壳轴

The main components have impeller, pump shell and the seal device.

重要部件有叶轮、泵壳和轴启安装。

The main components have impeller, pump shell and the seal device.

重要部件无叶轮、泵壳和轴启安装。

The mechanism was optimized by taking the position of the key shaft as the design var...

以操作机构的关键轴的位置为设计变量，进行了机构的优化设计，为国内开发新一代低压塑壳断路器提供参考。

The driven shaft and head discs are eccentric to the shell.

驱动，轴和头部光盘偏心，以蚬壳公司。

The twin vortex at the tip clearance of hub side and the asymmetric recirculation at wall of inlet duct are also observed. 4 The mass-weighted average of flow parameter at inlet and outlet of every passage of impeller changes with different positions. In addition to the above, with the unsteady method, the head rise, shaft power and efficiency have been predicted well.

再次，采用整机非定常计算准确预测了三种工况下部分流泵的扬程、轴功率和效率；发现了叶轮进出口质量加权平均的速度、压力、动量矩的宏观不变特性；蜗壳内流动的非定常性对部分流泵的外特性有重要的影响。

Screw pump the working principle is: screw pump work, the liquid after being inhaled into the screw pump shell and sealed by Wai space, when the initiative screw rotation, the screw pump seal volume in the squeezed increase Luoya Screw pump pressure, and along the axial movement.

螺杆泵的工作原理是：螺杆泵工作时，液体被吸入后就进入螺纹与泵壳所围的密封空间，当主动螺杆旋转时，螺杆泵密封容积在螺牙的挤压下提高螺杆泵压力，并沿轴向移动。

Based on the multi-layer shell element model that is now widely used in the nonlinear analysis for the shear wall structure,different constitutive models of concrete and reinforcement are discussed in this paper.Selected in this discussion were two models:a new constitutive model for concrete,referred as microplane model,which could precisely simulate the nonlinear behaviors of concrete under complicated stress conditions,and a constitutive model for reinforcement,which could accurately modeling the hysteretic behaviors of the reinforcement.Some shear wall tests were analyzed to demonstrate the precision of the proposed model.

在适用于剪力墙结构非线性分析的分层壳墙单元模型基础上，对其中的混凝土本构模型和钢筋本构模型进行讨论，采用一种能较好的模拟混凝土在多轴复杂应力状态下特性的microplane模型和一种能够全面反映钢筋在往复载荷下各种复杂受力特性的钢筋本构模型，分别模拟混凝土和钢筋的力学行为特征。

The differential case supports the differential-pinion gear on a shaft, and this gear meshes with the two bevel gears.

差速器壳支承在行星齿轮轴上，行星齿轮与两个半轴齿轮相啮合。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。