites by IGC.

在以前的文献中很少见到这样利用近红外分析固体复合物表面层的报导。

It detailedly analysis the computer operation process: picture import and export, module design, datda handle, result output and board automatic number and verticall guide load; displacements and interal force analyses of all kinds of loads; combination of internal force.

在此基础上本文进行了LC复合墙结构的计算机程序设计，详细论述了图形输入输出设计、模块化设计、数据处理、结果处理、楼板的自动编号及竖向导荷，各种荷载作用下的内力及位移分析，然后进行了内力组合。

The experimental research on the lateral resistance system steel frame structure with sandwich-type infilling wall has been completed.

试验研究和理论分析表明，钢框架结构抗侧刚度较低，空腔砌块复合墙体能显著的提高钢框架的抗侧刚度，两者能很好地协同工作，成为钢结构住宅有效的抗侧力体系。

Empirical results show that the "intercity intermodal logistics transportation" has its financial benefits.

经由实例分析结果发现，「城际复合物流运输」确实为一具财务效益之营运策略。

Time domain signal is transformed to the frequency domain signal by FFT. Dispersion curve is obtained from phase angle that is calculated by the frequency spectrum analysis. A compound dispersion curve is obtained from the dispersion curves intervale, and the representative dispersion curve is used to evaluate dimensions and quality of soil grouting body.

由FLAC所得不同点位的速度历时透过快速傅立叶转换后，得到频率域讯号，再经过频谱分析计算其相位角，得到其频散曲线，由不同间距的频散曲线集合成复合频散曲线，再绘制成一"代表性"频散曲线，以评估灌浆体品质及范围。

The two sponges get marks of 0 in acute eye stimulation test and intracutaneous stimulation test , thus they are not stimulating to tissues.

由不同原料制备的FGF/胶原蛋白复合海绵，分别进行以下生物学测试；(1)皮内刺激试验；(2)短期肌肉植入试验，实验数据根据标准进行分析和评估。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。