复位

Among them,26 cases were treated with open reduction and internal fixation,and 11 cases received nonoperative treatment.

其中26例行切开复位重建钢板螺钉内固定术，11例采取保守疗法。

Methods From June 1997 to June 2001,89 cases of femoral neck fracture were treated by two nonparallel and nonintersection hollow compression screws fixation.

闭合复位、空心加压螺钉内固定作为治疗股骨颈骨折的一种方法，由于其创伤小、费用低廉而得到广泛应用[1] 。

In vertebra with heterogeneous bone structure, balloon expansion may be nonuniformly as a result of this heterogeneity and could result in inadequate fracture reduction.

当椎体骨质结构不均匀时，可能导致球囊不均匀的膨胀，造成骨折复位不充分。

Methods the positioning nystagmic features in 131 patients with bppv treated between april 2004 and march 2006 were recorded and analyzed with video- nystagmography.

对我科2004年4月—2006年3月就诊的bppv 病人131例，应用红外线视频眼动记录分析变位试验诱发的眼震特点，进行分型、定侧，并采用相应的耳石复位技术治疗。

Methods The positioning nystagmic features in 131 patients with BPPV treated between April 2004 and March 2006 were recorded and analyzed with video- nystagmography. After the BPPV types and the affected side were determined, the appropriate repositioning maneuvers were chosen and performed.

对我科2004年4月—2006年3月就诊的BPPV 病人131例，应用红外线视频眼动记录分析变位试验诱发的眼震特点，进行分型、定侧，并采用相应的耳石复位技术治疗。

［Objective］ To analyze the outcome of internal fixation for occipitalization with atlantoaxial joint dislocation by posterior decompression and occipitocervical fusion ［Method］ From December 2005 to June 2007,8 patients with occipitalization and atlantoaxial joint dislocation received removal of the posterior arcus of atlas and the enlargement of the posterior edge of the foramen magnum after skull traction performing for an average of 135 daysAll patients were operated on by posterior craniocervical fusion using cervifix internal fixation system and autologous ilium graftsThe clinical efficacy after operation was analyzed by Japanese Orthopaedic Associationneural function score ［Result］ All the patients were followed up from 6 months to 2 years, average of 15 monthsNo complication was foundAtlantodental interval was 5~9 mm before and 4~6 mm after skull tractionAtlantoaxial joint dislocation didn't completely reducedThe neurological defects were improved to some extents according to the JOA scoreImageology showed all patients had full decompression and bony fusionThe loosening or broken internal fixation was not found ［Conclusion］ Posterior decompression and fusion is a feasible method for the treatment of occipitalization with atlantoaxial joint dislocation,and the clinical effect is satisfactory

分析后路减压枕颈融合内固定术治疗合并寰枢关节脱位的寰椎枕骨化临床疗效。［方法］2005年12月至2007年6月间，对8例合并寰枢关节脱位的寰椎枕骨化患者在行颅骨牵引治疗一段时间（12~16 d，平均135 d）后采用枕骨大孔后缘扩大，寰椎后弓切除减压取自体髂骨枕颈融合Cervifix系统内固定术，手术后采用日本骨科学会神经功能评分分析临床疗效。［结果］8例患者随访6个月~2年，平均为15个月。8例患者无一例出现术后并发症，术前寰齿前间隙为5~9 mm，经颅骨牵引后为5~7 mm，寰枢关节脱位未能完全复位。手术前后JOA评分示神经症状均有不同程度恢复，影像学检查示枕颈区减压充分植骨区获得骨性融合，无一例出现内固定松动或断裂。［结论］合并寰枢关节脱位的寰椎枕骨化患者术前仔细评估影像学改变，采用颅骨牵引一段时间后行后路减压枕颈融合内固定术的治疗方案是合理可行的，且临床效果满意。

First, it analyses all-around design of the electronic computer-based interlocking system and each module, then from introducing CAN bus, it lucubrates design of the censorial module's software and hardware which is based on CAN bus of signal lamp's stimulant state, then the hardware's circuit of the entire system's censorial module is made up of opsonic circuit, collecting circuit, microcontrolled circuit,circuit of communication, interrupt circuit of overcurrenting and reset circuit.

首先对全电子计算机联锁系统的总体设计及各个执行模块进行全面的分析和研究，然后通过介绍CAN总线技术，着重研究了基于CAN总线的信号灯模拟状态监测模块的软硬件设计，其中整个系统监测模块的硬件电路主要由硬件调理电路、采集电路、微控制电路、通信电路、高过流中断电路、复位电路等部分组成。

First it analyses all-around design of the electronic computer-based interlocking system and each module then from introducing CAN bus it lucubrates design of the censorial module's software and hardware which is based on CAN bus of signal lamp's stimulant state then the hardware's circuit of the entire system's censorial module is made up of opsonic circuit collecting circuit microcontrolled circuitcircuit of communication interrupt circuit of overcurrenting and reset circuit.

首先对全电子计算机联锁系统的总体设计及各个执行模块进行全面的分析和研究，然后通过介绍 CAN总线技术，着重研究了基于 CAN总线的信号灯模拟状态监测模块的软硬件设计，其中整个系统监测模块的硬件电路主要由硬件调理电路、采集电路、微控制电路、通信电路、高过流中断电路、复位电路等部分组成。

First, it analyses all-around design of the electronic computer-based interlocking system and each module, then from introducing CAN bus, it lucubrates design of the censorial module%26rsquo;s software and hardware which is based on CAN bus of signal lamp%26rsquo;s stimulant state, then the hardware%26rsquo;s circuit of the entire system%26rsquo;s censorial module is made up of opsonic circuit, collecting circuit, microcontrolled circuit,circuit of communication, interrupt circuit of overcurrenting and reset circuit.

首先对全电子计算机联锁系统的总体设计及各个执行模块进行全面的分析和研究，然后通过介绍CAN总线技术，着重研究了基于CAN总线的信号灯模拟状态监测模块的软硬件设计，其中整个系统监测模块的硬件电路主要由硬件调理电路、采集电路、微控制电路、通信电路、高过流中断电路、复位电路等部分组成。

All rats were fed under the same conditions for 7 days and sacrificed. Bilateral orchidectomy was performed and germ cell apoptosis was detected.

按Turner法建立睾丸扭转／复位模型，所有大鼠均在同等条件下喂养至术后7 d处死，切取双侧睾丸后检测凋亡指数。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。