增大

The mass ablative rate of the composite increases when the laser intensity and spot diameter are increased.

而该复合材料的质量烧蚀率随入射激光强度和光斑直径的增大而增大。

The calculated results show that the enhancement factor increases with the increase of absorbability of particles.

计算结果表明：增强因子随微粒吸附容量的增大显著增加；微粒距离气液界面越远，微粒吸附能力对气液传质的增强越小；在相同粒径与微粒距离气液界面距离的条件下，增强因子随微粒在气液停留时间的增加而增加，但是当停留时间超过一定值后，随着停留时间的增加，增强因子下降；粒径增大，增强因子减小。

Therefore, the sum of circumferences of small dot s in fine screen is much greater than the sum of circumferences of large dot s in coarse screen.

即是粗网的网点增大率和比较粗网各点的增大总和为长，所以幼网有较大的网点增大率。

Except cellulose acetate fiber,the strength of other four-kind fibers in completely dry state is decreased notably after MHT.With the initial moisture regain increased,the breaking elongations of cotton,rayon and loycell are improved remarkably after MHT.The increasing level is rayon＞loycell＞cotton,but ramie seems little improved.As the moisture regain is low,the fiber initial modulus is enhanced.However,when the moisture regain is higher,the fiber initial modulus did not change obviously.

除了醋酸纤维素纤维，其余四种纤维在初始回潮率为0的时候，经过微波处理，纤维强度都是显著性下降的：随着初始回潮率的增大，棉纤维、粘胶、天丝的断裂伸长率有了显著性的提高，其中升高的幅度为粘胶＞天丝＞棉纤维，苎麻没有显著性提高；在回潮率较小的范围内，微波处理之后纤维的初始模量是增大的，随着回潮率的增大，初始模量变化不显著。

The esterification reaction and itsinfluencing factors of hexanoic acid with n-butanol, catalyzed by lipaseNovozym100T, were studied in water-in-oil microemulsions formed by alkylpolyglucoside C_(12)G_(1.50)/n-butanol/cyclohexane/water system.

研究发现，十二烷基聚葡糖苷C_(12G_(1.50)／正丁醇／环己烷／H_2O体系形成的油包水微乳液中，脂肪酶Novozym100T催化正己酸和正丁醇的酯合成反应，反应初始速率V_0随正己酸的初始浓度C_~0增大而增大；随正丁醇的初始浓度C_~0的增大而减小，后V_0进入一&坪区&。

The results show that the plasticity zone and dynamically quiescent layer become fine equiaxed recrystallisation under the thermo-mechanical effect, the grains in the heat-affected zone grow up because of the effect of friction heat. When the rotation speed is 2 500 r/min and the welding time is 12 s, good joint is achieved, and the tensile shear strength of the joint reaches 9.24 kN. The tensile shear strength of spot increases with increasing tool rotation speed, with increasing welding time, the strength increases first, while then reduces. The microhardness of plasticity zone is high, but is slightly lower than that of the base metal, the minimum value of microhardness is in the heat affected zone. When the energy input of joint is high, the fracture type of spot is mode Ⅰ, and the tensile shear strength is high; on the contrary, when the energy input of joint is less the fracture type of spot is mode Ⅱ, and the strength is low.

结果表明：塑性区和动态静止层的晶粒在热和力作用下发生动态再结晶形成细小的等轴晶，热影响区的晶粒在摩擦热作用下长大变粗；搅拌头旋转速度为2 500 r/min，焊接时间为12 s时，可以获得力学性能较好的焊点，焊点的剪切强度达到9.24 kN；焊点的剪切强度随搅拌头旋转速度的增大而增大，随焊接时间的延长先增大后减小；塑性区的显微硬度较高，但略小于母材，接头显微硬度的最小值分布在热影响区；焊点热输入量较多时，接头为Ⅰ型断裂，焊点的剪切强度较高；焊点热输入量较少时，接头为Ⅱ型断裂，焊点的强度较低。

The flow resistance of Ice slurry increases if the pipes obliquity increases. That means the ice slurry that in the level pipe has the largest flow resistance, the reason is: the gravitation make the flow became more and more foul-up, accordingly, lead to the increase of flow resistance. Sixthly, introduced all of the preparative tasks before we began the experiment, because we met many problems during the test, we had our own methods which could solve these problems. In this paper, problems and these methods were introduced.

