增压

For Turbo charged and supercharged vehicles, it must be placed at the throttle body, after the turbo and intercooler.

为增压和增压车辆时，必须放置在节气门体后，涡轮增压和中间。

At the launch the model will be offered with a choice between a petrol engine (1.4 8v, 77 bhp) and a turbodiesel (1.3 Multijet 16v, 90 bhp with a variable geometry turbo), both combined with five-speed mechanical transmissions; the 120 bhp 1.4 16v Turbo from the new T-Jet family will be available at a later date.

在该模型将与汽油发动机之间（1.4 8V的选择，提供了发射77马力）和一个涡轮增压柴油发动机（1.3多点喷射16气门，90可变几何涡轮增压马力），同时结合五速机械传动； 120马力涡轮增压1.4升16v从全新的T -喷气系列将在日后公布。

This paper introduces two working principles for increasing pressure to solve the insufficient pressure in the fire tank .

介绍了解决消防水箱压力不足常用的2种增压设施的工作原理；通过实例计算，说明了2种增压设施的计算内容与计算方法，对2种增压方式的优缺点进行了比较；提出了设计中选用增压方式的原则

The research method is used, which combines the turbocharged engine dynamic performance simulation with the steady test. A quasi linear dynamic simulation model for turbocharged diesel engine is established. Neural network based emission model is established using the steady test data. A prediction simulation model of turbocharged engine dynamic emission is proposed based on MATLAB/SIMULINK.

采用了增压发动机动态性能模拟与稳态试验相结合的方法，建立了涡轮增压柴油机的准线性动态模型，利用稳态试验数据建立神经网络排放模型，提出了一种将2种模型结合起来在MATLAB/SIMULINK环境下的增压发动机动态排放预测仿真模型。

Bleed air is extracted from the high pressure compressor for the following system: Air-conditioning Cabin pressurizatin Wing and engine inlet cowl anti-icing Hydraulic tank pressurization Potable water tank pressurization Fan air is used as cooling air for the precooler to limit the temperature of the bleed air in the pneumatic manifold.

引气从高压压气机中释放给列镣系统：引气从高压压气机中释放给列镣系统：空调系统客舱增压系统 21 专业资料航空工程英语机翼及发动机入口整流罩防冰液压油箱增压饮用水箱增压风扇空气做为预冷器中的冷却空气用以限制增压总管中的引气温度。

Gas supercharging process by compressor plays an important role in low-pressure gas gathering and transportation.

压缩机增压工艺目前仍然是低压气集输工艺的主导工艺，而增压一般分为单井增压和集中增压两种方式。

Gas supercharging process by compressor plays an important role in lo-pressure gas gathering and transportation. There are mainly two supercharging ways, i.e. the single well supercharging and the central supercharging.

压缩机增压工艺目前仍然是低压气集输工艺的主导工艺，而增压一般分为单井增压和集中增压两种方式。

Through the flue gas and air characteristic analysis in supercharged boiler,the results showed that the value of parameters would increase with the increase of fuel consumption.And volume heat load of the furnace, fuel consumption, heat change between flue gas and convective heating surface and evaporation value would increase with the increase of compression ratio.The heat calculation would be different because of dissimilar thermal calculation in the turbo-compressor when the boiler load was changed.As the boiler load increased,heat loss in the turbo-compressor would increase and the efficiency of the boiler would decrease.The results of the boiler start-up simulation showed that the time of start-up would decrease with the increase of flue consumption ,but instantaneous pressure amplitude would increase.Steam water"s dymamic diversification would be more complex than flue gas"s,and dynamic characters of their parameters would be changed due to different boiler load and disturbance variable,which was shown by results of the simulation when boiler load was changed.

通过分析增压锅炉内的空气、烟气参数特性，发现随着锅炉负荷的增加，空气和烟气的各项参数值都相应的增加；炉膛容积热负荷、锅炉的燃料负荷随着增压比的提高成比例增加；随着增压比的增大，烟气与对流受热面的换热增加，蒸发量随之增加；由于涡轮增压机组在不同负荷下的热力计算不同而造成增压锅炉在不同负荷下的热平衡计算的不同；锅炉增压机组的总的热损失随着锅炉负荷的增加而增加，而增压锅炉的热效率随着锅炉负荷的增加而减少；锅炉启动模拟仿真结果中发现，锅炉启动时燃料量增加，锅炉的启动时间就会减少，但是瞬时升压速度会增加；而动态负荷变化模拟仿真结果中发现，锅炉汽水侧的变化相比烟气侧更为复杂，且在不同负荷和不同扰动量下，烟气侧和汽水侧的重要参数动态特性是不同的。

A regulation valve of a two-stage turbocharging system is arranged into the high pressure turbine volute to reduce the system sizes. Matching calculations for the turbocharging system and a diesel engine are made. Calculations in designing of two turbine volutes and regulating valve were taken. Experiments are conducted with the designed system.

为获得结构更为紧凑的二级增压系统，提出了将调节阀集成在高压级涡轮壳内部的二级增压系统结构方案，进行了增压系统与柴油机的匹配计算、两个涡轮壳的设计计算、调节阀计算以及流动分析，并对所设计的二级增压系统进行了试验研究。

Large air separation plant 40000m3/h, This plant adopts molecular sieve system to adsorb CO2, C2H2, moisture and CnHm in air to pre-purify air, by use of air booster compressor, to pressurize some of purified feed air by two sections, pressurized air to warm up high pressure liquid oxygen in high pressure coil heat exchanger to ambient temperature and delivere out off cold box to coal gasification, some pressurizrd air by first section is drawn from middle part of coil heat exchanger and expanded in medium pressure expander then led into lower column, other part of pressurized air by second section is drawn from cold end of coil heat exchanger and led into lower column after throttling, un-pressurized feed air is cooled by return gas in plate fin heat exchanger and led into lower column.

产品描述：采用常温分子筛空气预净化系统吸附空气中的CO2、C2H2、水份和一些碳氢化合物，使用单独的空气增压压缩机将部分净化后的原料空气分为两段增压，增压后的空气在高压绕管式换热器中将经液氧泵加压的高压液氧汽化并复热至常温送出冷箱直接供煤气化工序使用，第一段增压后的空气，部分从绕管式换热器中部抽出经电机制动的中压透平膨胀机膨胀后送入下塔，另一部分经第二段增压后从绕管换热器的冷端抽出节流后送入下塔，未经增压的原料空气在板翅式换热器中被低压返流气体冷却后进入下塔。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。