增热

In addition, the thermal pressure coefficients and densities of eight plasticizer over the temperature range of 25-85℃ have been measured.

此外，本文还测定了8个增塑剂在25—85℃温度范围的热压力系数和密度值。

The present status of the toughening and thermal stabilization of Polyamide on Polyoxymethylene was reviewed.

综述了目前聚酰胺对聚甲醛的增韧及热稳定作用的研究现状，并对其今后的发展方向进行了展望。

Current research status were summarized on toughened,wear-resistant and self-lubricated,thermal Stability,flame retardancy of polyoxymethylene and its application in PTC condcting material.

综述了聚甲醛的增韧、耐磨改性及改善POM热稳定性、耐候性、阻燃性能的研究成果，介绍了POM用作PTC导电材料的现状。

Results Combined group was much better than radiotherapy group in total effective rate and completely remittent rate,and the time of effect were also shortened compared with control group.Conclusion The combination of two methods is effective and significantly superior to single treatment of radiotherapy.

微波热疗对放疗有协同增敏作用，二者配合对颈部较大淋巴结转移癌的治疗有重要的临床应用价值，可明显提高局控率，减少局部放疗剂量，减轻放疗反应，无明显毒副作用，值得临床推广使用。

For this reason conventional antireflection coating designs developed for thermal evaporation are not ideally suited for DC reactive sputter deposition.

基于这个原因，传统的热蒸发法的增透膜的设计，不适合直流反应溅射沉积。

To realize a better control of corrosion rate, the operation without heat load was adjusted and more corrosion inhibitor synergist was added in addition to corrosion and scale inhibitor.

为较好地控制腐蚀速率，对不带热负荷的运行配方进行调整，在投加缓蚀阻垢剂的基础上增投缓蚀增效剂。

The decomposition temperatures of the main components in TNAZ-CMDB propellants was obtained in the range of 180～235 ℃ at high pressure by PDSC, and TNAZ in the propellants was found to volatilize or sublimate in the temperature range of 70～180 ℃ at common pressure.

微量量热实验研究发现，高压下TNAZ作为增塑剂的无烟CMDB推进剂的分解温度为180～235 ℃，其中TNAZ的分解温度大于220℃，而常压下该推进剂中的TNAZ在70～180℃时即挥发或升华。

The study results indicate that as emission power increases, the peak power density on the section of a certain distance will increase firstly, then it will descend and that the peak light intensity on the section will increase with the increasing of spot radius of basic mode Gaussian beam. As the propagation distance increases, the peak light intensity on the section will descend gradually, and the laser energy will spread. The light intensity distribution exhibits straw hat shape on a certain conditions, in other word to say, the central light intensity is less than acroteric light intensity.

结果表明，无风稳态热晕效应存在时，随发射功率的增大，一定传输距离截面上的峰值功率密度先增人后减小；截面上的峰值光强随基模高斯光束的腰斑半径的增大而增大；随着传输距离的增大，截面上峰值光强在逐渐减小，能量在逐渐向周围扩展；在一定条件下，截面上的光强分布会呈现中心光强小于周围光强的&草帽型&分布。

The data of mechanical properties test proved that the composite materials compounded with 0.39~0.46um PS organic rigid particles at 0.2% and PP have excellent strength and toughness. SEM photograph found that the organic rigid particles were separated into 60~80nm size in the composite by melting process, which has belter toughness compare with the PP compounded with ultra-fine organic rigid particles.

用2％粒径为0.39～0.46um的XPS复合PP，经力学性能测试，有最好的增韧效果；SEM扫描电镜发现，经热加工的复合材料中最小的有机刚性粒子粒径可部分分散到60～80nm，该复合材料比超细有机刚性粒子复合的PP有更好的冲击韧性。

With cellulose as the skeleton, gelatinized cassava starch solution and tungsten carbide were used as porogenic agent and inert densifier, respectively. The matrix prepared showed good sphericity and a logarithmic symmetrical distribution of particle size.

取得的主要结果如下：纤维素基复合层析基质的物理功能化：以再生纤维素为骨架，碳化钨粉末为增重剂，糊化木薯淀粉为制孔剂，采用&反相悬浮热再生法&和成球后去除淀粉方法，成功制备了纤维素/碳化钨复合微球，可用作层析介质的基质。

In the negative and interrogative forms, of course, this is identical to the non-emphatic forms.

。但是，在否定句或疑问句里，这种带有"do"的方法表达的效果却没有什么强调的意思。

Go down on one's knees;kneel down

屈膝跪下。。。下跪祈祷