随着管道倾角的增大，二元冰的摩擦阻力减小，也就是说相同条件下水平管道内的摩阻最大，这是因为重力的影响导致管道内二元冰和乙二醇分层现象更加明显，从而导致紊流程度增大，最终使得摩阻增大；第六，对二元冰蓄冷空调系统运行前的准备工作进行了介绍，由于在试验过程我们遇到了很多问题，针对这些问题，我们有自己的方法和解决办法，本文介绍了这些问题和相应的解决办法。

The energy achieves in a big way, for - 1854.458 a.u., EH increases along with the electric field increases gradually, when F=0.01 a.u., the EH value obtains the maximum value, is - 0.2559a.u., continues along with the electric field to increase, energy level EH has the reduction tendency, EL increases along with the electric field reduces gradually.

时能量达到最大，为-1854.458 a.u。，EH 随着电场的增加逐渐增大，在F＝0.01 a.u。时，EH的值取得最大值，为-0.2559a.u。，随着电场的继续增大，能级EH有减小的趋势，EL随电场的增大逐渐减小。

The results indicated that the corn silk extract could not only prohibit the transformation of calcium oxalate monohydrate to calcium oxalate dehydrate, but also reduce the size of COD.

结果显示，这种抑制作用随玉米须浓度增大而增大，且COD晶体尺寸随着玉米须浓度的增大而减小。

Results 1、 Generally, we can see the original blue and white, shiny, no cracks in the articular surface of the cartilage after the stress increases gradually yellow, surface roughness, cracks appear; when the pressure decreases, the yellowing, rough, the color of the fracture restore gradually and become shiny.2、the shiny smooth surface can be seen under a light microscope, formation, cell distribution, tidy, clear the level of cartilage at the articular surface stress increases, the surface roughness changes, defects, disordered cells, uneven dyeing ; when the articular surface of the pressure gradually decreased, the cartilage gradually repair and the surface of cells at the surface appear only disorder.3、immunohistochemical observation can be seen throughout the observation period, cartilage cells are type Ⅱ collagen expression and expression after 3 weeks gradually weakening, when the seventh week begin to strong gradually.4、 electron microscopy shows that when stress increases the articular surface, the cartilage cells became flat, the cytoplasm in the endoplasmic reticulum, Golgi apparatus decreased with collagen disorders; and when stress decreases the articular surface, cartilage cells gradually returned normal, cytoplasm in the endoplasmic reticulum, Golgi body gradually restore quantity; collagen fibers with a gradual rules.

结果：①大体观察可见到原本蓝白色、有光泽、无裂纹的软骨在关节面压力增大后，逐渐呈灰黄色，表面粗糙，出现裂隙；当压力逐渐减小后，变黄、粗糙、有裂隙的软骨颜色逐渐恢复，变得有光泽②光镜下可见表面光滑、平整，细胞分布均匀、整齐，层次清楚的软骨在关节面压力增大后，表面变粗糙、缺损，细胞排列紊乱、染色不均；当关节面压力逐渐减小后，软骨表面逐渐修复，细胞仅在表层排列紊乱③免疫组织化学观察可见整个观察期内软骨细胞胞浆内均有Ⅱ型胶原表达，术后3周内表达逐渐变弱，从第7周时开始逐渐变强。④电镜下可见当关节面压力增大后，软骨细胞逐渐变扁，胞质中内质网膜、高尔基体减少，胶原排列紊乱；当关节面压力减小，软骨细胞形态逐渐恢复正常，胞质中内质网膜、高尔基体数量逐渐恢复；胶原纤维排列逐渐有规则。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。