壳体

All cover of water tank, casing and internal tube-bearing board shall use non- magnetic conductive stainless steel

水箱盖、壳体及内部承管板等构件全部采用非导磁不锈钢材料。

Condenser is made up of heat exchange components, tube-bearing board, cover of water tank, casing of condenser and airproof parts, etc.

冷凝器由换热元件、承管板、水箱盖、冷凝器壳体和密封件等组成。

Which fixed plate heat exchanger for both the shell and tube sheet connected into one, simple structure and low cost advantages, Therefore, using the more widely.

其中固定管板式换热器为两端管板和壳体连接成一体，具有结构简单和造价低廉等优点，因此使用较为广泛。

Beam and truss designs are obtained under nominal loading,under uncertain loading while employing the convex model,and under uncertain loading using the maximum load condition.

梁和珩架的设计是通过应用凸壳体模型进行名义加载，不定量加载，以及通过在最大加载条件下不定量获得的。

The dual-input clutch is mounted to the transmission pump housing for structural support.

双输入离合器被安装在变速器泵壳体以在结构上支撑。

The pump pulley and the transmission gearbox shell is united as one body, fixes behind the engine crank on the flange.

泵轮与变速器壳体连成一体，固定于发动机曲轴后端的凸缘上。

If the Bolts are tightened under such circumstances, the transmission case may be Broken.

如果在这种情况下紧固螺栓，变速器壳体就会破裂。

If the Bolts are tighten ed under such circumstances, the transmission case may be Broken.

如果在这种情况下紧固螺栓，变速器壳体就会破裂。

If the Bolts are tightened under such circumstance s, the transmission case may be Broken.

如果在这种情况下紧固螺栓，变速器壳体就会破裂。

Section views of the casting along with X-ray photographs can be seen in Figure 3. A pressure-tight power train casting, the oil pump filter housing requires leak tightness at 5 bar.

铸件剖面及铸件 X 射线照片如图3所示，此产品是需要承受高压的铸件，油泵过滤器壳体需要的防漏压密封压力为5 bar 。

Neither the killing of Mr Zarqawi nor any breakthrough on the political front will stop the insurgency and the fratricidal murders in their tracks.

在对危险的南部地区访问时，他斥责什叶派民兵领导人对中央集权的挑衅行为。

In fact,I've got him on the satellite mobile right now.

实际上 我们已接通卫星可视电话了