壁内的

It contains quadratic photosynthetic chamber and columned soil fixing body, wherein soil fixing body of canopy leaf chamber bottom set with knob basal portion being corrugation notch, capable of easy inserting amboceptor in soil to form inclosed canopy leaf chamber, amboceptor upper port inosculation with photosynthetic chamber lower wall round opening to make canopy leaf chamber intracavity forming one integral, photosynthetic chamber upper wall sealed by two side glue and photosynthetic film to ensure photosynthetic chamber steady light permeability, photosynthetic chamber sidewall installed one small size fan controlled by external battery and switch, fan capable of rapid making canopy leaf chamber gaseous reaching equalization.

本发明涉及一种用于测定植物冠层群体光合作用的冠层叶室，由正方形的光合室和圆柱状的土壤固定体两部分结合而成，冠层叶室下部土壤固定体设有把手，基部为波纹状切口，可以很容易地把固定体插入土壤中形成密闭的冠层叶室，固定体上口与光合室底壁的圆形开口吻合，使冠层叶室的内腔形成一个整体；光合室顶壁用双面胶和光合薄膜密封，以保证光合室稳定的透光性能；光合室侧壁内安装一个小型风扇，由装在侧壁外的电池和开关控制，风扇可使冠层叶室内的气体迅速达到平衡。

Results: In all 13 patients, non-contact mapping showed AFLs confined to the RA with the cycle length (230 ±20 ms). 6 patients presented single-loop re-entry circulating around the central obstacle in the anterolateral wall through the channel between the CO and the crista terminalis .Seven patients presented "8" re-entry, and the gap of upper and lower loop located in CT in 4 cases, another 3 cases with upper loop and free-wall single-loop re-entry. RF of CT gap and/or the free-wall channel was effective in eliminating these AFLs in 13 patients.

结果 经 NMS标测证实13例患者折返均在右房内，激动在右房内的折返平均时间为230±20ms.6例房扑患者为单折返环，围绕右房中心障碍区折返，激动在心房的前壁穿过中心障碍区与界瘠之间的狭窄通道。7例患者证实为2个折返环，其中4例表现为上下折返环形成"8"字形折返，共同的传导通道在界瘠；另外3例表现为折返环1个在心房上部，1个在前游离壁。13例消融界瘠或前游离壁后房扑终止。

scatheless measurement ; numerical simulation ; helium pressure

利用氦气在不同压力下具有不同的状态参数和热力参数，可以通过传热方法测量包壳内的氦气压力。1试验装置和研究方法如图1，把燃料棒浸入到一个高温的池子内，热量会在燃料棒内传递开来，通过测量管壁外面不同位置出的壁面温度，就可以推测到包壳内的氦气压力

The spermatozoa are embeded in a extracellalar matrix composed of high dense fibrils matrix and flocculent and concentric vesicles similar to that in the primary spermatophore layer, but the later lack of spermotozoa. The flocculent and concentric vesicles are often seen to release their contents around the main body of spermatozoa. The spermatozoa may absorb the contents to form vesicular zone and membrane zone in sperm nucleu. The secondary spermatophore layer is distinctly subdivided into inner region and outer region. The loose outer region consists of canaliculated reticulum and large flocculent vesicles.

输精管内的精荚为管状，由精子群、精荚基质及初级精荚壁和次级精荚壁组成，初级精荚壁与精荚基质是相连续的，它们之间无明显界限，两者均由电子密度较高的纤丝状基质和絮状泡和同心圆泡组成，但后者不含精子，后者中的絮状泡和同心圆泡常在精子主体部周围释放内含物，可能与形成精子细胞核中的泡状带和膜状带有关，在交配后的雌虾，其头胸部腹面上粘着的精荚中，其基质内已不见絮状和同心圆泡，仅见稀疏的纤丝。

The typical structural characteristics of oil cells include, presence of a tripartite cell wall, in which the outer and inner layers are cellulose, the middle layer is a suberin layer lamellated; presence of a cupule attaching the oil vacuole to the wall; presence of plasmodesmata occurring in wall protuberances, which is coursed by the suberin layer.

