处理方法

The results show that the morphological speech processing is feasible and superior to the traditional method in some aspect.

实验结果表明，这种基于形态滤波的非线性语音处理方法是可行的，而且在某些方面要优于传统的处理方法。

The acquisition of signal and several processing methods for Laser Doppler signal are introduced in chapter 4, and the Short-time Fourier Transfer method are tried to process the high frequency, wide bandwidth, wide dynamic range and nonstable signal of this system.

第四章介绍了对信号的采集和几种常用的多普勒信号处理方法，并根据本系统信号的高频、宽带、大动态范围、非平稳的特点，提出了采用短时傅立叶变化的方法来对信号进行处理，从而得到振动位移的变化情况。

A DPLS discriminant analysis model was developed based on spectra region from 400 nm to 2 498 nm with mathematic pretreatment 2-8-6-1 and scatter correction treatment the standard normal variate. The accurate discriminant rate of calibration and external validation was 95.7% and 95.6% respectively. For the adulterated samples (MBM mass percentage≥5%), the accurate discriminant rate was 100%.

建立的判别分析模型：数学预处理方法为2-8-6-1，散射校正方法为变量标准化处理，光谱范围为全谱（408～ 2 492 nm），定标模型的正确判断率为95.7%，外部验证正确判断率为95.6%，对于掺入量≥5%MBM时，正确判断率为100%。

It separates the network into symmetrical parts and unsymmetrical parts,synthetically uses sequence compo nents an d phase components.In the sequence domain,it equals the symmetrical parts to its boundary nod es;in the phase domain,with the po lym orphic calculationtechnique,it deals wi th all kinds of faults directly without huge calculating work as it is in the conventional phase compo nents methood.The example shows the advantages of this improved method.

该方法以相分量故障处理方法为依据，在序坐标下化简对称部分，等效到其边界节点，在相坐标下对化简后的网络处理各种简单和复杂故障，采用多态计算技术，以矩阵变换代替传统的数值方程的计算，避免了相分量法计算量大的缺点。

This paper mainly discusses the overset mesh pre-processing technology, and supplies a new efficient and robust hole-cutting algorithm applied in the overset mesh preprocessing, which is based on maze algorithm and can be easily implemented with low complexity.

本文主要讨论重叠网格预处理方法，并提出迷路算法应用于"挖洞"过程，为重叠网格预处理提供了高效、可靠的"挖洞"方法，算法复杂度低，实现简单，健壮性好；在多层次嵌套重叠方面，引入了重叠网格主从关系图有效解决多层次嵌套重叠带来的问题；在提高找重效率方面，建立基于网格的kd树加快了找重过程。

There are many methods of foundation consolidation for civil engineering, such as soil exchange method, prepress method, dynamic consolidation method, vibrancy rushing method, soil and podsol dense pile method, sand pile, cement-coal-powder and gravel pile method, deep mixing method, high-pressure eject masonry, etc.

目前国内外地基处理的方法很多，主要的地基处理方法包括：换填法、预压法、强夯法、振冲法、土和灰土挤密桩法、砂桩法、水泥粉煤灰碎石桩法、深层搅拌法以及高压喷射注浆法等。

It's pointed out that soft sensor will play more important role in field bus network control system. According to this, a crude solution was addressed. At last, we point out that soft sensor technology must used to build an information warehouse for the whole enterprise, combined with data fusion, data warehouse, data rectification and other related technologies. The main contributions of this dissertation are as follows: The background, requirement, and application situation of soft sensors are expounded, the theories, methods and skills of soft sensing technology are analyzed, and the fruits and problems in current soft sensor technologies are summarized. Some new methods of soft sensor is proposed: A principal component analysis-based secondary variable selection method are proposed; A new conception which modeling data should have gross error detection is addressed, and then a cluster analysis-based modeling data gross error detection method is given.

本文的主要贡献有：对软测量技术根据实践的要求进行了一定的理论研究，针对具体问题提出了新的方法：讨论了辅助变量选择问题，研究了基于主元分析的辅助变量选择方法，该方法克服了传统方法只能利用数学模型产生的仿真数据进行最优辅助变量选择的缺点，可以根据历史数据进行辅助变量选择；提出了建模数据显著误差侦破的概念，指出传统的显著误差侦破研究的是已知过程数学模型的情况，而建模时数学模型是未知的，但是直接来自现场的数据并不能保证不含显著误差，并用基于聚类分析的方法解决了该问题，该方法利用聚类分析原理，直接面对过程数据，不需以过程模型为基础，在此基础上给出了软测量建模过程中样本数据的处理方法。

Finally the system frame and the hardware are given and the principium of measuring speed and range method is introduced.

并且将多普勒处理的方法扩展至一般的编码信号，从而使该种处理方法能适用与所有的相位编码信号。

The writer carries on processing to the Laichau area ETM remote sensing phantom data with application digital image processing method, and has obtained the good effect. She has withdrawn the mineralization alteration information and strengthened the loop of wire phantom characteristic. She has verified the golden ore deposit was in the loop of wire structure connection, the junction cuts as well as the ring structure edge spot. With the aid of in the remote sensing study information analysis method, the writer withdraws the mineralization advantageous loop of wire structure from the remote sensing phantom, and uses the mineral resource appraisal analysis system MORPAS software developed by China University of Geology to linear structure quantitative, gained massive quota information related with the gold mineralization.

本文应用数字图像处理方法对莱州地区的ETM遥感影像数据进行处理，取得了较好的效果，提取出了矿化蚀变信息并增强了线环影像特征，已探明的金矿床均处于线环构造交汇、交切以及环形构造边缘部位；借助于遥感地学信息分析方法，从遥感影像中提取成矿有利的线环构造，并利用中国地大开发的矿产资源评价分析系统MORPAS软件对线性构造定量化，获取了大量与金矿化有关的定量信息。

Then, the detail progress of 2D FEM is presented, such as the discrete method of 2~ order isoparametric element and the disperse program using scalar quantity.

然后对二维有限元的处理方法展开说明，给出了二阶等参元剖分算法和标量离散化处理方法。

As she looked at Warrington's manly face, and dark, melancholy eyes, she had settled in her mind that he must have been the victim of an unhappy attachment.

每逢看到沃林顿那刚毅的脸，那乌黑、忧郁的眼睛，她便会相信，他一定作过不幸的爱情的受害者。

Maybe they'll disappear into a pothole.

也许他们将在壶穴里消失