增长速率

Parasitic wasps in the two post-embryonic development, the young bee body protein content is increasing day by day, parasitized the same time, David Bee Ichneumonidae protein accumulation to be significantly higher than gifuensis David Bee, and the growth rate of the former significantly larger than the latter.

在两种寄生蜂胚后发育的过程中，幼蜂体内蛋白含量均是逐日增加的，寄生后相同的时间内姬蜂幼蜂蛋白积累要明显高于茧蜂幼蜂，且前者的增长速率也明显大于后者。

The kinetically controlled molecular weight profiles and relative initiation versus propagation rates of REMP resulted in polymer Mw values that increased with decreasing initial concentrations.

动力学控制的分子质量曲线和 REMP 相对初始与增长速率的比值导致聚合物 Mw 值随着初始浓度的降低而增加。

Six bacteria and five mildews have been separated from 119 strains, wliich grew well on the culture media contained lignin. The result of taxonomic identification is that XI, X2 and X3 belong to Pseudomonas, X4 and X5 belong to Xanihomonas, X6 belongs to Mycoplana. A preliminary study has been carried out on the capacity of lignin degradation of the 6strains of bacteria, and strains X2 and X4 were chose to carry out the experiments. The most favorable temperature for the 2 strains is 30癈, and the pH is 7; After being treated by ultraviolet rays, activity of all the three kinds of lignin-degrading enzyme produced by the strains can be increased greatly, the bacteria increasing rate is remarkably improved.

从119个菌株中分离筛选出了6株细菌和5株霉菌，它们可以在含有木质素的培养基上良好生长：细菌分类学鉴定结果为X1、X2和X3：假单胞菌属，X4和X5：黄单胞杆菌属，X6：枝动杆菌属；对6株细菌降解木质素性能进行了初步的研究，选定X2和X4为实验用菌种，两株菌适宜的生长温度为30℃，最适初始pH值为7；经紫外线照射诱变法处理，可使它们产生的三种木素分解酶活性均有明显的提高，细菌增长速率比诱变前明显提高。

The effect of P was analyzed from several aspects of cells number, increase rate of algae and maximum standing stock of S. obliquus.

方法］从斜生栅藻细胞数目、藻比增长速率和藻最大现存量几个方面对磷的影响进行分析。

The exact position where pear scab parasite in leaves was pectin layer.The primary injections of V.nashicola to resistant,suspectible and non-host materials were similar,the increasing rate of subcuticular hyphae on suspectible material is far higher than resistant and non-host material,and dead hyphae appeared on resistant and non-host material,which indicated that resistance expressed after hyphae had invaded cuticular.

梨黑星菌在叶片中寄生的具体位置是果胶层。V.nashicola对抗性、易感和非寄主材料的初期侵染相似，当真菌侵入角质层之后，亚角质层菌丝在易感材料中的增长速率远远高于抗性和非寄主材料，并且在抗性和非寄主材料上出现死亡菌丝，这些都表明抗性是在真菌侵入角质层之后表达的。

US officials have told their counterparts that if other sources of domestic demand do not emerge to fill the gap left by a retrenching US consumer, the trend rate of global growth could fall from 4 per cent plus to 3 per cent or less for many years.

美国官员已经向其他国家的同行表示，如果未能从其它来源出现国内需求以填补美国消费萎缩留下的缺口，全球经济增长速率可能会从逾4%减缓至3%或更低，并持续数年。

While Leaf of middle type variety LiaoDan 527 and thin density variety DanYu 39 would drop rapidly after tasseling stage, duration of larger leaf area was short. LAI increased along with the density increase. The increasing rate of LAI was bigest at jointing stage and droped at tasseling stage.

中间型品种辽单527和稀植品种丹玉39都是在抽雄以后就迅速下降，单株叶面积较大值维持时间较短；LAI随着密度的增加而增大，以拨节期-抽丝期增长速率最快，抽雄期以后开始下降。

The batch activated sludge method was used to determine autotrophs maximum growth rate. In addition, affecting factors were also investigated.

采用间歇式活性污泥法测定了自养细菌最大增长速率，分析了测定过程中的影响因素。

The results show that autotrophs maximum growth rates varied from 0.32 d^(-1) to 0.54 d^(-1) and the average rate was 0.45 d^(-1) at 20℃.

试验结果表明，硝化系统内自养细菌最大增长速率在20℃时的变化范围为0.32~0.54d^(-1)，平均值为0.45d^(-1)。

The factors, such as temperature, dissolved oxygen concentration, autotrophs concentration, initiative ammonia concentration and organic substance had remarkable influences on autotrophs maximum growth rate.

温度、溶解氧、接种污泥浓度、起始氨氮浓度以及污水中的有机物均会对自养细菌最大增长速率的测定产生重要影响。

Finally, according to market conditions and market products this article paper analyzes the trends in the development of camera technology, and designs a color night vision camera.

最后根据市场情况和市面上产品的情况分析了摄像机技术的发展趋势，并设计了一款彩色夜视摄像机。

Only person height weeds and the fierce looks stone idles were there.

只有半人深的荒草和龇牙咧嘴的神像。