增大

The results show that the microstructure of the cladding wire by drawing at room temperature is vimineous grain as fibril shape from prime equiaxed grain. The fibril diameter is in inverse proportion to deformation and the fibril length is in direct proportion to the square of deformation approximately. The ultimate tensile strength of the cladding wire by drawing at room temperature goes up in direct proportion to square root of deformation, whereas the elongation decreases and fluctuates.

结果表明：显微组织自原始的等轴晶变为细长条纤维状，纤维直径与形变量近似地成反比，纤维长度与形变量的平方近似地成正比；经室温拉变形的铜包铝线的极限抗拉强度随形变量增大而增大，与形变量平方根呈直线关系；延伸率随形变量增大逐渐降低，但延伸率波动较大。

The new formula shows that the compressibility of vuggy rocks increases with vuggy porosity, and decreases with the increasing hardness of rock matrix.

计算公式显示，溶洞介质的压缩系数随溶洞孔隙度的增大而增大，随基质硬度的增大而减小。

Thermal characteristics of salty soil are researched by TG-DSC technique. The results show that soluble salts have great influence on thermal characteristics of salty soil; water content gets higher, phenomena gets acuter. Freezing force depends on water content and freezing temperature; the more water content or the less temperature is, the more intensive of freezing force is.

运用TG-DSC技术对冻区盐渍土热特性进行分析并研究环境变化对冻土强度的影响，结果表明：易溶盐对盐渍土热特性有着重要影响，随含水率增大影响愈剧烈；冻结强度随着含水率的增大而增大，随冻结温度的降低而升高。

In addition, the test illuminate that when the gas pressure is augmenting, the droplet size minishes, where the spraying rate aggrandizes.

试验结果表明，喷雾量随气体压力的增大而增大，雾滴直径则随气体压力的增大而出现减小趋势。

It is shown that the M2 factor increases with increasing bandwidth and deceases with increasing spatial correlation degree.

研究结果表明，M2因子随脉冲光束带宽的增大而增大，随空间相关度的增大而减小。

Results The amplitude of rabbit stomach in front-back direction rapidly increases after 5 Hz and reaches the peak of 277.5% input at about 8Hz and then deceases gradually. The resonance frequency is 7-9Hz. and the amplitude of vibration is higher than 150% of input amplitude from 6Hz to 10Hz. The resonance frequency reduces and the maximum amplitude increases with the increase of stomach mass and volume.

结果 在2~50Hz频率范围内家兔胃在前后方向的振动在5Hz后振幅迅速增大，在8Hz左右达峰值，达到施加振幅的277.5%，之后又逐渐减小；共振频率为7~9Hz，在6~10Hz频率范围内胃的振幅都超过了施加振幅的150%；随着胃的质量、体积的增大，胃共振频率变低，但最大振幅增大。

Through numeric analysis, it is found that the degree of the manufacturer's misreporting will be enhanced along with the increase of the retailer's sensitivity, and with decrease of market demand uncertainty.

通过数值分析发现，制造商的最优谎报随市场需求不确定性的增大而降低；随零售商的订货量对制造商的批发价格敏感性系数的增大而增大。

Results show that adding obligating width of soil can reduce level distortion of diaphragm walls evidently, but the effect of reducing the level distortion of diaphragm walls will be unconspicuous when the obligating width of soil is increased to definite value.

计算结果表明，增大预留土体坡肩宽度对减小地下连续墙的水平变形有一定的效果，但是随着预留土体坡肩宽度增大到一定值时，再继续增大预留土体坡肩宽度对减小地下连续墙水平变形的效果就不明显。

It was discovered that reinforced embankments had overturn trends after watered and the trends aggravated when the geogrid space was reduced or the slope was steepened, while slope of the embankment without geogrid was failure in the same conditions.

获得了土工格栅加筋路堤横断面位移分布和路堤中土工格栅应变随时间变化的情况，发现在边坡坡脚浸水的情况下，加筋模型有绕边坡坡脚倾覆的趋势，倾覆趋势随加筋密度的增大和边坡坡度的增大而增大，而不加筋路堤边坡发生了滑塌，表明土工格栅的加入提高了路堤的整体性。

The mechanism of instability wrinkling in the process based on minimum energy principle is revealed, uniform mathematic description of the wrinkling wave on the strip of in-plane bending is established, the internal and external energy is deduced by energy method, and a uniform criteria of internal and external wrinkling is established; then how to combine the criteria with the FEM simulation system to make the numerical prediction of wrinkling into reality is also resolved in the paper. The effects of the forming parameters on the deforming result are analyzed by the uniform predict criteria. The results show as follows: as the compress width increase, external wrinkling first come into being, then internal winkling do, and finally in-plane bend occur; the loading wedge angle increase, internal winkling first come into being, thenin-plane bend do, and finally external wrinkling occur; in-plane bend is possible to occur with a increase of the strain-hardening exponent and the strength coefficient; and the effect of the friction factor may be ignored.

2揭示了板带不均匀压下面内弯曲成形过程基于能量原理的失稳起皱机理，提出了统一的描述内外缘起皱波形的函数，采用变分法推导了服从该波形函数的内外缘起皱能，建立了统一的起皱预测准则；将新建立的统一的起皱预测准则引入到数值模拟系统IBS中，数值预测结果与实验结果的吻合较好；分析了成形过程各参数对起皱的影响规律：随着接触变形区宽度的逐渐增大，先是发生外缘起皱，然后发生内缘起皱，进而才出现稳定成形；随着实际加载楔角的增大，先是发生内缘起皱，然后发生稳定成形，进而出现外缘起皱；硬化指数和强化系数增大，易于稳定成形；摩擦因子对起皱的影响不明显；而且接触变形区宽度对起皱的影响最大。

Neither the killing of Mr Zarqawi nor any breakthrough on the political front will stop the insurgency and the fratricidal murders in their tracks.

在对危险的南部地区访问时，他斥责什叶派民兵领导人对中央集权的挑衅行为。

In fact,I've got him on the satellite mobile right now.

实际上 我们已接通卫星可视电话了