基本力

The basis of static, flat汇交system of forces, torque and couple Department of plane, plane general system of forces, center of gravity and centroid, the internal force and internal force diagram, tension and compression, torsion, bending, stress analysis and strength of the theory of the stability bar , the point of movement, the basic rigid-body movement, points of complex, rigid body planar motion, the movement of particle differential equations, dynamic general theorem, static and dynamic method.

静力学基础、平面汇交力系、力矩与平面力偶系、平面一般力系、重心和形心、内力和内力图、拉伸和压缩、扭转、弯曲、应力状态分析和强度理论、压杆的稳定性、点的运动、刚体的基本运动、点的复合运动、刚体的平面运动、质点的运动微分方程、动力学普遍定理、动静法。

In this thesis, the application of FEM in the special cars frames has been studiedIn the chapter 1 of this thesis, the basic principle of FEM is introduced, and the application of FEM in static and dynamic analysis of a car frame is discussed briefly, considering its structure and load properties.

本文结合工程实例，对特种车车架的有限元静力、动力分析作了一些探讨。本文第一章介绍了有限元法的基本思想，并结合汽车车架的具体结构和载荷特点，对利用有限元法进行静力、动力分析的有关问题进行了阐述。

Five versions of the vane cascade systems for the torque converter with the same basic geometric parameters were designed and the steady comparative experiments of these 5 versions versus the base version of W305 torque converter were performed.

在基本几何参数一致的基础上，设计了5种液力变矩器叶栅系统方案，并且对包括W305型液力变矩器比较基型在内的6种方案进行了稳态试验比较分析。

In part Ⅲ, effects of abnomal states in drilling process, such as drill wear, drill breakage, chips clogging etc, on feeding force and motor power will be studied in experimental way.

由此推导出了考虑刀具磨损的新的切削力理论公式，在此基楚上，提出了用静态、动态切削力信号监控刀具磨损的基本思想。

This paper is focused on the basic principle,forming method and the calculations of forming force and blank holder force for 630 kN multi point forming press.

重点介绍了 630kN 多点成形压力机的基本原理、成形方法、成形力及压边力的计算。

The results show that the friction between hoop cable and joint will cause tension redistribution in hoop and radial cable of structure,led to uneven force distribution of the same hoop cable,increase displacement of some joints and axial stress of some bars in the lattice shell, and static properties of the structure will be obviously affected,but the dynamic and stability characteristic almost will not.

计算结果表明，环索与节点间的摩擦会导致结构环索及斜索张力重分布，致使同圈索力分布不均匀，使部分网壳杆件轴向应力和节点位移增大，对结构的静力性能影响最大，而对动力和稳定性能基本没有影响。

In order to make up the deficiencies of the actual law, the supreme court promulgate a law named the rules about evidences in civil procedure which uses other countries'salutary experiences for reference and integrates the situationg of our country as well as the basic diathesis of the judges. It establish the principle of modern free evaluaion of evidence that rules the judges look through the evidences according to the legal procedures. Other than following occupational moralities, the judges should handle logistic illations and experiences of daily life to estimate probative power and evidential ability of evidences roundly and objectively.

为弥补现行立法上的漏洞与缺陷，在借鉴其他国家的有益经验的基础上，最高人民法院于2001年12月21日颁布的《关于民事诉讼证据的若干规定》从我国的现实国情出发并结合我国法官队伍的基本素质，在证据的审查判断上确立了现代自由心证原则，即审判人员应当依照法定程序，全面、客观地审核证据，依据法律的规定，遵循法官职业道德，运用逻辑推理和日常生活经验，对证据有无证明力和证明力大小独立进行判断，并公开判断的理由和结果。

The calculating results indicate that surrounding rock initial stress has an obvious influence on interior force of invert center, interior force increases with the vertical force increasing in both side of invert center, and decrease with horizontal force increasing in interior side , unchangeable in outer ...

计算结果表明，围岩初始应力场对仰拱受力有明显影响，随着竖向压力的增大，仰拱中心的内、外侧应力均增大；随着水平压力的增大，仰拱中心内侧应力减小、外侧应力基本不变；减小复合衬砌结构中初期支护厚度以及变刚性接头为柔性接头均会改善仰拱受力。

The possibility of translation equivalence is based on translatability, which is based on four factors: isomorphs of all human beings, the identity of humans thinking modes, the rough identity in grammatical elements and functions of all languages and the mutual infiltration of cultures.

作者详细对比分析了汉英两种语言在表达同一&言外之力&上的差异、间接言语行为话语和会话含义的理解与翻译，指出语用对等的基本原则是确保&言外之力&的等效。文章第六部分介绍翻译中的语用策略。

Base on the theory analysis, if the plate exit gauges are calculated by the same spring model, the influence of the model zero deviation on rolling force self-learn can be ignored.

分析弹跳方程零点漂移对轧制力模型自学习的影响，得知如果轧件出口厚度的计算全部采用弹跳方程计算值，则弹跳方程零点漂移对轧制力模型的自学习基本没有影响。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。