成熟油细胞结构的典型特征是：具有三层暗明暗相间的细胞壁，内外两层是纤维素壁层，电子不透明，中间一层是电子透明的木栓质化壁层，由明暗相间的片层结构组成；细胞腔被油囊充满，它由一个细胞壁向内突起的杯形构造连接于细胞壁上：胞间连丝发生于由木栓质化壁层形成的一个向内的突起中。

The existence of larger size vortexes was identified as the major cause of wall-wetting according to the investigation of a DSI FGD reactor from NFK Co., Japan. Another cause is dewing results from the great temperature difference between the reactor wall and the main flow.

通过对一套工业试验性半干半湿FGD系统反应塔湿壁现象的测试分析发现：塔内涡流滞流区的存在，是湿壁的主要原因；塔壁与主流间过大的温差也经常导致结露湿壁。

The inside surface difference between flank-extrados and flank-intrados of any section of loop shell should induce the force difference when the loop shell under internal pressure. The force difference in ring shell can balance itself.

对于内压作用下的任何弯管，因为弯管中线上径向向外的管壁表面积均要比中线上径向向内的管壁表面积大，两者面积之差在同一内压作用下产生面积压力差。

The experimental investigation demonstratesthat (1) the critical perforation energy of pressure pipelines (D/H=15) with pressure OMPa under lateral impact of flat-nose and spherical-nose indenters ranges from 2~3%,the critical perforation energy of empty pipelines is higher 1 ~2% than pipelines filled in water without pressure.

实验研究结果表明：(1)当管梁内注满水，预加工作内压P=0MPa时，对于径厚比D／H=15的厚壁圆管，在平头弹体和球形弹体两种弹体冲击作用下临界穿透破坏能量的降幅在2～3％之间：锥头弹体冲击厚壁空管的临界穿透能量比充水预加内压为P=0MPa的圆管高1～2％：(2)充水管道的预加内压提高，临界穿透能量有一定降低。

The thermal boundary condition of the cast iron cooling stave with surface alloyed steel pipe was used for numerical simulation of temperature field and commercial software ANSYS and the method of coupling heat-structure were used to calculate thermal deformation of steel pipe at high temperature,and analyze the influence of air gap and thermal deformation on the life of cooling stave.The optimal size of air gap and hot load to guarantee long life of cast iron cooling stave were obtained.

根据合金化管铸铁冷却壁热态试验数据确定了合金化管铸铁冷却壁温度场数值模拟的边界条件，利用ANSYS软件、采用热-结构耦合的方法计算了高温状态下合金化管铸铁冷却壁内钢质冷却水管的变形，分析了气隙层和水管热变形对合金化管铸铁冷却壁寿命的影响，得出保证合金化管铸铁冷却壁长寿的最佳气隙层厚度和相应的最佳使用热负荷。

The thermal boundary condition of the cast iron cooling stave with surface alloyed steel pipe was used for numerical simulation of temperature field and commercial software ANSYS and the method of coupling heat-structure were used to calculate thermal deformation of steel pipe at high temperature,and analyze the influence of air gap and thermal deformation on the life of cooling stave.

根据合金化管铸铁冷却壁热态试验数据确定了合金化管铸铁冷却壁温度场数值模拟的边界条件，利用ANSYS软件、采用热-结构耦合的方法计算了高温状态下合金化管铸铁冷却壁内钢质冷却水管的变形，分析了气隙层和水管热变形对合金化管铸铁冷却壁寿命的影响，得出保证合金化管铸铁冷却壁长寿的最佳气隙层厚度和相应的最佳使用热负荷。

Plunder melds and run with this jewel!

掠夺melds和运行与此宝石！

My dream is to be a crazy growing tree and extend at the edge between the city and the forest.

此刻，也许正是在通往天国的路上，我体验着这白色的晕旋。