处理

Its test result, after using agent of sewage disposal of biology of carapace god ocean and technology of flood body rehabilitate, build good oxygen biology to stabilize a bed, processing sewage effect is apparent, expression is: Black smelly sewage is rapid decolour, deodorization, become clear, insipidity, the COD after handling two days by 333 drop 76, achieve view and admire water and the water quality demand that breed water, can develop aquatic substance. A green alga, red snapper grows to feed after 4 days wait for primary live thing, breed the water biology such as water hyacinth to be able to put in a suitable place to breed view and admire a fish.

其试验结果，运用甲壳神海洋生物污水处理(通过物化方法去除水中一些物质的过程)剂和大水体修复技术后，建立好氧生物稳定床，处理污水效果明显，表现为：黑臭的污水迅速脱色、脱臭，变得澄清、无味，处理两天后COD由333下降到76，达到观赏水和养殖水的水质要求，可培养水生物。4天后长出绿藻、红鱼食等初级生物，养殖水葫芦等水生物并可放养观赏鱼。

Experimental results show that the water velocity is that when the BV ammonia concentration of 50 mg, L - 1 simulation wastewater and 98 mg, L - 1 point of industrial wastewater, penetrate respectively C/C0 = 0.3 and 0.15, water column of natural zeolite could handle respectively; 126 BV, 43 BV Modified zeolite column can handle respectively 157 BV, water, and with 46 BV hydraulic load increases, zeolite column can reduce water treatment, The experiment was found to leak after 8 NaCl solution with zeolite desorption regeneration effect is good, low cost, regeneration of zeolite adsorption capacity decrescent, Test through dynamics analysis found that zeolite column of ammonia nitrogen adsorption fast.

实验结果表明，进水速度为2.72 BV时，通入氨氮浓度为50 mg·L-1的模拟废水和98 mg·L-1的工业废水，此时穿透点分别为C/C0=0.3和0.15时，得到天然沸石柱可处理水量分别为126 BV、43 BV；改性后沸石柱可处理水量分别为157 BV、46 BV，且随水力负荷增大，沸石柱可处理水量减小；试验还发现对泄露后沸石用8%NaCl溶液解吸再生效果好，成本低，再生后的沸石吸附容量变小；试验通过动力学分析发现沸石柱吸附氨氮速度较快。

The thermodynamics quantities were calculated based on the first relaxation process. The results indicated that active enthalpy△H and active entropy △S all decreased with the increase of decrystallization extent. And, it was concluded that the relaxation process of untreated wood is for endothermic reaction and that of treated wood for exothermic reaction.

并通过计算获得了第一个松弛过程的各个热力学量，活化焓△H和活化熵△S都随着非晶化处理程度的增加而减小，未处理木材的松弛过程为吸热反应，而处理木材的松弛过程为放热反应。

Changes in Xc for different pulp cellulose fibers are not the same during the ultrasonic treatment. Crystallization and decrystallization may both exist during the treatment at the conditions of lower-intensity ultrasonic wave. After treatment with ultrasonic Xc of MBKP cellulose is decreased and that of EBKP is increased. The changes of Xc of different pulp cellulose are more closely correlated to the fibers' morphology size and the cavitation state. The maximum Xc of 84% is obtained when BEKP cellulose is treated under the conditions of ultrasonic frequency f=23-25kHz, power=400w, and treatment time t=720s.

不同原料来源的纤维素纤维，由于形态尺寸和超分子结构的差异，经超声波处理后超分子结构表现出不同的变化规律；超声波处理过程中，结晶和消晶两种作用同时存在；超声波功率对纤维素的结晶度有较大的影响，对晶体尺寸有一定程度的影响，但结晶度Xc与超声功率没有线性关系；在频率为23-25kHz，功率为400W条件下，对桉木漂白浆纤维进行超声波处理，可获得高结晶度（84%）的纤维素样品。

And the frontal technique is adapted to solve the FE equations. The techniques are studied to deal with the large slip frictional contactproblems between a deflectable body with large deformation and a rigid bodywith flat or curved surface. A new algorithm is presented to resolve such contactproblems, including incremental displacement constraints and force constraints,and the modules are programmed. The performances of tire under static load invertical loading state and camber state are analyzed by this method. And theexperiments were carried out at the same condition as used in analysis process.

研究了大变形柔性体与具有平面及曲面外形刚性体之间的大滑动摩擦接触问题，提出了求解这类接触问题的位移增量约束和主动力增量约束处理方法；编制了大变形柔性体与具有平面及曲面外形刚性体之间的大滑动摩擦接触问题求解模块；利用本文提出的大滑移接触问题处理方法，分析了轮胎在径向静载和静态外倾加载条件下受力和变形，并对部分分析结果进行了试验验证，验证结果表明，本文提出的位移增量约束和主动力增量约束处理接触问题的方法是正确可靠的，而且具有精度高、收敛性好、收敛速度快的优点。

Kinetics conditions for different disposing containers and methods are compared to choose pretreatment container as follows: desulphurization by KR in ladle, desiliconization and dephosphorization in converter.

对不同处理容器、不同处理方法的动力学条件比较得出预处理容器应选定：铁水包 KR 脱硫，专用转炉脱硅、脱磷。

In this article, by comparative research of the basic principles, agents, methods and effects of the hot metal pretreatments of desiliconization, dephosphorization and desulphurization, the writer defines that the converter-shaped pretreatment of desiliconization, dephosphorization and desulphurization has become the key pretreatment technique of the hot metal for its fine effect, low cost, and outstanding economic and environmentally friendly advantages.

本文通过对铁水预脱硅、脱磷、脱硫基本原理、预处理剂、预处理方法和处理效果的比较研究，明确了转炉型&三脱&工艺因其效果好，成本低和突出的经济、环保优势成为铁水&三脱&预处理的主流工艺。

Based on the production data of desiliconization, dephosphorization and desulfurization in torpedo car , the additional desiliconization, treatment efficiency of dephosphorization and desulfurization, temperature drop and oxygen ratio is analyzed, and the effect of less slag converter refining with the desiliconized,dephosphorized and desulfurized hot metal is also presented.

依据混铁车内&三脱&生产实绩对铁水预处理过程中的补充脱硅，同时脱磷、脱硫处理效率、铁水温度、气氧比等工艺问题进行了分析讨论，同时也介绍了转炉使用&三脱&处理铁水进行少渣冶炼的效果。

It also described diatomaceous earth in processing wastewater aspect basic characteristic and application prospect.

利用硅藻土作吸附剂研究处理含铬电镀废水，介绍含铬电镀废水处理的一些常用方法，硅藻土在处理废水方面的基本特征和应用前景。

The teaching and learning action based on network becomes popular in current high school, by the didactical feedback information of all kinds can be obtained after the processing of education information.It can provide the scientific and effective instruction for the teaching and the learning. This paper focused on the education information processing method and the realization technology with middleware based on network.

基于网络环境的教学活动在高校日益普及，通过对网络教学环境中教育信息的处理得到的各类教学反馈信息能为教师施教和学生学习提供科学有效地指导作用，本文在研究网络教学环境中的教育信息处理方法的基础上，结合中间件技术重点探讨了数学处理方法在网络平台的实现技术。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。