增大

There were the same load characteristics of 1MW, 1.5MW and 2MW blade model, which the tensile stress, shear stress and torque of section were linearly increased with increasing of wind speed; and tensile stress of all test sections of the blade was changed greatly, but shear stress was basically the same in the same wind speed. The shear stress and tensile stress were increased obviously in the place of 388mm to centre of gyration of wind rotor comparing with other section where the phenomenon of stress concentration had for 1.5MW blade model.

对1MW、1.5MW、2MW叶片模型有相同载荷特性，各截面处的拉应力、剪应力、扭矩随风速增大而增大，呈线性增加规律；在相同风速下，叶片各测试截面的拉应力值变化较大，而剪应力值基本相同，但对1.5MW叶片模型，在距风轮回转中心388mm处与其它截面处的剪应力、拉应力比较明显增大，有应力集中现象。

Decision rule chain and distance function of decision rule are proposed, by which the order of decision rules are explained. The group scale's effect on decision quality and the marginal contribution of decision-makers are analyzed. It's pointed out that the increase of the scale will enhance the decision quality with the optimal decision rule applied. Otherwise it is likely to weaken the decision quality. It's proved that for homogeneous group with simple majority rule applied the marginal contribution of decision-maker will decrease while the scale increases or the decisional competencies of other decision-makers increase; 3.We study the group decision-making with a leader in it. It's proved that the existence of the leader impairs the decision quality when the group applies the optimal decision rule.

研究了决策者的决策能力不确定情况下的群体决策，给出了最优决策规则，指出其仍然是广义加权多数规则；提出了决策规则链和决策规则距离函数的概念，利用这些概念解释了群体决策规则的序现象；分析了群体规模对决策质量的影响、决策者决策能力的边际贡献，指出当群体应用最优规则时，群体规模的增大会提高决策质量，否则群体规模的增大可能会削弱决策质量；证明了对于应用简单多数规则的同质群体，随着其规模的增大，决策者决策能力对决策质量的边际贡献会减小；随着其他决策者决策能力的提高，决策者决策能力对决策质量的边际贡献也会减小； 3。

The effects of the reaction time,the concentration of chloral and the pH on dechlorination were obtained,and the results showed that the dechlorinate effect was obvious.

实验结果表明，还原铁粉对三氯乙醛有明显的脱氯作用，脱氯率随三氯乙醛质量浓度的减小而增大，随pH值的减小而增大，随反应时间的增加而增大。

It is found that the expansion width of the circular frequency optical spectrum of the scattered photons in multiphoton nonlinear Compton effect increases with the incident electron velocity increase and the increase of the photon number by the electron absorpted at the same time,and it red...

结果表明，未被俘获电子使该散射的频谱展宽随入射电子速度和与电子同时作用的光子数的增大而增大，随电子与光子非弹性碰撞成分的增大而减小，从而使能量转换效率近乎与电子入射速度正比降低。

The results show that the flow stress decreases with increasing deforming temperature and increases with increasing strain rate. The flow stress of the alloy during hot compression deformation can be described by constitutive equation in hyperbolic sine function with a hot deformation activation energy of 196.27 kJ/mol. Partial recystallization takes place in the alloys deformed at a high temperature or at a low strain rate, and large number of dislocations and subgrains are observed in the alloy. The elongated grains observed in the samples coarsen with increasing temperature and decreasing strain rate. Correspondingly, the subgrain size increases and the dislocation density decreases. The main soften mechanism of the alloy transforms from dynamic recovery to dynamic recrystallization.

结果表明：Al-Cu-Mg-Ag耐热铝合金在热压缩变形中的流变应力随着温度的升高而减小，随着应变速率的增大而增大；该合金的热压缩变形流变应力行为可用双曲正弦形式的本构方程来描述，其变形激活能为196.27kJ/mol；在变形温度较高或应变速率较低的合金中发生部分再结晶，并且在合金组织中存在大量的位错和亚晶；随着温度的升高和应变速率的降低，合金中拉长的晶粒发生粗化，亚晶尺寸增大，位错密度减小，合金的主要软化机制逐步由动态回复转变为动态再结晶。

The results indicate viscosity coefficient of polymer emulsion

结果表明，乳液的粘性系数随固相材料密度的增大而变小；当固相颗粒数增多或颗粒半径增大时，粘性系数也随之增大。

The results indicate viscosity coefficient of polymer emulsion reduce as the density of granule increases, and augment as the number or the radius of granules increase .

结果表明，乳液的粘性系数随固相材料密度的增大而变小；当固相颗粒数增多或颗粒半径增大时，粘性系数也随之增大。

Results indicate that when the strain rate is 1200 s-1, the twin number of samples in different orientation increases with plastic strain increasing; when the strain rate increases to 2800 s-1, the σ-ε curves have no obvious charges as the angle is 0o and 45o, compared with that at 1200 s-1; however the σ-ε curves vary from concave to convex when the angle is 90o, because thermal softening has occurred with increasing plastic strain, which results in the number of twin decreasing, and smaller strain hardening

结果表明：当加载应变率为1200 s-1时，不同取样方向的样品中孪晶数量均随塑性变形应变量的增大而增多；当加载应变率增大到为2800 s-1时，取样方向为0°和45°、流变曲线形状较应变率为1200 s-1时没有明显变化，而取样方向为90°时曲线形状由应变率为1200 s-1时的凹形变为凸形，曲线形状变化的原因是由于应变量增大，热软化效应使得孪

After deaeration of the 3.5% NaCl solution with nitrogen,only Ψc decreased markedly in comparison with that without deaeration at the same flow velocity.

结果表明：在35% NaCl流动溶液中，随着流速的增大，仅碳钢腐蚀的阴极反应作用系数急剧增大，其腐蚀率也随之增大，流体力学因素主要加速了碳钢腐蚀的阴极反应过程。

The result shows that: The variation rhythm of the sensitivity index changed unanimously for Jensen,Blank and Stewart water production functions of spring wheat in Liangzhou city,the volume is small in the former stage,then become large at the middle stage,and less at the last stage. Jensen and Stewart water production functions are better of spring wheat in Gulang County in 1987-1989. The Variation rhythm of water deficiency sensitive index is unanimous: the volume are small at first,then large at middle,and diminish at last. The Variation rhythm of water deficiency sensitive index is unanimous in Jensen,Blank and Minhas of flax in Liangzhou county in 1987-1989. The water deficiency sensitive index in Gulang district in 1987-1989 models bad,are too many minus.

结果表明：1985-1986 年凉州春小麦Jensen 模型、Blank 模型和Stewart 模型的敏感指数变化规律接近一致，在前期较小，中期增大，最后再减小。1987-1989 年古浪春小麦水分生产函数以Jensen 模型和Stewart 模型拟合较好，其敏感指数变化规律比较一致，敏感指标值前期较小，中期增大，后期又减小。1983-1985 年凉州亚麻水分生产函数以Jensen 模型、Blank 模型和Minhas 模型敏感指标值变化规律比较一致：先减小，后增大，最后再减小。1987-1989 古浪亚麻敏感指数出现负值较多，模型拟合较差。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。